33.120.40 天线 标准查询与下载

DLA MIL-DTL-12995 D-2007 (W-120型电线)天线电线

This specification covers one type of stranded, round electrical wire fabricated from silicon bronze, suitable for antenna applications. The classification of wire covered by this specification is type W-120 (see 3.3.1).

WIRE, ELECTRICAL, ANTENNA (WIRE, W-120)

DLA MIL-DTL-5815 G-2007 超高频带飞机用天线的一般规范

This specification covers the general requirements for ultra high frequency (UHF) band airborne antenna.

ANTENNA, AIRBORNE, UHF - BAND, GENERAL SPECIFICATION FOR

DLA MIL-DTL-25895 A-2007 AT-505/AP型天线

This specification establishes the requirements for Antenna AT-505/AP which is a pressure-sealed single-slot flush-mounted broadband airborne antenna.

ANTENNA AT-505/AP

ANSI/TIA-222-G-1-2007 钢天线塔和天线支持结构补充件1结构标准

The objective of this Standard is to provide recognized literature for antenna supporting structures and antennas pertaining to: (a) minimum load requirements as derived from ASCE 7-02, 'Minimum Design Loads for Buildings and Other Structures', and (b) design criteria as derived from AISC-LRFD-99, 'Load and Resistance Factor Design Specification for Structural Steel Buildings' and ACI 318-02, 'Building Code Requirements for Structural Concrete'.

Structural Standards for Steel Antenna Towers and Antenna Supporting Structures Addendum 1

DIN EN 302085:2006 固定无线电系统.点对多点天线.在3～11GHz频带范围上运行的点对多点固定无线电系统用天线

This European standard specifies requirements in the telecommunications sector.

Fixed Radio Systems - Point-to-Multipoint Antennas - Antennas for point-to-multipoint fixed radio systems in the 3 GHz to 11 GHz band (Endorsement of the English version EN 302085 V1.2.3 (2005-09) as German standard)

DLA MIL-DTL-18793 A-2006 AS-333/AP型天线

This specification establishes the requirements for antenna type AS-333/AP which is a single slot, flush mounted, broadband airborne antenna for use over the frequency range of 420 MHz to 460 MHz.

ANTENNA AS-333/AP

BS DD IEC/PAS 62437:2006 道上车辆、船舶和设备上用接收机保护的无线电干扰特性.限值和测量方法.有源天线规范

Active antennas used on board vehicles are electronic components in the sense of CISPR 25. Therefore, the requirements regarding emissions apply to it in its function as EUT. In addition to this, vehicle active antennas are used as part of the measurement chain for the evaluation of emissions produced by any other component in the vehicle. With a passive antenna no special considerations were necessary because it can neither generate emissions nor harmonics due to its linearity. This Publicly Available Specification (PAS) gives additional information for the use of active antennas for radiated emission measurement according to CISPR 25. Test set-ups at component level are defined for the determination of noise floor. The current vehicle antenna technology provides two categories of active antennas. The first category (I) consists of an active part (electronic part) and a passive part (antenna structure). These parts can be considered as two separate "black boxes". During the emission tests (antenna as EUT), the passive antenna part is normally replaced by an "artificial antenna network". Antennas with their active and passive parts inseparably combined within one housing are defined as category (II) antennas.

Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices - Limits and methods of measurement - Specifications for active antennas

SJ/T 11322-2006 反射面天线及伺服传动系统机械性能测试方法

本标准规定了反射面天线（以下简称“天线”）及伺服传动系统机械性能测量方法，用于样板曲线、曲面、伺服系统传动精度及回程误差、精密数据传递机构的精度测量。

Measurement method for reflector antenna and servo gear system mechnical performance

SANS 1611:2005 卫星电视接收天线的结构参数

Specifies requirements for antennas designed to be used out of doors for the reception of satellite television transmissions, in the frequency range 8,0 GHz to 14,0 GHz. It is not applicable to portable antennas.

The mechanical requirements for satellite television receiving antennas

DLA MIL-DTL-55288 D-2005 AS-1729/VRC直流天线

This specification covers one type of center-fed whip antenna intended for use in a vehicular communications system operating over the frequency range of 30.00 to 76.00 MHz and designated as Antenna AS-1729/VRC (see 6.1 and 6.6).

DC ANTENNA AS-1729/VRC

DLA MS25048 REV B-2005 终端天线桅杆

The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.

MAST, ANTENNA, DEAD-END

VDA 240-200-2005 车辆天线规范-功能要求、测量方法

Spezifikation für Fahrzeug-Antennen - Funktionsanforderungen,Messmethoden

ANSI/TIA-222-G-2005 天线支撑结构物和天线的结构标准

The objective of this Standard is to provide recognized literature for antenna supporting structures and antennas pertaining to: (a) minimum load requirements as derived from ASCE 7-02, &8220;Minimum Design Loads for Buildings and Other Structures&8221;, and (b) design criteria as derived from AISC-LRFD-99, &8220;Load and Resistance Factor Design Specification for Structural Steel Buildings&8221; and ACI 318-02, &8220;Building Code Requirements for Structural Concrete&8221.

Structural Standard for Antenna Support Structures and Antennas

YD/T 1059-2004 移动通信系统基站天线技术条件

本标准规定了移动通信系统基站天线的术语定义、分类、电性能、机械特性、环境条件、测量方法、检验规则以及标志、包装、运输和贮存。 本标准适用于工作频段为825MHz~960MHz、1710MHz~1990MHz、1920MHz~2170MHz 移动通信系统基站天线。同类型其他频段、规格的天线也可参照使用。

Mobile communication system base station antennas

SANS 1252:2004 VHF和UHF频段电视和VHF频段音频传输接收用无源天线

Specifies the characteristics of passive antennas designed to be used out of doors for the reception of VHF and UHF television and VHF sound transmissions. It does not cover self-contained, "set top" or portable antennas.

Passive antennas for the reception of VHF and UHF television and VHF sound transmissions

DIN EN 301215-4:2004 固定无线电系统.点对多点天线.频带范围11GHz至60GHz的多点固定无线电系统用天线.第4部分:频带范围30GHz 到 40.5 GHz

This European standard specifies requirements in the telecommunications sector.

Fixed Radio Systems - Point-to-Multipoint Antennas - Antennas for multipoint fixed radio systems in the 11 GHz to 60 GHz band - Part 4: 30 GHz to 40,5 GHz (Endorsement of the English version EN 301215-4 V1.1.1 (2003-12) as German standard)

DLA MS25051 VALID NOTICE 3-2004 天线终端插入

MS25051 remains inactive for new design, however, the document is valid for use

INSERT, DEAD-END, ANTENNA

DLA MS25049 REV A VALID NOTICE 2-2004 引入天线桅杆

MS25049A remains inactive for new design, however, the document is valid for use.

MAST, ANTENNA, LEAD THROUGH

DLA MS25061 REV A VALID NOTICE 3-2004 内部天线支撑套筒

MS25061A remains inactive for new design, however, the document is valid for use.

SLEEVE, SUPPORT, ANTENNA, INTERNAL THREAD

SANS 10061-1:2004 用于接收电视和广播传送的公用单天线系统的安装．第1部分：VHF和UHF电视和VHF声音天线系统

This part of SANS 10061 establishes principles for the installation, modification and maintenance of communal and single antenna systems (i.e. antennas and associated equipment other than HF wired distribution systems) for the reception of VHF and UHF television and VHF sound transmissions. It includes the protection of such systems against atmospheric electrical disturbances. 2 Compliance with the provisions in this part of SANS 10061 does not confer immunity from relevant legal requirements, including the regulations issued by Telkom, and, when conflict with these regulations is likely, Telkom should be consulted before any installation design is brought to finality. In particular, the attention of users of this part of SANS 10061 is drawn to the regulations regarding communication connections between premises. 3 SANS 10142-1 covers the wiring of premises.

The installation of communal and single antenna systems for the reception of television and sound broadcast transmissions Part 1: VHF and UHF television and VHF sound antenna systems