43.080.10 卡车和挂车 标准查询与下载



共找到 265 条与 卡车和挂车 相关的标准,共 18

本标准规定了50号牵引座和90号牵引座的强度要求与试验方法。 本标准适用于50号牵引座和90号牵引座。

Road vehicle.Fifth wheel couplings tests

ICS
43.080.10
CCS
T72
发布
2006-01-10
实施
2006-06-01

本标准规定了牵引车与相连接半挂车之间机械连接的互换性尺寸。 本标准适用于安装符合GB/T 4606规定的50号牵引销的半挂汽车系列,并允许二轴或三轴牵引车使用相同的半挂车。本标准不适用于低平板式或倾卸式等专用半挂车。

Road vehicles.Mechanical coupling between tractors and semi-trailers.Interchangeability

ICS
43.080.10
CCS
T72
发布
2006-01-10
实施
2006-06-01

本标准规定了液化气体运输车的设计、制造、试验方法、检验规则和标志等要求。 本标准适用于设计压力大于等于0.1MPa,设计温度不低于-50℃的钢制罐体,且由定型底盘或半挂行走机构改装的液化气体运输车。 本标准不适用于下列液化气体运输车的设计和制造: ——罐体为有色金属材料或非金属材料的; ——罐体为真空绝热结构的; ——有特殊要求国防军事装备的。 对不能采用本标准进行设计的液化气体运输车罐体,允许采用以下方法设计,但需经全国锅炉压力容器标准化技术委员会评定、认可: ——包括有限元法在内的应力分析; ——验证性试验分析(如实验应力分析、验证性液压试验); ——用可比的已投入使用的结构进行对比经验设计。

Liquefied gas tanker

ICS
43.080.10
CCS
T59
发布
2005-09-14
实施
2006-04-01

本标准规定了货运挂车产品质量检查的试验规程,它包含了:货运挂车定型试验的实施条件、试验程序、试验内容及方法,试验报告的编写内容,货运挂车产品质量生产一致性检查的抽样规则、判定原则、试验内容及方法。 本标准适用于在公路和城市道路上行驶的货运挂车的定型试验和产品质量生产一致性检查试验。

Test-rules of products quality inspection for trailers

ICS
43.080.10
CCS
T71
发布
2002-08-29
实施
2003-01-01

本标准规定了货运全挂车的技术要求、检验规则及试验方法。 本标准适用于在公路及城市道路上行驶的货运全挂车。

Technical requirements for freight full trailers

ICS
43.080.10
CCS
T71
发布
1998-03-20
实施
1998-10-01

本标准规定了牵引车与挂车之间气制动管连接器的互换性尺寸、安装及标志。 本标准适用于汽车列车装备双管路气压制动系用气制动管连接器。其中一条为供能管路、另一条为控制管路。其他车辆列车亦可参照执行。

Pneumatic braking connections between motor vehicles and towed vehicles

ICS
43.080.10
CCS
T74
发布
1992-11-14
实施
1993-07-15

本标准规定了牵引座在半挂牵引车上的安装尺寸和要求。 本标准适用于公路运输用半挂牵引车上装置的与半挂车50号牵引销或90号牵引销相应的牵引座。其他车辆列车用牵引座可参照执行。

Road vehicles.Semi trailer fifth wheel mounting

ICS
43.080.10
CCS
T72
发布
1992-11-14
实施
1993-07-15

本文件规定了柴油发动机建筑废土运输车辆的术语和定义、结构和规格、要求、试验方法、车辆检验等

Technical specifications for Construction waste soil transportation vehicles Part 1:dieselvehicle

ICS
43.080.10
CCS
C361
发布
2024-05-01
实施
2024-05-15

Draft BS EN 12252:2022/A1 LPG equipment and accessories - Equipping of LPG road tankers

ICS
43.080.10
CCS
发布
2024-04-30
实施
2024-04-30

本文件规定了皮卡车盖(以下简称“车盖”)的术语和定义、型号及基本参数、技术要求、试验方法、检验规则、使用说明与标志、包装、运输和贮存。

Tonneau cover

ICS
43.080.10
CCS
C3670
发布
2023-12-13
实施
2023-12-13

4 要求 4.1 一般要求 4.1.1 牵引车外廓尺寸、轴荷、最大总质量应符合GB 1589的规定。 4.1.2 牵引车车辆识别代码应符合GB 16735的规定。 4.1.3 牵引车在运行过程中不得有漏液、漏水现象。 4.1.4 牵引车整车铭牌应符合GB/T 18411的规定。 4.1.5 牵引车号牌板及位置应符合GB 15741的规定。 4.1.6 牵引车运行安全应符合GB 7258的规定。 4.1.7 牵引车与挂车之间的机械连接装置应符合 QC/T 446、GB/T 13880 和 GB/T 20070 的规 定;电连接装置应符合 GB/T 20716.1 的规定;气制动管连接器应符合 GB/T 13881 的规定。 4.2 性能要求 4.3 安全要求 4.4 环保要求 牵引车的排气污染物排放及噪声应符合GB 17691及GB 1495的规定

6×4 natural gas semi-trailer tractor

ICS
43.080.10
CCS
C361
发布
2023-10-26
实施
2023-10-26

1   Scope This document specifies filling, discharge and emergency procedures for road tankers equipped in accordance with EN 12252 used for the transport of liquefied petroleum gas (LPG). This document does not apply to “batteries of receptacles”.

LPG equipment and accessories. Filling and discharge procedures for LPG road tankers

ICS
43.080.10
CCS
发布
2023-06-30
实施
2023-06-30

Technical Specifications for the Management of Domestic Waste Transport Vehicles

ICS
43.080.10
CCS
T 51
发布
2023-06-10
实施
2023-07-10

本文件规定了轻型货车质量及企业标准水平评价的基本要求、评价指标及要求、评价方法及等级划分。 本文件适用于以汽油或柴油为单一燃料的轻型货车质量和企业标准水平评价。相关机构开展质量分级和企业标准水平评估、“领跑者”评价以及相关认证时可参照使用,企业标准可参照执行。

Quality Grading and “Top Runner” Evaluation Requirements for Light Trucks

ICS
43.080.10
CCS
G544
发布
2023-05-19
实施
2023-05-20

本文件规定了半挂车产品质量及企业标准水平的基本要求、评价指标及要求、评价方法及等级划分。 本文件适用于载货半挂车质量和企业标准水平评价。相关机构开展质量分级和企业标准水平评估、“领跑者”评价以及相关认证时可参照使用,企业标准可参照执行。

Quality classification and "Leader" evaluation requirements for semi-trailers

ICS
43.080.10
CCS
G544
发布
2023-05-19
实施
2023-05-20

This European Standard specifies filling, discharge and emergency procedures for road tankers equipped in accordance with EN 12252 used for the transportation of liquefied petroleum gas (LPG). This European Standard does not apply to "batteries of receptacles".

LPG equipment and accessories - Filling and discharge procedures for LPG road tankers

ICS
43.080.10
CCS
发布
2023-05-03
实施

This document specifies minimum requirements for the inspection and testing of the LPG road tanker, which includes its pressure vessel, accessories and vehicle LPG equipment. This document does not specify requirements for the initial inspection (after manufacture) of a pressure vessel, see EN 12493, or for service equipment on the road tanker, see EN 12252. This document does not apply to compartmented road tankers. NOTE 1 There is no upper size limit for the pressure vessel as this will be determined by the gross vehicle weight limitation. NOTE 2 For inspection and testing requirements of equipment other than the pressure vessel, accessories and vehicle LPG equipment, see applicable regulations.

LPG equipment and accessories - Inspection and testing of LPG road tankers

ICS
43.080.10
CCS
发布
2023-05-03
实施

This document specifies equipment and accessories for road tankers used for the transport of Liquefied Petroleum Gas (LPG) and identifies the equipment that is considered necessary to ensure that filling, transportation and discharge operations can be carried out safely. It specifies the requirements for the assembly of the accessories and the vehicle LPG equipment to the road tanker. This document also identifies additional equipment and accessories that can be used on road tankers carrying LPG. This document does not preclude the use of alternative designs, materials and equipment testing which provide the same or a higher level of safety. ADR [9] requires that such alternative technical codes be recognized by the competent authority, provided that the minimum requirements of section 6.8.2 of ADR [9] are complied with. This document does not apply to “tank-containers” or “battery-vehicles” used for the transport of LPG.

LPG equipment and accessories - Equipping of LPG road tankers

ICS
43.080.10
CCS
发布
2023-05-03
实施

Rules for Periodic Inspection of In-service Metal Atmospheric Tanks for Tank Vehicles Transporting Liquid Dangerous Goods by Road

ICS
43.080.10
CCS
T 59
发布
2022-12-27
实施
2023-01-27

5 检验前准备  5.1 委托单位检验前准备  5.2 检验单位检验前准备  5.3 检验环境和安全防护检查  5.4 检验内容  6 检验项目、方法和要求  6.1 罐体资料审查  6.2 结构及几何尺寸检验  6.3 罐体外观检验  6.4 附件检查  6.5 罐体壁厚测定  6.6 罐体试验(必要时)  6.7 罐体与底盘(或者行走机构)连接检查 

Road tanker for dangerous liquid goods transportation specification for Regular checking of atmospheric pressure metal tank

ICS
43.080.10
CCS
M745
发布
2022-09-29
实施
2022-09-29



Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号