43.180 检查、维修和试验设备 标准查询与下载

T/NVSEA 2-2022 机动车检验机构分级管理与评价

文件规定了机动车检验机构分级管理与评价的基本要求、评价原则及评价内容等

Classified management and evaluation of motor vehicle inspection agencies

T/NVSEA 1-2022 机动车检验机构管理规范

文件给出了机动车检验机构管理的术语和定义，规定了机动车检验机构的基本要求、制度与管理体系建设、检测设备及检测场地设施要求、人员要求、评价与改进等内容

Management Regulations for Motor Vehicle Inspection Institutions

T/HEBQIA 078-2022 氢氧汽车积碳清洗机

本文件规定了氢氧汽车积碳清洗机的术语和定义、要求、试验方法、检验规则、标志、使用说明书、包装、运输、贮存。

Hydrogen and oxygen car carbon cleaning machine

BS ISO 14229-5:2022 公路车辆 统一诊断服务（UDS） 互联网协议实施的统一诊断服务(UDsonIP)

1   Scope This document specifies an application profile for the implementation of unified diagnostic services (UDS) Internet Protocol (IP) in road vehicles (UDSonIP). UDSonIP references ISO 14229‑1 and ISO 14229‑2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Internet Protocol. This document includes — additional requirements specific to the implementation of UDS on the Ethernet network, and — specific restrictions in the implementation of UDS on the Ethernet network.

Road vehicles. Unified diagnostic services (UDS). Unified diagnostic services on Internet Protocol implementation (UDSonIP)

GSO ISO 3888-1:2022 乘用车 严格变道操作的测试跑道 第1部分：双变道

This document specifies the dimensions of the test track for a closed-loop test method to subjectively determine a double lane-change which is one part of the vehicle dynamics and road-holding ability of passenger cars. It is applicable to passenger cars as defined in ISO 3833. It is also applicable to light commercial vehicles up to a gross vehicle mass of 3,5 t.

Passenger cars — Test track for a severe lane-change manoeuvre — Part 1: Double lane-change

BS ISO 14229-3:2022 公路车辆 统一诊断服务（UDS）CAN 实施上的统一诊断服务（UDSonCAN）

What is ISO 14229-3 - UDS on CAN implementation in road vehicles about? Diagnostic systems are developed so that the product development teams, software/hardware testing teams, and after-sales teams can detect faults in a vehicle by connecting their diagnostic tester tools to the electronic control units (ECUs) in the vehicle. ISO 14229 discusses road vehicles and unified diagnostic services (UDS) with a focus on unified diagnostic services on CAN implementation. ISO 14229-3 is the third part of the ISO 14229 multi-series on road vehicles and unified diagnostic services that specifies: Additional requirements specific to the implementation of UDS on the CAN network, and Specific restrictions in the implementation of UDS on the CAN network. UDSonCAN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on CAN. Who is ISO 14229-3 - UDS on CAN implementation in road vehicles for ? ISO 14229-3 on UDS on CAN implementation in road vehicles is useful for: Road vehicle engineers Manufacturers of road vehicl...

Road vehicles. Unified diagnostic services (UDS) - Unified diagnostic services on CAN implementation (UDSonCAN)

ISO 14229-7:2022 道路车辆.统一诊断服务（UDS）.第7部分:本地互联网络（UDSonLIN）上的UDS

This document specifies an application profile for the implementation of unified diagnostic services (UDS) local interconnect network (LIN) in road vehicles (UDSonLIN). UDSonLIN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Local Interconnect Network. This document includes: — additional requirements specific to the implementation of UDS on local interconnect network; and — specific restrictions in the implementation of UDS on local interconnect network.

Road vehicles — Unified diagnostic services (UDS) — Part 7: UDS on local interconnect network (UDSonLIN)

ISO 14229-5:2022 道路车辆.统一诊断服务（UDS）.第5部分:互联网协议实施上的统一诊断服务（UDSonIP）

This document specifies an application profile for the implementation of unified diagnostic services (UDS) Internet Protocol (IP) in road vehicles (UDSonIP). UDSonIP references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on Internet Protocol. This document includes — additional requirements specific to the implementation of UDS on the Ethernet network, and — specific restrictions in the implementation of UDS on the Ethernet network.

Road vehicles — Unified diagnostic services (UDS) — Part 5: Unified diagnostic services on Internet Protocol implementation (UDSonIP)

BS ISO 20080:2019+A1:2021 公路车辆 远程诊断支持信息 一般要求、定义和用例

1   Scope This document specifies general requirements and constraints applicable to a remote diagnostic process , the use cases and scenarios to support the implementation of a remote diagnostic process using a standardized interface of the ExVe. It concerns: — the road vehicles with four or more wheels designed and constructed primarily for the carriage of persons that are defined as Category 1 vehicles in the United Nations Special Resolution No.1 in TRANS/WP.29/1045, as last amended on 19 June 2012, and — the road vehicle with four or more wheels designed and constructed primarily for the carriage of goods that are defined as Category 2 vehicles in the United Nations Special Resolution No.1 in TRANS/WP.29/1045, as last amended on 19 June 2012, where these road vehicles are still in accordance with the specifications of the vehicle manufacturer . This document does not define the interfaces provided by the ExVe nor the internal implementation inside the ExVe. Processes like repair, prognostics , monitoring, configuration, re-programming and variant coding are not part of this document. The prerequisites (e.g. authentication and authorization) for all use cases are not covered within this document. A possible specification of the required content for the implementati...

Road vehicles. Information for remote diagnostic support. General requirements, definitions and use cases

T/ZZB 2642-2022 液压式汽车举升机

本文件规定了液压式汽车举升机的术语和定义、分类及型号、基本要求、技术要求、试验方法、检验规则、标志、包装、运输和储存以及质量承诺。 本文件适用于额定举升质量不大于20 000 kg的液压式汽车举升机（以下简称举升机）。

Hydraulic automotive lift

ISO 14229-3:2022 道路车辆.统一诊断服务（UDS）.第3部分:CAN实施上的统一诊断服务（UDSonCAN）

This document specifies an application profile for the implementation of unified diagnostic services (UDS) on controller area network (CAN) in road vehicles. UDSonCAN references ISO 14229-1 and ISO 14229-2 and specifies implementation requirements of the diagnostic services to be used for diagnostic communication on CAN. This document specifies — additional requirements specific to the implementation of UDS on the CAN network, and; — specific restrictions in the implementation of UDS on the CAN network.

Road vehicles — Unified diagnostic services (UDS) — Part 3: Unified diagnostic services on CAN implementation (UDSonCAN)

T/GDCKCJH 060-2022 汽车域控制器(DCU)自动化测试线检测方法

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)的术语和定义、缩略语和检测方法。

Testing method for automatic testing line of vehicle domain control unit

T/GDCKCJH 059-2022 汽车域控制器(DCU)自动化测试线接口规范

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)接口的术语和定义、缩略语、要求。

Technical interface specifications for automatic testing line of vehicle domain control unit

T/GDCKCJH 058-2022 汽车域控制器(DCU)自动化测试线通用要求

本文件规定了汽车域控制器(DCU)自动化测试线(以下简称“测试线”)的术语和定义、缩略语、构成与分类、要求。

General requirements for automatic testing line of vehicle domain control unit

BS ISO 14229-2:2021 公路车辆 统一诊断服务（UDS） 会话层服务

What is ISO 14229-2 about?   ISO 14229-2 is the second part of multiple series that specifies common session layer services and requirements to provide independence between unified diagnostic services ( ISO 14229-1 ) and all transport protocols and network layer services (e.g., ISO 13400-2 DoIP, ISO 15765-2 DoCAN, ISO 10681-2 communication on FlexRay, ISO 14230- 2 DoK-Line, and ISO 20794-3 CXPI).

Road vehicles. Unified diagnostic services (UDS). Session layer services

ISO/TR 19222:2021 道路车辆.雷神假人的伤害风险曲线

Road vehicles — Injury risk curves for the THOR dummy

DIN EN 17281:2021 安全要求 车辆清洁设备；德文版 EN 17281:2021

This standard contains technical safety requirements for the design, equipment and testing of brushless vehicle washing systems and vehicle washing systems with brushes for, indoor and outdoor operation e. g. roll-over vehicle washing systems, vehicle washing tunnels, manually mo

Safety requirements - Vehicle cleaning equipment; German version EN 17281:2021

BS EN 17003:2021 公路车辆 适用于总重超过 3.5 吨的车辆的滚轮制动测试仪 安全要求

What is BS EN 17003 about?    A road vehicle's ability to brake effectively and efficiently is critical to the safe operation of the vehicle on roads. A roller brake tester is a method of allowing the assessment of the braking system of a vehicle, whilst the vehicle itself is in a static condition. They play a vital role in testing the brake functionality of vehicles and so need to be safe for use themselves.  BS EN 17003  specifies safety requirements for roller brake testers for road vehicles of more than 3,4 tons GVW.  T his safety standard applies to roller brake testers (brake test benches) that are designed for roadworthiness tests on categories M2, M3, N2, N3, O3, and O4 vehicles (as defined in Regulation (EU) 2018/858) and that might be also used to test M1, N1 categories.   Notes-  BS EN 17003 doesn’t cover mobile roller or plate brake testers.  BS EN 17003  covers fixed-bed roller brake testers with or without inspection pits and whose chassis are inside or outside the building.

Road vehicles. Roller brake testers for vehicles of more than 3,5 tons GVW. Safety requirements

ISO 20080:2019/Amd 1:2021 道路车辆.远程诊断支持信息.一般要求 定义和用例.修改件1

Road vehicles — Information for remote diagnostic support — General requirements, definitions and use cases — Amendment 1

EN 17003:2021 道路车辆 GVW 超过 3.5 吨的车辆的辊式制动器测试仪 安全要求

This document applies to roller brake testers (brake test benches) that are designed for roadworthiness tests on categories M2, M3, N2, N3, O3 and O4 vehicles (as defined in Regulation (EU) 2018/858) and that might be also used to test M1, N1 categories. This document covers fixed-bed roller brake testers with or without inspection pits and whose chassis are inside or outside the building. This document does not cover mobile roller or plate brake testers. These roller brake testers are used to take measurements for testing and assessing the efficiencies of the brake systems fitted to vehicles in the above-cited vehicle categories. The users of the roller brake tester are all kinds of staff that for any reason operate the roller brake testers (e.g. staff working in public transport, vehicle rental, vehicle maintenance, vehicle repair, training, test laboratories and vehicle inspection sectors ...). This document is not applicable to roller brake testers manufactured before the date of its publication.

Road vehicles - Roller brake testers for vehicles of more than 3,5 tons GVW - Safety requirements