共找到 1885 条与 航空航天制造用材料 相关的标准,共 126 页
This handbook provides guidance for the ASE(Aircraft Survivability Equipment) data submittals, which will be completed prior to issue of a Safety of Flight(SOF) Release for testing of new/modified ASE equipment installed on U.S. Army aircraft. A combination of analyses, component testing, and ground testing will be used to issue the first release to test the system, which should be stipulated in each contract. The ADS-66 handbook would assist the contractor in determining the exact data/reports needed to assure airworthiness of the system.
GUIDANCE FOR DATA FOR SAFETY OF FLIGHT AIRWORTHINESS RELEASE FOR HELICOPTER AIRCRAFT SURVIVABILITY EQUIPMENT (ASE)
The margins of this amendment are marked with asterisks to indicate where changes from the previous amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bi
GUN, AUTOMATIC, 20MM, GENERAL SPECIFICATION FOR
This drawing describes the requirements for IR secure indicator assemblies with panel sealing and panel and rear sealing with filtered type lens designed for sunlight viewing, with tireflection coated lens and available with electrostatic screen.
INDICATOR ASSEMBLIES: IR SECURE LIGHTING; RED, YELLOW, GREEN; PANEL SEALING
This amendment forms a part of MIL-M-45151C(AR), dated 2 December 1974, and is approved for use by the U.S. Army Armament, Research, Development and Engineering Center, and is available for use by all Departments and Agencies of the Department of Defense.
MOUNT, TRIPOD, MACHINE GUN, CALIBER .50: M3 [Use In Lieu Of: ARMY MIL-M-0045151 B]
This amendment forms a part of MIL-G-71047(AR), dated 13 April 1993, and is approved for use by the U.S. Army Armament, Research, Development and Engineering Center, and is available for use by all Departments and Agencies of the Department of Defense.
MACHINE, GUN, CALIBER .50, AIRCRAFT, XM296
MIL-C-16310D, dated 20 March 1991, is hereby reinstated and may be used for acquisition.
CYLINDER COMPRESSED GAS (COMPRESSED AIR AND CARBON DIOXIDE, NONSHATTERABLE AND NONMAGNETIC)
The voltage drop within the flasher shall not exceed 5.0 percent of the input voltage for any value of load within the limits specified in MIL-F-26301.
FLASHER, SOLID STATE, AIRCRAFT LIGHT
A-A-59107, dated 9 September 1997, has been reviewed and determined to be valid for use in acquisition
TOLUENE, TECHNICAL
A-A-55805, dated 31 May 1996, has been reviewed and determined to be valid for use in acquisition
SHEARING MACHINES, METAL SQUARING, HYDRAULIC DRIVE
A-A-59256, dated 11 May 1998, has been reviewed and determined to be valid for use in acquisition
DINITROTOLUENE, (FOR USE IN EXPLOSIVES)
This standard is approved for use by all Departments and Agencies of the Department of Defense.
GLOSSARY OF DEFINITIONS, GROUND RULES, AND MISSION PROFILES TO DEFINE AIR VEHICLE PERFORMANCE CAPABILITY [Superseded: AIR FORCE MIL-C-5011 A CANC NOTICE 1, AIR FORCE MIL-C-005011 B CANC NOTICE 1, AIR FORCE MIL-C-005011 B, AIR FORCE MIL-C-5011 A, AIR
This specification covers the magnetic effect limits and testing methods for nonmagnetic equipment used in the proximity of magnetic influence ordnance. This specification covers finished equipment (final assemblies). Testing (Pre-screening) of sub-assemblies, components and raw materials will not guarantee acceptability of the final assemblies.
MAGNETIC EFFECT LIMITS FOR NONMAGNETIC EQUIPMENT USED IN THE PROXIMITY OF MAGNETIC INFLUENCE ORDNANCE
This amendment forms a part of MIL-G-70790(AR), dated 7 June 1995, and is approved for use by the U.S. Army Armament Research, Development, and Engineering Center, and is available for use by all Departments and Agencies of the Department of Defense.
GUN, MACHINE, 40MM MK19 MOD 3
This list has been prepared for use by or for the Government in the procurement of products covered by the subject specification and such listing of a product is not intended to and does not connote indorsements of the product by the Department of Defense.
PRIMER COATING, EPOXY, WATER REDUCIBLE, LEAD AND CHROMATE FREE
This CID covers dehydrated pelletized potato-based mix, for use with extruder equipment with an internal rehydrating device, packed in commercially acceptable containers,suitable for use by Federal, State, local governments and other interested parties.
POTATO-BASED MIX, PELLETIZED, DEHYDRATED (FOR FRENCH-FRIED TYPE PRODUCTS)
This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense.
CLEANING COMPOUND, AIRCRAFT SURFACE
MIL-W-2902D remains inactive for new design, however, the document is valid for use.
WIRE ROPE ASSEMBLIES, SINGLE LEG, OXYGEN BREATHING APPARATUS SAFETY LINE
MS35794A remains inactive for new design, however, the document is valid for use
BEARING, SLEEVE, STEEL-BACKED BIMETAL, SPLIT TYPE, ONE PIECE
MS21783 remains inactive for new design, however, the document is valid for use.
BEARING, WASHER, THRUST, SINTERED BRONZE, OIL IMPREGNATED
MIL-B-5687D, dated 21 February 1984, is hereby reinstated as inactive for new design.
BEARINGS, SLEEVE, WASHERS, THRUST, SINTERED, METAL POWDER, OIL-IMPREGNATED, GENERAL SPECIFICATION FOR
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号