共找到 486 条与 垫圈和其他锁紧元件 相关的标准,共 33 页
This standard establishes a recommended minimum test sequence and test procedures for electrical connectors and sockets.
Electrical Connector/Socket Test Procedures Including Environment Classifications Errata: 10/23/2006
These washers are designed primarily for usae under bolt heads.
Aerospace series - Washers, countersunk
Aerospace series - Washers, flat, in steel, cadmium plated
This standard applies to connectors and sockets that are mounted to printed wiring boards (PWB) employing through mount technology.
TP-71b Solder Wicking (Wave Solder Technique) Test Procedure for Electrical Connectors and Sockets Revision of EIA-364-71A; Errata July 13, 2001
The document specifies the rules of use and installation for spring clips, for aerospace applications.#,,#
Aerospace series - Clips, spring tension - Design recommandations (AECMA Technical Report TR 4586:2000)
Aerospace series - Clips, spring tension - Assembly recommandations (AECMA Technical Report TR 4587:2000)
This standard was developed under the auspices of the Consumer Electronics Association (CEA) Technology & Standards R4.8 DTV Interface Subcommittee.
High Definition TV Analog Component Video Interface
This standard was developed under the auspices of the Consumer Electronics Association (CEA) Technology & Standards R4.8 DTV Interface Subcommittee.Other scanning structures for analog component interfaces are set forth in separate standards, identified by EIAíCEA-770.X notation.
Standard Definition TV Analog Component Video Interface Errata: 11/23/2004
This standard specifies the characteristics for washers, bulkhead, in titanium alloy, for aerospace applications.
Aerospace series - Washers, bulkhead in titanium alloy
Rubber gasket for clamping clamp
This standard establishes a test method to determine the connector's resistance to burning when exposed to a flame. Burning resistance is defined as the ability to not support or propagate combustion after an ignition source is removed.
TP-104A Flammability Test Procedure for Electrical Connectors
Clamp, Loop, Plain, Support, Aircraft FSC 5340TABLE 1 - DIMENSIONSTABLE 2 - DIMENSIONS AND SIZE CODE
Clamp, Loop, Plain, Support, Aircraft
Washer, Key - Single, Bearing Retaining, AMS 8350 (ASG) FSC 5310;
Washer, Key - Single, Bearing Retaining, AMS 8350 (ASG) FSC 5310
Washer, Key - Single, AMS 6350 (ASG) FSC 5310
Washer, Key - Single, AMS 6350 (ASG) FSC 5310
Washer, key-single, bearing retaining, AMS 8350 (ASG)
Washer, key-single, AMS 6350 (ASG)
This standard applies to a family of connectors having the following characteristics: shielded68 position trapezoidal-shaped mating interface,0.8 mm pitch spacing of contacts on a double row,for board-to-board and wire to board applications.
Detail Specification for Trapezoidal Shielded Connector 0.8 mm Pitch Used with Very High Density Cable Interconnect (VHDCI)
This specification covers interconnect systems typically used for production land grid array(LGA) devices.
Detail Specification for Production Land Grid Array (LGA) Socket for Use in Electronic Equipment
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号