共找到 486 条与 垫圈和其他锁紧元件 相关的标准,共 33 页
CEA-109-D specifies Intermediate Frequencies (IFs) to be used in Standard Broadcast (AM), FM, and TV broadcast receivers.In CEA-109-D, the term Intermediate Frequency (IF) refers to the dominant interference-rejecting and passband-shaping circuits in receiver front-ends.
Intermediate Frequencies for Entertainment Receivers
This standard specifies the characteristics, qualification and acceptance requirements for spring tension clips for the support of electrical harnesses, in alloy steel for aerospace applications. It is applicable whenever referenced.
Aerospace series - Clips, spring tension - Technical specification
Aerospace series - Clips, spring tension - Technical specification
Aerospace series - Clips, spring tension, in alloy steel FE-PA3903
This standard specifically designates 6 MHz channel frequency allocations for 158 channels up to 1002 MHz, with a method of specifying higher channels. This standard is not intended to preclude channel mapping in cable systems. (To provide compatibility, cable systems will follow the frequency allocations designated in this channel identification plan and will seek to ensure that all channel information that is supplied by the cable system properly identifies channels by numbers as well as by signal carried. The cable operator will provide information for printed and on-screen program guides, so that subscribers can directly reference programs with the channel identification plan used on cable ready receivers.)
Cable Television Channel Identification Plan [Replaced: CEA IS-6, CEA IS-6]
This standard establishes test methods to determine the ability of the contact retention system in an electrical connector with removable contacts to withstand a static mechanical load at elevated temp erature.
TP-58-A Temperature Life with Mechanical Loading for Connectors with Removable Contacts (Static Mechanical Load at Temperature) Test Procedure for Electrical Connectors
This standard specifies the characteristics of spring tension clips for the support of electrical harnesses, in FE-PA3903 for aerospace applications. Maximum operating temperature 250 °C
Aerospace series - Clips, spring tension, in alloy steel FE-PA3903
This standard specifies the characteristics, qualification and acceptance requirements for spring tension clips for the support of electrical harnesses, in alloy steel for aerospace applications. It is applicable whenever referenced.
Aerospace series - Clips, spring tension - Technical specification
This standard specifies the characteristics of spring tension clips for the support of electrical harnesses, in FE-PA3903 for aerospace applications. Maximum operating temperature: 250 ℃
Aerospace series - Clips, spring tension, in alloy steel FE-PA3903
This document specifies the characteristics of washers in heat and corrosion resisting steel intended for use in aircraft fluid system pipelines.
Aerospace series - Washers in heat resisting steel; German and English version EN 3696:2001
Angled duplex stop washer (6355)
Angled duplex stop washer (6354)
Padded suspended clamp (8272)
Padded suspended clamp (8271)
Padded suspension grip clamp with lightening hole (8090)
Padded suspension grip clamp with lightening hole (8089)
Padded suspension grip clamp with lightening hole (8088)
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号