71.080.60 醇、醚 标准查询与下载

T/SDHCIA 022-2022 β-丁氧基丙酸丁酯及丙烯酸正丁酯混合液

本文件规定了β-丁氧基丙酸丁酯及丙烯酸正丁酯混合液（以下简称“混合液”）的技术要求、试验方法、检验规则、标志、标签、随行文件、包装、运输和贮存。 本文件适用于采用甲磺酸或对甲苯磺酸均相催化以丙烯酸和正丁醇反应生产丙烯酸丁酯过程中副产的β-丁氧基丙酸丁酯及丙烯酸正丁酯混合液。

Mixted solution of butyl-β-butoxypropanoate and n-butyl acrylate

T/FSI 082-2022 异氰酸酯基硅烷改性聚醚

本文件规定了异氰酸酯基硅烷改性聚醚的技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于异氰酸酯基硅烷封端的硅烷改性聚醚。

Isocyanatosilane Modified Polyether

T/FSI 085-2022 1,1,2,2-四氟乙基-2,2,3,3-四氟丙基醚

本文件规定了1,1,2,2-四氟乙基-2,2,3,3-四氟丙基醚的技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于以四氟丙醇和四氟乙烯为原料生产出的四氟乙基四氟丙基醚，CAS号为16627-68-2，分子式为C5H4F8O,分子量为232.07。

1,1,2,2-tetrafluoroethyl-2,2,3,3-tetrafluoropropyl ether

T/FSI 086-2022 六氟异丙醇

本文件规定了六氟异丙醇的技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于六氟异丙醇化合物。

Hexafluoroisopropanol

T/FSI 083-2022 1,1,2,2-四氟乙基-2,2,2–三氟乙基醚

本文件规定了1，1，2，2-四氟乙基-2，2，2三氟乙基醚（以下简称四氟乙基三氟乙基醚）的技术要求、试验方法、检验规则、标志、包装、运输、贮存和安全。 本文件适用于以三氟乙醇和四氟乙烯为原料生产出的四氟乙基三氟乙基醚，主要作为有机氟溶剂、清洗剂应用于化工、电子半导体等行业。 分子式C4H3F7O； 相对分子质量200.05（按2018年国际相对原子质量）。

1,1,2,2-Tetrafluoroethyl-2,2,2-trifluoroethyl ether

T/CPCIF 0193-2022 工业用3-甲基-2-丁烯-1-醇

项    目　要    求 　Ⅰ  型　Ⅱ  型 3-甲基-2-丁烯-1-醇，w/%                         ≥　99.50　98.50 3-甲基-3-丁烯-1-醇，w/%                         ≤　0.20　0.30 3-甲基-1-丁醇，w/%                             ≤　0.050　0.10 3-甲基-2-丁烯-1-醛，w/%                        ≤　0.10　0.20 水分，w/%                                    ≤　0.050　0.20 色度（铂-钴色号）/Hazen单位                   ≤　20　30

3-Methyl-2-buten-1-ol for industrial use

T/SDSCCE 018-2022 回收甲醇

本文件规定了回收甲醇的要求、试验方法、检验规则以及标志和随行文件、包装、运输和贮存。 本文件适用于以医药行业合成头孢菌素类、美罗培南类、阿维菌素类、青霉素类医药产生的废液为原料，经过预处理、精馏等工艺得到的回收甲醇，用于化工生产。

Reclaimed methanol

T/CIESC 0027-2022 工业用乙基纤维素

本文件规定了工业用乙基纤维素的产品分类和型号、要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于以精制棉为主要原料，添加氯乙烷经过碱化醚化反应，洗涤干燥、粉碎而成的工业用乙基纤维素。

Ethyl cellulose for industrial use

T/CIESC 0028-2022 工业用羟乙基甲基纤维素

本文件规定了工业用羟乙基甲基纤维素的分类、技术要求、试验方法、检验规则、标志、包装、运输、贮存、质保期。 本文件适用于以天然纤维素为原材料，经过碱化、醚化反应生成的工业用羟乙基甲基纤维素。

Hydroxyethyl methyl cellulose for industrial use

T/CIESC 0033-2022 工业用四氢糠醇

本文件规定了工业用四氢糠醇的技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于以工业糠醇为原料，通过加压催化加氢精制制取的工业用四氢糠醇。主要用于合成二氢呋喃、赖氨酸、维生素B1，也可用作树脂、涂料、油脂的溶剂及药品的脱色、脱臭剂等。

Tetrahydrofurfuryl alcohol ( THFA) for industrial use

T/SDHCIA 019-2022 乙二醇二乙酸酯（EGDA）

本文件规定了乙二醇二乙酸酯(EGDA)的技术要求、试验方法、检验规则、标志、包装、运输、贮存及安全。 本文件适用于乙酸和乙二醇为原料合成的乙二醇二乙酸酯，该产品主要用于涂料、油墨等行业做溶剂及高科技电子设备配件清洗。

Ethylene glycol diacetate (EGDA)

T/LNIQA 002-2022 乙醇中苯的测定

本文件规定了乙醇中苯测定的气相色谱法和顶空气相色谱法。其中气相色谱法的检出限0.50 mg/L，定量限1.0 mg/L；顶空气相色谱法的检出限0.20 mg/L，定量限0.50 mg/L。

Determination of benzene in ethanol

T/CIESC 0022-2022 工业用N -甲基二乙醇胺

本文件规定了工业用N-甲基二乙醇胺的技术要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于以环氧乙烷与一甲胺为原料合成的工业用N-甲基二乙醇胺。主要用于石油与天然气的脱硫和其他工业气体脱碳，也可作医药中间体及某些精细化工产品原料。

N-Methyl diethanol amine（MDEA）for industrial use

BS EN 15491:2021 乙醇作为汽油的调和成分 总酸度的测定 显色指示剂滴定法

What is BS EN 15491 about?    BS EN 15491 discusses about Ethanol as a blending component for petrol. BS EN 15491 specifies a method for determining the total acidity, calculated as acetic acid, of ethanol to be used in petrol blends. It is applicable to ethanol having total acid contents of between 0,003 % (m/m) and 0,015 % (m/m).     NOTE: For the purposes of this document, the terms “% (m/m)” and “% (V/V)” are used to represent the mass fraction and the volume fraction, respectively.  WARNING — BS EN 15491 can involve hazardous materials, operations and equipment. BS EN 15491 does not purport to address all the safety problems associated with its use. It is theresponsibility of the user of this document to take appropriate measures to ensure the safety and health of personnel prior to the application of the document, and to fulfil statutory and regulatory restrictions for this purpose.   

Ethanol as a blending component for petrol. Determination of total acidity. Colour indicator titration method

ASTM D5441-21 用气相色谱法分析甲基叔丁基醚（MTBE）的标准试验方法

1.1 This test method covers the determination of the purity of methyl tert-butyl ether (MTBE) by gas chromatography. It also provides a procedure to measure impurities in MTBE such as C4 to C12 olefins, methyl, isopropyl and tert-butyl alcohols, methyl sec-butyl and methyl tert-amyl ethers, acetone, and methyl ethyl ketone. Impurities are determined to a minimum concentration of 0.02 % by mass. 1.2 This test method is not applicable to the determination of MTBE in gasoline. 1.3 Water cannot be determined by this test method and must be measured by a procedure such as Test Method D1364 and the result used to normalize the chromatographic values. 1.4 A majority of the impurities in MTBE is resolved by the test method, however, some co-elution is encountered. 1.5 This test method is inappropriate for impurities that boil at temperatures higher than 180 °C or for impurities that cause poor or no response in a flame ionization detector, such as water. 1.6 The values stated in SI (metric) units of measurement are preferred and used throughout the standard. 1.6.1 Exception—Alternate units, in common usage, are also provided to improve clarity and aid the user of this test method. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Analysis of Methyl Tert-Butyl Ether (MTBE) by Gas Chromatography

T/SDHCIA 018-2021 工业用新戊二醇酯

本文件规定了工业用新戊二醇酯的要求、试验方法、检验规则、标志、运输和贮存。 本文件适用于以异丁醛为原料加氢生产新戊二醇过程中经精馏、过滤、脱色等工艺制得的工业用新戊二醇酯。该产品是以新戊二醇和羟基特戊酸新戊二醇单酯为主要组分的混合物，主要用于生产不饱和树脂、聚酯粉末涂料等。

Neopentyl glycol esters for industrial use

ASTM D7796-21 用气相色谱法分析乙基叔丁基醚（ETBE）的标准试验方法

1.1 This test method covers the determination of the purity of ethyl tert-butyl ether (ETBE) by gas chromatography. It also provides a procedure to measure impurities in ETBE such as C4 to C12 olefins, methyl, isopropyl and tert-butyl alcohols, methyl sec-butyl and methyl tert-amyl ethers, acetone, and methyl ethyl ketone. 1.2 This test method is not applicable to the determination of ETBE in gasoline. 1.3 Water cannot be determined by this test method and shall be measured by a procedure such as Test Method D6304 and the result used to normalize the chromatographic values. 1.4 Most of the impurities in ETBE are resolved by the test method, however, some co-elution is encountered. 1.5 This test method is inappropriate for impurities that boil at temperatures higher than 180 °C or for impurities that cause poor or no response in a flame ionization detector, such as water. 1.6 The values stated in SI units of measurement are preferred and used throughout the standard. Alternate units, in common usage, are also provided to improve clarity and aid the user of this test method. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Analysis of Ethyl tert-Butyl Ether (ETBE) by Gas Chromatography

KS M 1953-2021 工业用甲醇 试验方法

Methanol for industrial use－Methods of te

KS M 1657-2021 乙醇（乙醇）

Ethanol (Ethyl alcohol)

KS M 1658-2021 甲醇（甲醇）

Methanol (Methyl alcohol)