75.040;75.080 标准查询与下载

BS EN ISO 3838:2004 石油及其产品的试验方法 BS 2000-189/190 原油和液体或固体石油产品 密度或相对密度的测定 毛细管塞比重瓶和分级双毛细管比重瓶方法

Identical with IP 189/190-2005

Methods of test for petroleum and its products. BS 2000-189/190. Crude petroleum and liquid or solid petroleum products. Determination of density or relative density. Capillary-stoppered pyknometer and graduated bicapillary pyknometer methods

EN ISO 3838:2004 原油和液体或固体石油产品.密度或相对密度的测定.毛细管塞比重瓶和带刻度双毛细管比重瓶法［使用:IP 189-190/2005］

Crude petroleum and liquid or solid petroleum products - Determination of desity or relative density - Capillary-stoppered pyknometer and graduated bicapillary pyknometer methods (ISO 3838:2004)

JIS K 2251:2003 原油及石油产品的取样

この規格は，原油，石油製品，半製品.タンク残留物及びたい積物の試料を固定タンク，タンク車，タンクローリ，ドラム，石油タンカー，バージ船などの船舶 (以下，船という。)並びにパイプラインなどから採取する方法について規定する。ただし，液化石油ガス，電気絶縁油及び芳香族製品は適用しない。

Crude petroleum and petroleum products -- Sampling

BS ISO 3007:2002 石油及其产品试验方法.BS 2000-69:石油产品.蒸汽压力的测定.雷德法

This International Standard specifies a method for the determination of the vapour pressure of liquid petroleum products consisting of essentially or wholly of hydrocarbon components, or containing oxygenated hydrocarbons of specific types and at specified maximum concentrations. The method does not apply outside these concentration levels, nor to any blends containing methanol or other oxygenated hydrocarbons not covered in note 1. NOTE 1 The maximum concentration of ethers containing 5 or more carbon atoms is 15 % (V/V), and for ethanol is 10 % (V/V). For higher alcohols, the maximum concentration is 7 % (V/V). NOTE 2 For the purposes of this International Standard, the term "%(V/V)" is used to represent the volume fraction of a material. For petroleum products containing methanol, or other oxygenated hydrocarbons outside the scope of note 1, a dry vapour-pressure test method should be used. For liquefied petroleum gases, ISO 4256 should be used. The test method may be applied to volatile crude petroleum with a vapour pressure exceeding 10kPa, although the precision has not been evaluated. Four procedures are described in this International Standard. Procedures A and B are alternative apparatus configurations for products with a Reid vapour pressure up to 180 kPa, Procedure C is applied to liquid products with a Reid vapour pressure above 180 kPa, and Procedure D applies to aviation gasolines with a Reid vapour pressure of approximately 50 kPa. Vapour pressure is an important physical property of volatile liquids, and has critical performance implications for automotive and aviation gasolines. Vapour pressure is also one of the properties affecting atmospheric evaporation, and is therefore increasingly used in regulations relating to emissions and air quality control. Vapour pressure is also a critical property limiting the performance and safety of operation of equipment during transfer operations. NOTE Because the external atmospheric pressure is counteracted by the atmospheric pressure initially in the vapour chamber, the Reid vapour pressure is approximately the "absolute" vapour pressure at 37,8 ℃. The Reid vapour pressure differs from the true vapour pressure of the sample owing to slight vaporization of the sample and the pressure of water vapour and air in the confined space.

Methods of test for petroleum and its products - BS 2000-69: Petroleum products - Determination of vapour pressure - Reid method

JIS K 2270:2000 原油及石油产品.碳残留量的测定

この規格は，原油及び石油製品の残留炭素分を測定する方法について規定する。

Crude petroleum and petroleum products -- Determination of carbon residue

JIS K 2283:2000 原油及石油产品.运动粘度的测定及根据运动粘度计算粘度指数的方法

この規格は，試験温度においてニュートン液体状の原油及び石油製品の動粘度（ν）をガラス製毛管式粘度計を用いて試験する方法並びに40℃及び100℃における動粘度から石油製品の粘度指数を算出する方法について規定する。

Crude petroleum and petroleum products -- Determination of kinematic viscosity and calculation of viscosity index from kinematic viscosity

NP EN ISO 12185:2000 石油制品以及原油．相关密度的测量，数字密度计或者U型振荡管法（ISO 12185-1996）

A presente Norma especifica um método para determina??o da massa volúmica, de petróleo bruto e de produtos afins, na gama dos 600 a 1100 kg/m3, que possam ser considerados como líquidos (apresentando uma só fase) à temperatura e press?o do ensaio, por meio de um medidor de massa volúmica constituído por um tubo oscilante em U. Esta Norma é aplicável a líquidos de qualquer tens?o de vapor desde que se tomem as precau??es adequadas para que se mantenham numa fase única, sem perdas de leves nem altera??es subsequentes da composi??o e da massa volúmica, durante o manuseamento da amostra e realiza??o do ensaio. NOTA 1: Quando se pretende converter a massa volúmica determinada numa massa volúmica a uma dada temperatura de referência, utilizando as tabelas de medi??o de petróleos brutos, o ensaio deve ser realizado a uma temperatura t?o próxima quanto possível da temperatura de referência, de modo a minimizar as incertezas resultantes da utiliza??o de tabelas de uso geral. Este método n?o deve ser usado na calibra??o de medidores de massa volúmica em linha.

Crude petroleum and petroleum products Determination of density Oscillating U-rude methods(ISO 12185-1996)

GOST 1756-2000 石油焦碳.饱和蒸汽压力测定法

Настоящий стандарт устанавливает метод определения абсолютного давления пара летучей сырой нефти и летучих невязких нефтепродуктов, кро

Petroleum products. Determination of saturated vapours pressure

DIN EN ISO 3675:1999 原油和液体石油产品.密度实验室测定.密度计法

The document specifies a method for the laboratory determination, using a glass hydrometer, of the density of crude petroleum, petroleum products and homogeneous mixtures of petroleum and non-petroleum products.#,,#

Crude petroleum and liquid petroleum products - Laboratory determination of density - Hydrometer method (ISO 3675:1998); German version EN ISO 3675:1998

ISO 3007:1999 石油产品和原油 蒸气压的测定 雷德法

This International Standard specifies a method for the determination of the vapour pressure of liquid petroleum products consisting of essentially or wholly of hydrocarbon components, or containing oxygenated hydrocarbons of specific types and at specified maximum concentrations. The method does not apply outside these concentration levels, nor to any blends containing methanol or other oxygenated hydrocarbons not covered in note 1. NOTE 1 The maximum concentration of ethers containing 5 or more carbon atoms is 15 % (V/V), and for ethanol is 10 % (V/V). For higher alcohols, the maximum concentration is 7 % (V/V). NOTE 2 For the purposes of this International Standard, the term "%(V/V)" is used to represent the volume fraction of a material. For petroleum products containing methanol, or other oxygenated hydrocarbons outside the scope of note 1, a dry vapour-pressure test method should be used. For liquefied petroleum gases, ISO 4256 should be used. The test method may be applied to volatile crude petroleum with a vapour pressure exceeding 10kPa, although the precision has not been evaluated. Four procedures are described in this International Standard. Procedures A and B are alternative apparatus configurations for products with a Reid vapour pressure up to 180 kPa, Procedure C is applied to liquid products with a Reid vapour pressure above 180 kPa, and Procedure D applies to aviation gasolines with a Reid vapour pressure of approximately 50 kPa. Vapour pressure is an important physical property of volatile liquids, and has critical performance implications for automotive and aviation gasolines. Vapour pressure is also one of the properties affecting atmospheric evaporation, and is therefore increasingly used in regulations relating to emissions and air quality control. Vapour pressure is also a critical property limiting the performance and safety of operation of equipment during transfer operations. NOTE Because the external atmospheric pressure is counteracted by the atmospheric pressure initially in the vapour chamber, the Reid vapour pressure is approximately the "absolute" vapour pressure at 37,8 ℃. The Reid vapour pressure differs from the true vapour pressure of the sample owing to slight vaporization of the sample and the pressure of water vapour and air in the confined space.

Petroleum products and crude petroleum - Determination of vapour pressure - Reid method

BS EN ISO 3675:1998 原油和液体石油产品 实验室测定密度 比重计法

Identical with IP 160/99

Crude petroleum and liquid petroleum products. Laboratory determination of density. Hydrometer method

ISO 3675:1998 原油和液体石油产品 密度实验室测定 密度计法

This International Standard specifies a method for the laboratory determination, using a glass hydrometer, of the density at 15 ℃ of crude petroleum, liquid petroleum products, and mixtures of petroleum and non-petroleum products normally handled as liquids and having a Reid vapour pressure (RVP) of 100 kPa or less. This International Standard is suitable for determining the density of mobile transparent liquids. It can also be used for viscous liquids by carrying out the determinations at temperatures above ambient using a suitable liquid bath for temperature control. It can also be used for opaque liquids by reading the hydrometer scale where the top of the meniscus meets the stem of the hydrometer and applying a correction from table 1 (see11.2). Since hydrometers are calibrated to read correctly at the specified temperature, scale readings made at other temperatures are only hydrometer readings and not values of density at these other temperatures. NOTES 1 The accuracy of the density, determined by the procedures given in this International Standard, for volatile and/or waxy crude oils containing free and/or suspended water and sediments can be less than inferred from the precision data quoted in clause 13. This is due to the possible loss of light components during sample mixing. However, sample mixing is necessary to ensure that the test portion transferred to the hydrometer cylinder is as representative as possible of the bulk sample. Techniques are given in clause 7 which are designed to minimize such loss of light component. 2 Values of density at 15 ℃ can be converted using standard measurement tables to equivalent values of API gravity or relative density so that measurements may be made in the units of local convenience.

Crude petroleum and liquid petroleum products - Laboratory determination of density - Hydrometer method

JIS K 2272:1998 原油和石油产品.灰分及硫酸灰分的测定

この規格は，原油及び石油製品(グリース類を除く。)の灰分並びに潤滑油用添加剤が含まれる未使用潤滑油及び潤滑油用添加剤の硫酸灰分を試験する方法について規定する。

Crude oil and petroleum products -- Determination of ash and sulfated ash

JIS K 2265:1996 原油及石油产品.闪点的测定

Crude oil and petroleum products -- Determination of flash point

JIS K 2275:1996 原油及石油产品.水含量的测定

この規格は，原油及び石油製品の水分を定量する方法について規定する。

Crude oil and petroleum products -- Determination of water content

JIS K 2541:1996 原油和石油产品.硫含量的测定

この規格は，原油及び石油製品の硫黄分を定量する方法について規定する。

Crude oil and petroleum products -- Determination of sulfur content

JIS K 2249:1995 原油和石油产品.基于标准温度(15℃)的密度的测定和石油测量表

この規格は，常温で液状又は固状のもので，JIS K 2258によって測定した蒸気圧が180 KPa{1.84kgf/cm}以下の原油及び石油製品の密度試験方法並びに密度?質量?容量換算表について規定する。

Crude petroleum and petroleum products -- Determination of density and petroleum measurement tables based on a reference temperature (15 centigrade degrees)

JIS B 7995:1994 原油及石油产品中硫含量的自动分析仪

この規格は，原油及び石油製品中の硫黄分を放射線を用いて測定する自動計測器(以下，計測器という。)について規定する。

Automatic analysers for sulphur in crude oil and petroleum products

BS 7702:1993 粘性碳氢化合物体积计量指南

This International Standard defines viscous hydro-carbons and describes the difficulties that arise when viscous hydrocarbons are raised to high temperatures. The effects of such temperatures upon meters, auxiliary equipment and fittings are discussed, and advice and warnings to overcome or mitigate diffi-culties are included.

Guide to volumetric metering of viscous hydrocarbons

ISO 9200:1993 原油和液态石油产品 粘质烃类容量计量

Defines viscous hydrocarbons and describes the difficulties that arise when they are raised to high temperatures. The effects of such temperatures upon meters, auxiliary equipment and fittings are discussed, and advice and warnings to overcome or mitigate difficulties are included.

Crude petroleum and liquid petroleum products; volumetric metering of viscous hydrocarbons