共找到 92 条与 相关的标准,共 7 页
Asphalt - Roadbase courses : roadbase asphalt concrete - Definition - Classification - Characteristics - Manufacturing - Laying.
Asphalt - Wearing course and base courses : high modulus asphalt concrete - Definition - Classification - Characteristics - Fabrication - Laying.
Road materials - Test method for the analysis of bituminous mixtures by ignition
Tests relating to pavements. Preparation of bituminous mixtures. Part 2 : plates compaction.
Specifies requirements for residual bitumens intended for use in the construction and maintenance of pavements.
Residual bitumen for pavements
Specifies requirements for anionic and cationic bituminous emulsions suitable for use in the construction and maintenance of pavements.
Bituminous emulsions for the construction and maintenance of pavements
Methods of testing bitumen and related roadmaking products - Determination of breaking behaviour by setting time
Describes a simple static load compression test which uses conditions similar to those experienced in roads.
Sampling and examination of bituminous mixtures for roads and other paved areas - Method for determination of resistance to permanent deformation of bituminous mixtures subject to unconfined uniaxial loading
Specifies requirements for the preparation of samples of materials as in AS 2008 and unidentified or improperly identified bituminous materials which may be classified as AMC 5, 6 or 7 in accordance with AS 2157.
Methods of testing bitumen and related roadmaking products - Sample preparation
Test relating to pavements. Static test on bituminous mixtures. Part 3 : hubbard field test.
ASPHALT. WEARING COURSE AND BASE COURSES : THIN LAYER ASPHALT CONCRETE. DEFINITION. CLASSIFICATION. CHARACTERISTICS. MANUFACTURING. LAYING.
Sets out a treatment of bitumen which is intended to simulate the conditions obtained when the bitumen is used to manufacture hot-mixed asphalt, and stipulates a procedure for measuring the flow properties of the bitumen before and after the treatment.
Methods of testing bitumen and related roadmaking products - Determination of the effect of heat and air on a moving film of bitumen (rolling thin film oven (RTFO) test)
Sets out procedures for the determination of dynamic viscosity of bituminous materials at a defined shear rate, using constant rate of rotation viscometers with standard concentric cylinder measuring geometries.
Methods of testing bitumen and related roadmaking products - Determination of dynamic viscosity by rotational viscometer
Sets out a procedure for the determination of the ductility of bitumen.
Methods of testing bitumen and related roadmaking products - Determination of ductility
Sets out a procedure for the determination of the closed flashpoint of cutback bitumens when the flashpoint does not exceed 110?C.
Methods of testing bitumen and related roadmaking products - Determination of flashpoint of cutback bitumen
Asphalt. Wearing course : cold asphalt concrete. Definition. Classification. Characteristics. Manufacturing. Laying.
ASPHALT. SURFACE COURSE AND BINDER COURSE. HIGH MODULUS ASPHALT CONCRETE. DEFINITION. CLASSIFICATION. CHARACTERISTICS. MANUFACTURING. LAYING.
Tests relating to pavements. Surface drainage properties on pervious pavements. Part 3 : site permeability test.
TESTS RELATING TO PAVEMENTS. PREPARATION OF BITUMINOUS MIXTURES. PART 5 : MEASUREMENT OF THE DENSITY IN THE LABORATORY USING A GAMMA DENSIMETER.
Bituminous asphalt. Laying of base, binder and surface courses. Components. Mix contents. Performance and checks.
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号