75.180.30 容积设备和容积测量 标准查询与下载

KS M ISO 4269-2014(2019) 石油和液体石油产品 - 液体测量的油罐校准 - 使用体积计的增量法

Petroleum and liquid petroleum products — Tank calibration by liquid measurement — Incremental method using volumetric meters

KS M ISO 11223:2014 石油和液态石油产品 直接静态测量 立式储罐容量的静压储罐计量测量

Petroleum and liquid petroleum products — Direct static measurements — Measurement of content of vertical storage tanks by hydrostatic tank gauging

KS M ISO 4269:2014 石油和液化石油产品 通过液体测量进行油箱校准 使用容积测量仪的递增法

Petroleum and liquid petroleum products — Tank calibration by liquid measurement — Incremental method using volumetric meters

GSO ISO 7278-2:2014 碳氢化合物液体动态测量经过验证的体积测量系统 第2部分：卡箍管

1.1 This part of ISO 7278 provides guidance for the design, installation and calibration of pipe provers. Calculation techniques for use when calibrating and operating provers are detailed in ISO 4267-2. 1.2 Most of the material in this part of ISO 7278 is general in that it applies to pipe provers for use with different liquids and types of meters and for proving them in different services. This part of ISO 7278 does not apply to the newer "small volume" or "compact" provers. 1.3 The standard reference conditions for petroleum measurement are a temperature of 15 °C and a pressure of 101 325 Pa as specified in ISO 5024. NOTE - In some countries other reference temperatures are used, e.g. 20 °C and 60 °F.

Liquid hydrocarbons -- Dynamic measurement -- Proving systems for volumetric meters -- Part 2: Pipe provers

GSO ISO 7278-1:2014 碳氢化合物液体 动态测量 经过验证的体积测量系统 第1部分：一般原则

This part of ISO 7278 provides general principles for proving systems for meters used in dynamic measurement of liquid hydrocarbons

Liquid hydrocarbons -- Dynamic measurement -- Proving systems for volumetric meters -- Part 1: General principles

GSO ISO 7278-4:2014 碳氢化合物液体 动态测量 经过验证的体积测量系统 第4部分：安装管道操作员指南

This part of ISO 7278 provides guidance on operating pipe provers to prove turbine meters and displacement meters. It applies both to the types of pipe prover specified in ISO 7278-2, which are referred to here as "conventional pipe provers", and to other types referred to here as "compact pipe provers" or "small volume provers". It is intended for use as a reference manual for the operation of pipe provers, and also for use in staff training. It does not cover the detailed differences between provers of broadly similar types made by different manufacturers.

Liquid hydrocarbons -- Dynamic measurement -- Proving systems for volumetric meters -- Part 4: Guide for operators of pipe provers

SY/T 6999-2014 用移动式气体流量标准装置在线检定流量计的一般要求

本标准规定了用移动式气体流量标准装置在线检定流量计时，对安全防护、站场条件、工作条件、计量控制、安装操作、检定等方面的一般要求。 本标准适用于用移动式气体流量标准装置在天然气计量站对流量计进行在线检定。 用移动式气体流量标准装置在天然气计量站对流量计进行离线检定时可参考本标准执行。

General requirements for flow meters on-line verification with a traveling gas flow standard facility

GSO ISO 10976:2014 低温轻烃液体 液化天然气运输船上货物的测量

This International Standard establishes all of the steps needed to properly measure and account for the quantities of cargoes on liquefied natural gas (LNG) carriers. This includes, but is not limited to, the measurement of liquid volume, vapour volume, temperature and pressure, and accounting for the total quantity of the cargo on board. This International Standard describes the use of common measurement systems used on board LNG carriers, the aim of which is to improve the general knowledge and processes in the measurement of LNG for all parties concerned. This International Standard provides general requirements for those involved in the LNG trade on ships and onshore.

Refrigerated light hydrocarbon fluids - Measurement of cargoes on board LNG carriers

LST EN ISO 8311:2014 冷冻轻烃液和非石油基液化气体燃料. 船用隔膜式油罐和单独式油罐的标定. 手工和内部电光测距法(ISO 8311-2013)

Refrigerated hydrocarbon and non-petroleum based liquefied gaseous fuels - Calibration of membrane tanks and independent prismatic tanks in ships - Manual and internal electro-optical distance-ranging methods (ISO 8311:2013)

DIN EN ISO 8311:2014 冷冻轻烃液和非石油基液化气体燃料.船用隔膜式油罐和单独式油罐的标定.手工和内部电光测距法(ISO 8311-2013).德文版本EN ISO 8311-2013

Refrigerated hydrocarbon and non-petroleum based liquefied gaseous fuels - Calibration of membrane tanks and independent prismatic tanks in ships - Manual and internal electro-optical distance-ranging methods (ISO 8311:2013); German version EN ISO 8311:20

DB50/T 540-2014 微电子热质燃气流量计

本标准适用于燃气种类为人工燃气、天然气、液化石油气，工作压力不超过50kPa的封闭管道中燃气流量的质量、体积和能量计量。

Microelectronic Thermal Mass Gas Flow Meter

DB50/T 541-2014 湿式气体流量计

本标准适用于湿式气体流量计的生产制造和验收。

Wet Gas Flow Meter

DB13/T 1831-2013 河北省车用天然气气瓶充装安全管理规范

本标准规定了车用天然气充装站(以下简称充装站)车用气瓶充装的一般要求、人员、设备、设施、仪器和保护装置、气瓶充装安全管理、应急管理及接受安全监察等方面的安全管理要求。 本标准适用于工作压力不大于25MPa、公称容积为30L～450L、工作温度为-40℃～60℃的车用压缩天然气(CNG)气瓶和在正常环境温度(-40℃～60℃)下使用，工作压力为0.6 MPa～3.5MPa、公称容积为150 L～500L、设计温度不低于-196℃的车用液化天然气(LNG)气瓶充装安全管理。

Safety management specification for filling natural gas cylinders for vehicles in Hebei Province

BS EN ISO 8311:2013 液化气体燃料非石油基冷冻烃.船上膜式舱和独立棱柱舱校准.手工内部电光距离射程法

Refrigerated hydrocarbon and non-petroleum based liquefied gaseous fuels. Calibration of membrane tanks and independent prismatic tanks in ships. Manual and internal electro-optical distance-ranging methods

GSO ISO 18132-3:2013 低温轻烃液体 自动液位计的一般要求 第3部分：海上油轮和浮罐上液化石油和化学气体的自动液位计

This part of ISO 18132 establishes general principles for the accuracy, installation, calibration and verification of automatic tank gauges (ATGs) used for custody transfer measurement of liquefied petroleum and chemical gases on board a gas carrier or floating storage. The part of ISO 18132 also describes the technical requirements for data collection, transmission and reception. Specific technical requirements for various automatic tank gauges and accuracy limitations are given in the annexes.

Refrigerated hydrocarbon and non-petroleum based liquefied gaseous fuels -- General requirements for automatic tank gauges -- Part 3: Automatic tank gauges for liquefied petroleum and chemical gases on board marine carriers and floating storage

KS M ISO 8222-2013 石油测量系统 校准 校准体积检验罐时使用的温度校正

Petroleum measurement systems－Calibration－Temperature corrections for use when calibrating volumetric proving tanks

KS M ISO 8311-2013 冷冻轻烃流体 船舶隔膜罐和独立棱柱形罐的校准 物理测量

Refrigerated light hydrocarbon fluids－Calibration of membrane tanks and independent prismatic tanks in ships－Physical measurement

KS M ISO 6551-2013 石油液体和气体 动态测量的保真度和安全性 电气和/或电子脉冲数据的有线传输

Petroleum liquids and gases－Fidelity and security of dynamic measurement－Cabled transmission of electric and/or electronic pulsed data

KS M ISO 13689-2013 冷冻轻烃流体 液化气体储罐液位测量 微波式液位计

Refrigerated light hydrocarbon fluids－Measurement of liquid levelsin tanks containing liquefied gases－Microwave-type level gauge

KS M ISO 9091-1-2013 冷冻轻烃流体 船舶球罐校准 第1部分：立体摄影测量

Refrigerated light hydrocarbon fluids－Calibration of spherical tanks in ships－Part 1：Stereo-photogrammetry