83.040.10 胶乳和生橡胶 标准查询与下载

KS M 6717-2022 合成橡胶CR胶乳试验方法

Testing method for synthetic rubber CR latex

KS M ISO 7781-2022 生丁苯橡胶.皂和有机酸含量的测定

Styrene-butadiene rubber, raw — Determination of soap and organic-acid content

BS ISO 249:2016+A1:2022 橡胶 天然原料 污垢含量的测定

1   Scope This International Standard specifies a method for the determination of the dirt content of raw natural rubber. It is not applicable to dirt present as surface contamination.

Rubber, raw natural. Determination of dirt content

ASTM D6049-03(2022) 用平行板之间的压缩法测量未硫化原橡胶和橡胶化合物的粘性和弹性行为的橡胶性能的标准试验方法

1.1 This test method is an adaptation of the German Standard DIN 53514, a further development of the former “Defo Test” (see Appendix X1). 1.2 This test method is capable of measuring and characterizing the rheological behavior (viscosity and elasticity) of unvulcanized raw rubbers and rubber compounds, relating to the macro structure of rubber polymers (average molecular weight, molecular weight distribution, long chain branching, and microand macro-gel). 1.3 The viscosity and elasticity of unvulcanized rubbers and rubber compounds are determined by subjecting cylindrical test pieces to a compression/recovery cycle. The dependency on shear rate at constant shear stress is evaluated and the material fatigue behavior is determined in repeat cycle testing. 1.4 The non-Newtonian viscous and elastic behavior of rubbers and rubber compounds can also be evaluated. 1.5 Statistical evaluation of the test data provides an indication of data variation, which may be employed as an estimate of the homogeneity of the material tested. 1.6 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Rubber Property—Measurement of the Viscous and Elastic Behavior of Unvulcanized Raw Rubbers and Rubber Compounds by Compression Between Parallel Plates

ASTM D3184-11(2022) 天然橡胶（NR）橡胶评价的标准试验方法

1.1 This practice covers the standard materials, test formulas, mixing procedures, and test methods for the evaluation and production control of natural rubber (NR). 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Rubber—Evaluation of NR (Natural Rubber)

ASTM D3194-17(2022) 天然橡胶塑性保持指数(PRI)的试验

1.1 This test method gives an indication of the oxidation resistance of raw natural rubber at a specified temperature. This resistance is indicated by the Plasticity Retention Index (PRI), a ratio expressed as a percentage of the aged plasticity to the original plasticity determined by means of a parallel plate plastometer. A low PRI value indicates a poor resistance to oxidation. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Rubber From Natural Sources—Plasticity Retention Index (PRI)

BS ISO 2006-1:2022 合成橡胶乳胶 机械稳定性的测定 高速法

1   Scope This document specifies a method for the determination of the high-speed mechanical stability of synthetic rubber latex. The method is not applicable to compounded synthetic rubber latices.

Rubber latex, synthetic. Determination of mechanical stability. High-speed method

ISO 2006-1:2022 合成橡胶胶乳.机械稳定性的测定.第1部分:高速法

This document specifies a method for the determination of the high-speed mechanical stability of synthetic rubber latex. The method is not applicable to compounded synthetic rubber latices.

Rubber latex, synthetic — Determination of mechanical stability — Part 1: High-speed method

22/30446379 DC BS ISO 19043 天然橡胶浓缩胶乳 分光光度法测定总磷含量

BS ISO 19043 Natural rubber latex concentrate. Determination of total phosphate content by spectrophotometric method

ISO 249:2016/Amd 1:2022 天然生胶.污垢含量的测定.修改件1

Rubber, raw natural — Determination of dirt content — Amendment 1

ASTM D3853-22 橡胶和橡胶胶乳相关的标准术语复合用化学品的缩写

1.1 This terminology is a compilation of abbreviations for accelerators, vulcanizing agents, activators, antidegradants, plasticizers, softeners, processing aids, blowing agents, retarders, isocyanates, peroxides, and antireversion agents used in the compounding of rubber products. Abbreviations for rubbers are listed in Practice D1418 and a numbering system for various grades of carbon blacks is described in Classification D1765. 1.2 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Terminology Relating to Rubber and Rubber Latices—Abbreviations for Chemicals Used in Compounding

KS M ISO 498-2022 天然橡胶浓缩胶 干膜的制备

Natural rubber latex concentrate－Preparation of dry films

KS M ISO 12243-2022 天然胶乳医用手套 改良洛瑞法测定水可提取蛋白

Medical gloves made from natural rubber latex — Determination of water-extractable protein using the modified Lowry method

KS M ISO 17052-2022 生橡胶 毛细管气相色谱法测定残留单体和其他挥发性低分子化合物 热脱附（动态顶空）法

Rubber, raw－Determination of residual monomers and other volatile low-molecular-mass compounds by capillary gas chromatography－ Thermal desorption(dynamic headspace) method

KS M ISO 1657-2022 橡胶、原料及胶乳 铁含量的测定 1,10-菲咯啉光度法

Rubber, raw and rubber latex－Determination of iron content－1,10-Phenanthroline photometric method

KS M ISO 249-2022 天然生橡胶 污垢含量的测定

Rubber, raw natural－Determination of dirt content

KS M ISO 2006-2-2022 合成胶乳 机械稳定性的测定 第2部分：负载中速法

Rubber latex, synthetic－Determination of mechanical stability－Part 2：Moderate-speed method under load

KS M ISO 13773-2022 橡胶 氯丁橡胶 碱度的测定

Rubber－Polychloroprene latex－Determination of alkalinity

KS M ISO 35-2022 浓缩天然胶乳 机械稳定性的测定

Natural rubber latex concentrate－Determination of mechanical stability

KS M ISO 11089-2022 生合成橡胶 高效液相色谱法测定抗降解剂

Rubber, raw synthetic－Determination of antidegradants by high-performance liquid chromatography