83.040.20 橡胶合成配料 标准查询与下载

KS M ISO 11234-2022 橡胶配合料 炭黑（粒状） 粉尘含量的测定

Rubber compounding ingredients－Carbon black(pelletized)－Determination of dust content

KS M ISO 11235-2022 橡胶配合剂 次磺酰胺促进剂 试验方法

Rubber compounding ingredients－Sulfenamide accelerators－Test methods

KS M ISO 1124-2022 橡胶配合料 炭黑出货取样程序

Rubber compounding ingredients－Carbon black shipment sampling procedures

KS M ISO 21870-2022 橡胶配合料 炭黑 热重法高温加热失重的测定

Rubber compounding ingredients－Carbon black－Determination of high－temperature loss on heating by thermogravimetry

KS M ISO 1125-2022 橡胶配合料 炭黑 灰分的测定

Rubber compounding ingredients－Carbon black－Determination of ash

KS M ISO 5796-2022 橡胶配合料 天然碳酸钙 试验方法

Rubber compounding ingredients－Natural calcium carbonate－Test methods

KS M ISO 9298-2022 橡胶配合剂 氧化锌 试验方法

Rubber compounding ingredients－Zinc oxide－Test methods

KS M ISO 4656-2022 橡胶配合料炭黑吸油值（OAN）和压缩样品吸油值（COAN）的测定

Rubber compounding ingredients — Carbon black — Determination of oil absorption number(OAN) and oil absorption number of compressed sample(COAN)

KS M ISO 5794-2-2022 橡胶配合料 沉淀水合二氧化硅 第2部分：苯乙烯-丁二烯橡胶的评价程序

Rubber compounding ingredients — Silica, precipitated, hydrated — Part 2:Evaluation procedures in styrene-butadiene rubber

KS M ISO 5794-1-2022 橡胶配合料 二氧化硅 沉淀 水合 第1部分：非橡胶测试

Rubber compounding ingredients — Silica, precipitated, hydrated — Part 1: Non-rubber tests

KS M ISO 8511-2022 橡胶配合料 炭黑 颗粒粒度分布的测定

Rubber compounding ingredients－Carbon black－Determination of pellet size distribution

KS M ISO 1304-2022 橡胶配合料 炭黑 碘吸附值的测定

Rubber compounding ingredients－Carbon black－Determination of iodine adsorption number

T/FSI 078-2022 硅橡胶用气相二氧化硅

本文件规定了硅橡胶用气相二氧化硅的分类和名称、技术要求、试验方法、取样、检验规则、标志、包装、运输和贮存。 本文件适用于未经处理和表面处理的气相二氧化硅。

Fumed silica for silicone rubber

JIS K 6217-5:2022 橡胶工业用炭黑—基本特性—第5部分：着色力的测定

Carbon black for rubber industry -- Fundamental characteristics -- Part 5: Determination of tinting strength

22/30446370 DC BS ISO 1138 橡胶混炼成分 碳黑 硫含量的测定

BS ISO 1138. Rubber compounding ingredients. Carbon black. Determination of sulfur content

T/CRIA 25002-2021 橡胶硫化促进剂TBBS

本文件规定了N－叔丁基－2－苯并噻唑次磺酰胺（橡胶硫化促进剂TBBS）的要求、试验方法、检验规则、标志、包装、运输和贮存。 本文件适用于橡胶硫化促进剂TBBS的生产、检验、交付、验收

Rubber vulcanization accelerator TBBS

T/CRIA 20003-2021 长纤维色母粒用炭黑

本文件规定了长纤维色母粒用炭黑的命名、技术要求、试验方法、检验规则和包装、标志、贮存和运输。 本文件适用于以油、气为原料，通过炉法，接触法等方式生产用在纺丝行业长纤维色母粒炭黑。

Carbon black for long fiber masterbatch

ASTM D4578-06(2021) 用萃取法测定橡胶化学品硫百分比的标准试验方法

Standard Test Methods for Rubber Chemicals—Determination of Percent Sulfur by Extraction

ASTM D1766-05(2021) 橡胶化学品溶解度的标准试验方法

1.1 This test method covers a practical test for the solubility of commercial chemicals used in rubber products. 1.2 It is not a true measure of solubility, since equilibrium is not approached from both sides, that is, higher temperature and lower temperature. 1.3 The test method indicates the total solubility, under the conditions of the test, of all components in the presence of each other and in the proportions present in the sample. 1.4 This test method does not measure the solubility of a rubber chemical in rubber. 1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Rubber Chemicals—Solubility

ASTM D4075-06(2021) 橡胶复合材料的标准试验方法金属的火焰原子吸收分析测定

1.1 These test methods cover the determination of metals in rubber compounding materials by flame atomic absorption. 1.2 The test methods include the following materials: Sections Zinc oxide 11 – 20 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (For a specific warning statement, see 6.1.) 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods for Rubber Compounding Materials—Flame Atomic Absorption Analysis—Determination of Metals