91.140.30 通风和空调 标准查询与下载

KS B 6274-2022 制冷机组冷却器的容量评估

Capacity evaluation for refrigerating unit coolers

KS B 6273-2022 水冷冷凝器 分体式

Water－cooled condensers, remote type

KS B 6272-2022 远程机械通风风冷制冷剂冷凝器

Remote mechanical－draft air－cooled refrigerant condenser

T/CAB 0162-2022 特定人群室内环境空气质量

本文件规定了特定人群室内环境空气质量的术语和定义、要求和试验方法。

Indoor environment air quality for specific population

BS EN ISO 29463-5:2022 用于去除空气中颗粒的高效过滤器和过滤介质 过滤元件的试验方法

1   Scope This document specifies the test methods for determining the efficiency of filters at their most penetrating particle size ( MPPS ). It also gives guidelines for the testing and classification for filters with an MPPS of less than 0,1 μm (Annex B) and filters using media with (charged) synthetic fibres (Annex  C ). It is intended for use in conjunction with ISO 29463‑1, ISO 29463‑2, ISO 29463‑3 and ISO 29463‑4.

High-efficiency filters and filter media for removing particles in air - Test method for filter elements

T/CAB 0155-2022 房间空气调节器用铝管翅式热交换器技术规范

本文件规定了铝管翅式热交换器（蒸发器、冷凝器）的术语和定义、技术要求、试验方法、检验规则、标志、包装、运输及贮存。

Technical specification for aluminum tube fin heat exchanger for room air conditioner

T/CAB 0104-2022 人工环境舒适性产品 第7部分：带新风净化功能的房间空气调节器（修订）

本文件规定了带新风净化功能房间空气调节器的术语和定义、型号、分类及基本参数、技术要求、试验方法、检验规则、标志、包装、运输和贮存等。

Artificial atmosphere comfort products Part 7: Air conditioners with fresh air purification function

T/CPQS E00030-2022 厨房专用房间空气调节器

本文件规定了厨房专用房间空气调节器（以下简称空调器）的术语和定义、产品分类和基本参数、要求、试验方法、检验规则等。

Room air conditioner for household kitchen

T/ZZXJX 122-2022 住宅厨房和卫生间排气道系统应用技术规程

前  言　 1 范围　 2 规范性引用文件　 3 术语和定义　 4 系统及组成　   4.1 一般规定　   4.2 排气道　   4.3 防火止回阀　   4.4 屋顶风帽　   4.5 变压装置　 5 设计　   5.1 一般规定　   5.2 系统设计　   5.3 排气道设计　   5.4 防火止回阀设计　   5.5 屋顶风帽设计　 6 施工　   6.1 一般规定　   6.2 排气道安装施工　   6.3 防火止回阀安装　   6.4 屋顶风帽安装　 7 验收　   7.1 一般规定　   7.2 主控项目　   7.3 一般项目　

Technical specification for the application of residential kitchen and bathroom exhaust system

T/CRAAS 439.3-2022 一般通风过滤器—— 第3部分：计重效率及阻力与试验容尘量关系的测定

T/CRAAS 439系列标准的本部分规定了一般通风过滤器计重效率及阻力的试验设备和试验方法。 本标准需与T/CRAAS 439.1、T/CRAAS 439.2和T/CRAAS 439.4联合使用。 本标准规定的试验方法，适用风量为0.25 m3/s～1.5m3/s（900 m3/h～5400 m3/h），试验台名义截面610 mm×610 mm。 T/CRAAS 439标准（所有部分）适用于按本系列标准规定试验规程实测ePM1效率不高于99%、ePM10效率不低于20%的一般通风过滤器。 T/CRAAS 439标准（所有部分）适用于按本系列标准规定试验规程实测ePM1效率不高于99%的一般通风过滤器，以及ePM10效率不低于20%的一般通风过滤器。 过滤器对其他粒径范围的过滤效率测定采用其他试验方法，如T/CRAA 431第1～5部分。 本标准不适用于便携式室内空气净化器所用过滤器。 按本系列标准得到的过滤器性能试验结果，不能用于定量预测受试过滤器在实际使用条件下的过滤效率和使用寿命。

General ventilation filters -- Part 3: Determination of gravimetric efficiency and resistance in relation to test dust holding capacity

T/CRAAS 439.2-2022 一般通风过滤器—— 第2部分：计径效率和阻力的测量

T/CRAAS 439系列标准的本部分规定了一般通风过滤器计径效率及阻力试验中的气溶胶发生、试验仪器和试验方法。 本标准需与T/CRAAS 439.1、T/CRAAS 439.3和T/CCRAAS 439.4联合使用。 本标准规定的试验方法，适用风量为0.25 m3/s～1.5m3/s（900 m3/h～5 400 m3/h）、名义截面为610 mm×610 mm的过滤器。 T/CRAAS 439标准（所有部分）适用于按T/CRAAS 439系列标准规定试验规程实测ePM1效率不高于99%、ePM10效率不低于20%的一般通风过滤器。 注：规定本标准适用的过滤器ePM10效率的下限为20%，这是因为，低于该效率时，本标准获得的试验结果很难保证统计学上的有效性要求。 过滤器对其他粒径范围的过滤效率测定采用其他试验方法，见T/CRAA 431。 本标准不适用于便携式室内空气净化器所用过滤器。 按本系列标准得到的过滤器性能试验结果，不能用于定量预测受试过滤器在实际使用条件下的过滤效率和使用寿命。

General ventilation filters -- Part 2: Measurement of gauge efficiency and resistance

ASTM F1704-12(2022) 商用厨房排气通风系统的捕获和容纳性能的标准试验方法

1.1 Characterization of capture and containment performance of hood, appliance(s), and replacement air system during cooking and non-cooking conditions (idle): 1.2 Parametric evaluation of operational or design variations in appliances, hoods, or replacement air configurations. 1.3 The test method to determine heat gain to space from commercial kitchen ventilation/appliance systems has been re-designated as Test Method F2474. 1.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Capture and Containment Performance of Commercial Kitchen Exhaust Ventilation Systems

ASTM F2975-12(2022) 商用厨房通风系统现场性能测量的标准试验方法

1.1 This test method can be used to measure and validate successful design, installation and commissioning of commercial kitchen HVAC and makeup air systems for specific installations. 1.2 This test method field evaluates commercial kitchen ventilation system airflows and pressures. 1.3 This test method field evaluates visual hood capture and containment performance. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only. 1.5 The data generated is specific to the field conditions as installed. 1.6 This test method may involve hazardous materials, gasses (for example, CO) operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Measuring the Field Performance of Commercial Kitchen Ventilation Systems

EN ISO 29463-5:2022 去除空气中颗粒的高效过滤器和过滤介质.第5部分:滤芯的试验方法

This document specifies the test methods for determining the efficiency of filters at their most penetrating particle size (MPPS). It also gives guidelines for the testing and classification for filters with an MPPS of less than 0,1 μm (Annex B) and filters using media with (charged) synthetic fibres (Annex C). It is intended for use in conjunction with ISO 29463‑1, ISO 29463‑2, ISO 29463‑3 and ISO 29463‑4.

High-efficiency filters and filter media for removing particles in air - Part 5: Test method for filter elements (ISO 29463-5:2022)

ISO 29463-5:2022 去除空气中颗粒的高效过滤器和过滤介质.第5部分:滤芯的试验方法

This document specifies the test methods for determining the efficiency of filters at their most penetrating particle size (MPPS). It also gives guidelines for the testing and classification for filters with an MPPS of less than 0,1 μm (Annex B) and filters using media with (charged) synthetic fibres (Annex C). It is intended for use in conjunction with ISO 29463-1, ISO 29463-2, ISO 29463-3 and ISO 29463-4.

High-efficiency filters and filter media for removing particles in air — Part 5: Test method for filter elements

T/CAB 0135-2022 人工热环境舒适性测评规范 第4部分：分温区控制的房间空气调节器

本文件规定了房间空气调节器分温区控制的术语和定义、测试方法、评价方法。

Test and evaluation for artificial thermal environment comfort-Part 4:Room air conditioners controlled to generate different temperature zones

JIS B 9927-1:2022 高效过滤器（EPA、HEPA和ULPA）和去除空气中颗粒物的过滤介质 第1部分：分类、性能、试验和标记

High-efficiency filters (EPA, HEPA and ULPA) and filter media for removing particles in air -- Part 1: Classification, performance, testing and marking

JIS B 9927-2:2022 用于去除空气中颗粒的高效过滤器（EPA、HEPA和ULPA）和过滤介质 第2部分：气溶胶产生、测量设备和颗粒计数统计

High-efficiency filters (EPA, HEPA and ULPA) and filter media for removing particles in air -- Part 2: Aerosol production, measuring equipment and particle-counting statistics

JIS B 9927-3:2022 高效过滤器（EPA、HEPA 和 ULPA）和去除空气中颗粒物的过滤介质 第3部分：测试平板过滤介质

High-efficiency filters (EPA, HEPA and ULPA) and filter media for removing particles in air -- Part 3: Testing flat sheet filter media

JIS B 9927-5:2022 高效过滤器（EPA、HEPA和ULPA）和去除空气中颗粒物的过滤介质 第5部分：滤芯试验方法

High-efficiency filters (EPA, HEPA and ULPA) and filter media for removing particles in air -- Part 5: Test method for filter elements