共找到 1086 条与 道路设备和装置 相关的标准,共 73 页
本文件规定了公路御风自发光线形诱导防眩板产品分类、结构、型号、规格、生产与制造、试验方法、检验规则、标识、包装、运输及贮存。 本文件适用于多风地区、强风多发地区和大雾频现地区能见度低的情形下使用的公路防眩板的生产、检验和使用。
Anti-glare board for highway with wind resistant and Self luminous alignment guide functions
本文件规定了公路混凝土护栏改造加固的术语和定义、护栏现状调查、改造加固条件、设计的要求。本文件适用于国省干线公路及农村公路的改扩建、养护工程中混凝土护栏的改造加固。
Code for design of highway concrete guardrail reconstruction and reinforcement
为规范高速公路标线施工,保证标线质量,制定本规程。本规程适用于新建、改扩建高速公路标线施工质量控制,其他等级公路可参照执行。
Code of practice for expressway markings construction
Energy efficiency levels and assessment methods of electrical equipment for highway electromechanical facilities Part 4: Highway LED variable message signs
本部分适用于公路隧道用射流式通风机的能效等级评定。
Energy efficiency levels and assessment methods of electrical equipment for highway mechanical and electrical facilities Part 2: Highway tunnel ventilators
Energy efficiency levels and assessment methods of electrical equipment for highway electromechanical facilities Part 1: LED lane control signs
本文件规定了公路隧道照明系统的基本要求、能效等级和评定方法。 本文件适用于公路隧道照明系统的能效等级评定。
Energy efficiency grade and evaluation method of main electricequipment for highway mechanical and electrical facilities-Part 3Highway tunnel lighting system
Energy efficiency levels and assessment methods of electrical equipment for highway electromechanical facilities Part 5: Highway LED lighting fixtures
本文件规定了路面标线涂料的分类、技术要求、试验方法、检验规则,以及标志、包装、运输和储存等要求。 本文件适用于在公路上施划的道路交通标线所用的路面标线涂料的生产、检验和使用。
Pavement marking paint
本文件适用于珠海市城市道路及其市区范围内其他允许社会机动车通行的公众场所,包括广场、公共停车场等用于公众通行的场所的交通设施设置的设计、施工、验收及维护。兼具城市道路功能的公路在满足相关国家和行业规范的前提下,可参照本文件执行。
Technical specifications for the installation of urban road traffic safety and management facilities in Zhuhai City
1 总则 2 规范性引用文件 3 彩铺总体要求 4 基本规定 5 材料要求 6 设置要求 7 施工与质量验收 本指南用词说明
Tianjin Bicycle Lane Color Paving Technical Guide
This European Standard contains provisions for the measurement of performance of products for the road restraint systems, under impact and impact severity levels, and includes: - Test site data; - Definitions for road restraint systems; - Vehicle specification (including loading requirements) for vehicles used in the impact tests; - Instrumentation for the vehicles; - Calculation procedures and methods of recording crash impact data including impact severity levels; - VCDI. The modifications included in this standard are not a change of test criteria, in the sense of EN 1317-5:2007, ZA.3.
Road restraint systems - Part 1: Terminology and general criteria for test methods
This European Standard specifies requirements on impact performance of safety barriers, including vehicle parapets, classes of containment, working width, vehicle intrusion and impact severity levels. NOTE This European Standard should be read in conjunction with EN 1317-1. Both these standards support EN 1317-5. The modifications included in standard are not a change of test criteria, in the sense of the EN 1317-5:2007, ZA.3.
Road restraint systems - Part 2: Performance classes, impact test acceptance criteria and test methods for safety barriers including vehicle parapets
Intelligent Network Road Construction Specifications (General Rules)
Intelligent transportation system engineering inspection specification
本标准规定了锚下板式索力传感器的产品分类、结构型式和型号、技术要求、检验方法、检验规则,以及标志、包装、运输和储存及安装等要求。 本标准适用于桥梁平行钢丝拉索或吊杆、钢绞线拉索或吊杆的拉力测试。其它类型的拉索可参考使用。
Plate Load Cell Under Anchor
本文件规定了感应板测力支座的分类、结构型式、型号、技术要求、检验方法、检验规则及其标志、包装、运输和储存等要求。 本文件适用于设计竖向承载力小于等于100MN的感应板测力球型支座和设计竖向承载力小于等于80MN的感应板测力盆式支座的生产、检验和使用。
Induction Plate Type Force Measuring Bearing
总体要求 交通感知设施 路侧定位设施 交通控制及诱导设施 通信设施 路侧计算设施 供电充电设施
Engineering technical specification for roadside facilities of smart highway
Specifications for setting up expressway traffic signs
本标准适用于公路上LED车道控制标志的生产、检验和使用。
LED lane control signs
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号