95.020 标准查询与下载

ASTM D5746-98(2016) 国防基地关闭和调整设施的物业区域类型环境状况标准分类

1.1 Purpose—The purpose of this classification is to define seven standard environmental condition of property area types for Department of Defense (DoD) real property at a closing military installation with respect to the requirements of the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA) of 1980 Section 120(h), as amended by the Community Environmental Response Facilitation Act (CERFA) of 1992, and Section 331 of the National Defense Authorization Act for Fiscal Year 1997. As such, this classification is intended to permit a DoD component to classify property into seven area types, in order to facilitate and support findings of suitability to transfer (FOSTs), findings of suitability to lease (FOSLs), and uncontaminated parcel determinations pursuant to the requirements of CERFA. Users of this classification should note that it does not address (except where noted explicitly) requirements for appropriate and timely regulatory consultation or concurrence, or both, during the identification and use of these environmental condition of property area types. 1.1.1 Seven Recognized Standard Environmental Condition of Property Area Types—The goal of this classification is to permit DoD components to classify properties on closing DoD installations in order to support determinations of which properties are suitable and unsuitable for transfer by lease or by deed. The term “standard environmental condition of property area type” refers to one of the seven area types defined in this classification. An identification of an area type on an environmental condition of property map means that a DoD component has conducted sufficient studies to make a determination of the recognized environmental conditions of installation real property or has complied with the identification requirements of uncontaminated property under CERFA, or both, and has categorized the property into one of the following seven area types: 1.1.1.1 Standard Environmental Condition of Property Area Type 1—An area or parcel of real property where no release, or disposal of hazardous substances or petroleum products or their derivatives has occurred (including no migration of these substances from adjacent properties). 1.1.1.2 Standard Environmental Condition of Property Area Type 2—An area or parcel of real property where only the release or disposal of petroleum products or their derivatives has occurred. 1.1.1.3 Standard Environmental Condition of Property Area Type 3—An area or parcel of real property where release, disposal, or migration, or some combination thereof, of hazardous substances has occurred, but at concentrations that do not require a removal or remedial action. 1.1.1.4 Standard Environmental Condition of Property Area Type 4—An area or parcel of real property where release, disposal, or migration, or some combination thereof, of hazardous substances has occurred, and all remedial actions necessary to protect human health and the environment have been taken. 1.1.1.5 Standard Environmental Condition of Property Area Type 5—An area or parcel of real property where release, disposal, or migration, or some combination thereof, of hazardous substances has occurred and removal or remedial actions, or both, are under way, but all required actions have not yet been taken. 1.1.1.6 Standard Environmental Condition of Property Area Type 6—An area or parcel of real property where release, disposal, or migration, or some combination thereof, of hazardous substances has occurred, but required response actions have not yet been initiated. 1.1.1.7 Standard Environmental Condition of Property Area Type 7—An area or parcel of real property that is unevaluated or requires additional evaluation. 1.1.2 CERCLA Section 120(h) Requirements—This classification of environmental condition of property area types is consistent with CERCLA § 120(h) requirements relating to the transfer of contaminated federal real property (42 USC 9601 and following). Areas classified as Area Types 1 through 4, as defined in this classification, are suitable, with respect to CERCLA § 120(h) requirements, for deed transfer to a nonfederal recipient. 1 This classification is under the jurisdiction of ASTM Committee E50 on Environmental Assessment, Risk Management and Corrective Action and is the direct responsibility of Subcommittee E50.02 on Real Estate Assessment and Management. Current edition approved Dec. 1, 2016. Published December 2016. Originally approved in 1995. Last previous edition approved in 2010 D5746 98(2010). DOI: 10.1520/D5746-98R16. Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States 1 1.1.3 CERFA Requirements—This classification of environmental condition of property area types can be used in conjunction with the reporting requirements of CERFA, which amended CERCLA (Public Law 102-426, 106 Statute 2174). As defined in this classification, areas classified as Type 1 areas are eligible for reporting as “uncontaminated property” under the provisions of CERFA. At installations listed on the national priorities list, Environmental Protection Agency (EPA) concurrence must be obtained for a parcel to be considered uncontaminated and therefore transferable under CERCLA § 120(h)(4). EPA has stated as a matter of policy that there may be instances in which it would be appropriate to concur with the military service that certain parcels can be identified as uncontaminated under CERCLA § 120(h)(4), although some limited quantity of hazardous substances or petroleum products have been stored, released, or disposed of on the parcel. If the information available indicates that the storage, release, or disposal was associated with activities that would not be expected to pose a threat to human health or the environment (for example, housing areas, petroleum-stained pavement areas, and areas having undergone routine application of pesticides), such parcels should be eligible for expeditious reuse. 1.1.4 Petroleum Products—Petroleum products and their derivatives are included within the scope of this classification. Under DoD policy, areas on which petroleum products and their derivatives have been released or disposed of may not be suitable for deed transfer until a response action has been completed. 1.2 Objectives—The objectives guiding the development of this classification are as follows: (1) to synthesize and put in writing a standard classification of environmental condition of property area types; (2) to facilitate the development of high-quality, standardized environmental condition of property maps that can be used to support FOSTs and FOSLs; (3) to facilitate the development of a standard practice for conducting environmental baseline surveys; and (4) to facilitate the development of a standard guide for preparing environmental baseline survey reports.

Standard Classification of Environmental Condition of Property Area Types for Defense Base Closure and Realignment Facilities

GA 1308-2016 2010式38毫米警用子母式发烟型训练弹

2010-style 38mm police sub-mother type smoke training ammunition

GA 1304-2016 2008式38毫米警用发烟型催泪弹

2008 type 38mm police smoke tear gas bomb

GA 1307-2016 2010式38毫米警用痛球弹

2010 style 38mm police pain ball

GA 1309-2016 1997式38毫米警用枪发手投两用发烟型催泪弹

1997-style 38mm police gun fires dual-purpose smoke-type tear gas bombs

GA 1305-2016 2008式38毫米警用催泪训练弹

2008 Type 38mm Police Tear Gas Training Ammunition

GA 1303-2016 2008式38毫米警用子母式发烟型催泪弹

2008-style 38mm police tear gas bomb

GA 1306-2016 2010式38毫米警用爆震弹

2010 type 38mm police detonation bomb

BS CWA 17008:2016 人道主义排雷文化指南

Cultural guidelines for humanitarian demining

ASTM F2654-16 软气枪警告的标准规格

1.1 This specification covers airsoft guns, air soft guns, or soft air guns, or any combination thereof, which propel a low energy air gun projectile, as defined in 3.1.2 and meeting the requirements in Specification F2748. These devices are also known as low energy air guns (LEAG). 1.2 Limitations—This specification does not cover the following categories of gun products: Products covered by Specifications F589 (non-powder guns), F2272 (paintball markers), F2573 (toy products), and F2574 (non-recreational guns such as those used by law enforcement, scientific, or military agencies). 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Airsoft Gun Warnings

AQAP-2070-2015 北约共同政府质量保证（GQA）

NATO mutual government quality assurance (GQA)

ASTM F2679-15e1 气枪使用的6 mm弹丸的标准规格

1.1 This specification establishes requirements and characteristics of airsoft gun projectiles which help define whether an airsoft gun is suitable for use in the sport commonly called airsoft, air soft, or soft air. Furthermore, the specification establishes minimum warning and package labeling to help ensure that the low energy airgun projectiles are used in a safe manner and that the risk of injury is reduced. 1.2 Limitations—This specification does not cover the following categories of projectiles: Projectiles covered by Consumer Safety Specification F590 (non-powder guns projectiles), Specification F1979 (paintballs), Specification F2573, and Specification F2574; liquid filled or metallic projectiles, toy products, and non-recreational projectiles such as those used by law enforcement, scientific, or military agencies. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for 6 mm Projectiles Used with Airsoft Guns

ASTM F2654-15 气枪警告的标准规格

1.1 This specification covers airsoft guns, air soft guns, or soft air guns, or any combination thereof, which propel a low energy air gun projectile, as defined in 3.1.2 and meeting the requirements in Specification F2748. These devices are also known as low energy air guns (LEAG). 1.2 Limitations—This specification does not cover the following categories of gun products: Products covered by Specifications F589 (non-powder guns), F2272 (paintball markers), F2573 (toy products), and F2574 (non-recreational guns such as those used by law enforcement, scientific, or military agencies). 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Airsoft Gun Warnings

GOST R 56134-2014 出口军事产品的售后支持. 通用原则

Exporting military products after-sales support. General principles

GOST R 56135-2014 军工产品的生命周期管理. 通用规定

Life cycle management for military products. General provisions

GOST R 56132-2014 军工产品出口用集成物流支持. 飞行器操作和维护期间的数据命名和收集格式

Integrated logistic support of exporting military products. Data nomenclature and format to collect during aircraft operation and maintenance

GOST R 56113-2014 军工产品出口用集成物流支持. 供应支持计划. 通用规定

Integrated logistic support of exporting military products. Supply support planning. General provisions

GOST R 56131-2014 军工产品出口用集成物流支持. 军工产品生命周期期间的集成物流支持

Integrated logistic support of exporting military products. Integrated logistic support during military product life cycle

GOST R 56114-2014 军工产品出口用集成物流支持. 军工产品出口用物流支持分析要求

Integrated logistic support of exporting military products. Requirements to logistic support analysis for exporting military product

GOST R 56111-2014 军工产品出口用集成物流支持. 技术操作能力指数的命名

Integrated logistic support for exporting military products. Nomenclature of the technical operating capabilities indices