A55 电磁计量 标准查询与下载

ANSI/IEEE 1650:2005 测量碳纳米管的电特性的标准试验方法

Recommended methods and standardized reporting practices for electrical characterization of carbon nanotubes are covered.

Standard Test Methods for Measurement of Electrical Properties of Carbon Nanotubes

JJG 521-2006 环境监测用X、γ辐射空气比释动能（吸收计量）率仪

本规程适用于监测环境X、γ辐射空气比释动能（吸收计量）率验的便携式、移动式或固定式仪器（以下简称空气比释动能率仪）的首次检定、后续检定和使用中检定。 X、γ辐射的空气比释动能率范围是30nGy/h～10μGy/h,辐射能量范围为50keV～1.5MeV（对可能用于测量核反应堆周围的高能光子的仪器，其辐射能量范围还包括6MeV的光子能量检定点）。对使用电离电流、计数率或其他量的积分方法来测定并显示一定时间内的平均空气比释动能率的仪器，本规程同样适用。 本规程不适用于测定环境X、γ辐射空气比释动能（积累量）仪器的检定；也不适用于热释光剂量计或其他无源测量装置以及β辐射仪器的检定。

X and Gamma Radiation Air Kerma Ratemeters for Environmental Monitoring

JJG 593-2006 个人与环境监测用X、γ辐射热释光剂量测量（装置）系统

本规程适用于个人监测用和环境监测用X、γ辐射热释光剂量测量（装置）系统（以下简称系统）的首次检定、后续检定和使用中检验。光子能量范围为15keV～3.0MeV。 本规程不适用于个人监测和环境监测用X、γ辐射热释光剂量计的单独检定。 本规程不适用于配用肢端计量剂的用于个人监测的装置，也不适用于测量β辐射、中子辐射和宇宙射线辐射装置的检定。

Thermoluminescence Dosimetry Systems Used in Personal and Environmental Monitoring for X and Gamma Radiation

JJG 1009-2006 直读式X、γ辐射个人剂量当量（率）监测仪

本规程适用于佩戴在人体躯干上的用来测量由X和γ辐射外照射而产生于佩戴者的个人剂量当量（亦可兼有个人剂量当量率测量功能）的直读式监测仪（以下简称监测仪）的首次鉴定、后续检定和使用中检验，该类监测仪属于X辐射防护仪器和γ辐射防护仪器的一种。 X、γ辐射的能量范围为50keV～1.5MeV,如果该监测仪器准备用于测量由能量最高可达10MeV的光子产生的剂量当量（率），比如在核反应堆会有6MeV的光子辐射存在，那么必须在适当的能量上确定其响应。 本规程不适用于测量弱贯穿辐射个人剂量当量（率）的监测仪的检定。 本规程不适用于诸多胶片剂量计、热释光剂量计或石英丝静电计等无源测量装置的检定。

Direct reading Personal dose equivalent (rate) Monitors for X and Gamma Radiation

DL/T 988-2005 高压交流架空送电线路、变电站工频电场和磁场测量方法

本标准规定了高压交流架空送电线路、变电站工频电场和磁场的测量方法。 　　本标准适用于所有电压等级的交流高压架空送电线路和变电站。

Methods of measurement of power frequency electric field and magnetic field from high voltage overhead power transmission line and substation

SANS 5385:2005 经过处理的编织织物的单位面积重量

Specifies a method for the determination of the mass per unit area of conditioned knitted textiles.

Mass per unit area of conditioned knitted textiles

JJG 1005-2005 电子式绝缘电阻表

本规程适用于测量范围不大于500GΩ，额定电压10kV以下的电子式绝缘电阻表的首次检定、后续检定和使用中的检验。

Electronic Insulating Resistance Meters

JJG 124-2005 电流表、电压表、功率表及电阻表

本规程适用于直接作用模拟指示直流和交流(频率40Hz～1OkHz)电流表、电压表、功率表和电阻表(电阻1Ω～1MΩ)以及测量电流、电压及电阻的万用表(以下均简称仪表)的首次检定、后续检定和使用中的检验。 本规程不适用于自动记录式仪表、数字式仪表、电子式仪表、平均值电压表、峰值电压表、泄漏电流表、三相功率表及电压高于600V的静电电压表的检定。

Amperemeters, Voltmeters, Wattmeters and Ohmmeters

IEC PAS 62431:2005 电磁波吸收仪在毫米波频上的反射性的测量方法

This PAS specifies the measurement methods for the reflectivity of electromagnetic wave absorbers (EMA) for the normal incident, oblique incident and each polarized wave in the frequency range from 30 GHz to 300 GHz. In addition, these methods are also equally effective for the reflectivity measurement of other materials. This PAS is applicable not only to those EMA which are widely used as the counter-measures against communication faults, radio interference etc., but also to those used in an anechoic chamber in some cases. EMAs may be any kind of material and may have any arbitrary shape, configuration, or layered structure as indicated below. Material: Conductive material, dielectric material, magnetic material Shape: Planar, pyramidal-type, wedge-type, etc. Layer structure: Single layer, multi layers, and graded-index material This PAS may give the measurement method of reflectivity applicable to various EMAs or materials. However, it may not be applicable to all EMAs. This PAS may be supplemented with additional methods if necessary so that a future demand may be fulfilled. The PAS specifies the measurement methods for the reflectivity of EMA in the millimetre-wave range: - measurement frequency range: 30 GHz to 300 GHz - reflectivity: 0 to -50 dB - incident angle: 0° to 80°.

Measurement methods for reflectivity of electromagnetic wave absorbers in millimetre wave frequency

JJF 1131-2005 TDMA-GSM数字移动通信综合测试仪校准规范

本校准规范规定了GSM数字移动通信综合测试仪的校准项目、条件及结果处理，适用于GSM数字移动通信综合测试仪的校准(TDMA：Time Division Multiple Access，时分多址；GSM：Global System for Mobile Communications，全球移动通信系统)。

Calibration Specification for TDMA - GSM Radio Communication Testers

JJG 387-2005 同轴电阻式衰减器

本规程适用于同轴电阻式衰减器的首次检定、后续检定和使用中的检验。

Coaxial Attenuator

DD 8431-2005 二次计量和分计量用静电计规范

This Draft for Development specifies requirements for newly manufactured electronic secondary meters or sub-meters which measure either electrical energies alone or electrical energies together with other electrical parameters associated with the energy. It applies to meters that measure active energy, apparent energy, reactive energy (capacitive, inductive and/or total), and ampere squared hours (A2h) and to the measurement of current, voltage, active power, apparent power, reactive power (capacitive, inductive and/or total), power factor, phase angle and frequency when measured in addition to an energy. It applies to all secondary and sub-meters for indoor and outdoor applications, both portable and permanently installed, for all power frequencies including d.c. It also applies to all registers, indicators, displays and outputs, and to the operation of test outputs. It does not apply to primary meters, to data interfaces to the meter, or to load survey analysers or load survey meters. The reliability aspect is not covered in this draft. NOTE 1 Primary meters are covered by BS EN 62052 and BS EN 62053. NOTE 2 Load survey analysers are instruments that might measure some or all of the parameters and estimate one or more energies but do not conform to the requirements of a meter as defined in this draft and other standards. Where the display and/or the memory is external or where other elements are enclosed in the meter case (such as maximum demand indicators, telemetering, time switches or remote control, etc.) this draft applies only to the section of the meter concerned with measurement.

Electrical static meters for secondary metering and sub-metering-Specification

JJG 48-2004 硅单晶电阻率标准样片

Standard Slice of Single Crystal Silicon Resistivity

JJF 1127-2004 射频阻抗/材料分析仪校准规范

Calibration Specification for RF Impedance/Material Analyzers

JJG 125-2004 直流电桥

D.C. Bridges

JJG 508-2004 四探针电阻率测试仪

Resistivity Measuring Instruments with Four - Probe Array Method

JJG 502-2004 合成信号发生器

Synthesized Signal Generators

DIN EN 60375:2004 有关电路和磁路的规定

Conventions concerning electric and magnetic circuits (IEC 60375:2003); German version EN 60375:2003

DIN V 42331:2004 脉冲磁场的技术报告

The present Technical Report reviews methods for measuring magnetically hard materials using pulsed field magnetometers.The methods of measurement of the magnetic properties of magnetically hard materials have been specified in IEC 60404-5 for closed magnetic circuits and in IEC 60404-7 for open magnetic circuits. The measurement of the magnetic properties of magnetically hard materials at elevated temperatures is given in Technical Report IEC TR 61807.

Technical Report on Pulsed Field Magnetometry (IEC 62331:2003)

JJG 984-2004 接地导通电阻测试仪

Earth-Continuity Testers