D50 非金属矿综合 标准查询与下载

KS E 3006-2008 矿石的锌量测定方法

이 표준은 광석의 아연 정량 방법에 대하여 규정한다.KS E 3006:2008비

Methods for determination of zinc in ores

JC/T 1081-2008 装饰石材露天矿山技术规范

本规范规定了装饰石材露天矿山矿床地质勘查、矿山设计、矿山建设和生产的要求。 本规范适用于装饰用途的花岗石、大理石、板石以及砂岩类天然石材露天矿山。

Technical specification for quarry of decorative stone

KS E 3068-2007 矿石的钴量测定方法

이 규격은 광석의 코발트 정량 방법에 대하여 규정한다.

Determination of cobalt in ores

KS E 3809-2007 造纸用黏土试验方法

이 규격은 제지용(충전제ㆍ도공용)에 사용하는 납석 점토(이하 적토라고 한다.)의 시험방법에

Testing methods of filler and coating clay for paper

NF B10-622:2007 天然石的试验方法.岩相检验

Natural stone test methods - Petrographic examination.

DIN 52100-2:2007 天然石料.岩石相检验法.总则和概述

Natural stone - Petrographic examinations - General and summary

DIN EN 12407:2007 天然石头试验方法.岩相学检验

This European Standard specifies methods for making technical petrographic descriptions of natural stone,except for roofing slates.For this product,the method for the petrographic examination is defined in EN 12326-2.Although chemical and physical methods of analysis are required for petrographic classification of some stone types, these methods will not be described in this standard.

Natural stone test methods - Petrographic examination English version of DIN EN 12407:2007-06

BS EN 12407:2007 天然石试验方法.岩石检验

This European Standard specifies methods for making technical petrographic descriptions of natural stone, except for roofing slates. For this product, the method for the petrographic examination is defined in EN 12326 –2. Although chemical and physical methods of analysis are required for petrographic classification of some stone types, these methods will not be described in this standard.

Natural stone test methods - Petrographic examination

NF B10-621:2007 天然石料试验方法.集中负荷抗弯强度测定

Natural stone test methods - Determination of flexural strength under concentrated load.

NF B10-615*NF EN 1936:2007 天然石料试验方法.实密度、表观密度、总孔隙率和开放孔隙率的测定

Natural stone test method - Determination of real density and apparent density, and of total and open porosity.

YB/T 5268-2007 硅石

本标准规定了硅石的分类与牌号、技术要求、试验方法、检验规则、包装、标志、运输、贮存和质量证明书。 本标准适用于耐火材料、铁合金和工业硅用硅石。

Silica

ASTM D5731-07 岩石点负荷强度指数的测定以便用于岩石强度分类的标准试验方法

1.1 This test method covers the guidelines, requirements, and procedures for determining the point load strength index of rock. This is an index test and is intended to be used to classify rock strength.1.2 Specimens in the form of rock cores, blocks, or irregular lumps with a test diameter from 30 to 85 mm can be tested by this test method.1.3 This test method can be performed in either the field or laboratory. The test is typically used in the field because the testing machine is portable, little or minimal specimen preparation is required, and specimens can be tested within a short time frame of being collected.1.4 This test method applies to medium strength rock (compressive strength over 15 MPa (2200 psi)).1.5 This test method does not cover which type of specimen should be tested or whether anisotropic factors should be considered. The specifics of the point load test program need to be developed prior to testing and possibly even before sampling. Such specifics would be dependent on the intended use of the data, as well as possible budgetary constraints and possible other factors, which are outside the scope of this test method.1.6 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.1.7 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.1.8 The values stated in the SI units are to be regarded as standard.1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Determination of the Point Load Strength Index of Rock and Application to Rock Strength Classifications

KS E 3906-2006 炼铜用碎铜及废铜采样方法及含水量测定方法

이 규격은 동제련용 동스크랩(1)의 로트에 대하여 그 동분 및 수분의 평균값(이하 평균 품

Copper scraps for smelting-Methods for sampling, sample preparation and determination of moisture content

KS E 3070-2006 矿石的铋量测定方法

이 규격은 광석의 비스무트 분석방법에 대하여 규정한다. 다만, 기타 한국산업규격에서 비스

Methods for determination of bismuth in ores

KS E 3001-2006 矿石的铜量测定方法

이 규격은 광석의 구리 정량 방법에 대하여 규정한다. 다만, 기타 한국산업규격에서 구리 분

Methods for determination of copper in ores

ASTM G113-06 与非金属材料自然和人工风化试验相关的标准术语

1.1 This terminology standard covers terms that relate to the durability testing of Nonmetallic Materials using natural and artificial weathering exposure techniques.1.2 It is the intent of this terminology standard to include those weathering terms in wide use in ASTM for which standard definitions appear desirable.

Standard Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Materials

KS E 3907-2005 非铁浮选精矿采样方法

이 규격은 부선 정광(동정광, 납정광, 아연 정광, 니켈 정광 등)에 대한 로트의 성분,

Methods for sampling of non-ferrous flotation concentrates in bulk

QB/T 2757-2005 无汞碱性锌-二氧化锰电池用石墨

本标准规定了无汞碱性锌-二氧化锰电池用石墨(以下简称“石墨”)的要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于无汞碱性锌-二氧化锰电池用石墨的生产、检测和验收。

Graphite for mercury-free alkaline zinc-manganese dioxide battery

KS E 3019-2004 铁矿石的氧化钙量测定方法

이 규격은 철광석 중의 산화칼슘 분석 방법에 대하여 규정한다.비 고 이 규격은 다

Methods for determination of calcium oxide in iron ores

KS E 3012-2001 铁矿石的吸附水量测定方法

이 규격은 철광석 중의 화합수 분석 방법에 대하여 규정한다.

Method for determination of combined water in iron ores