E10 石油勘探、开发与集输工程综合 标准查询与下载

ASTM D6285-99 定位废弃井的标准指南

1.1 This guide provides an approach to selecting and implementing a program to identify the locations of abandoned wells. This guide provides descriptions of methods to be used as starting points in the search for these locations. It is not intended to be a step-by-step procedure to conduct the search program. This guide also provides listings of government agencies that may have well location information. It is understood that addresses and phone numbers change and that the included information may not be accurate in the future. 1.2 The described methods are approaches that have been used at many sites across the United States. Other methods may be appropriate. Typically, several approaches are used to obtain acceptable confirmation of well locations. This guide is not limited to specific wells. The method chosen should be appropriate for the size of the area being searched and the type of well being located. Some well types and construction materials may preclude their detection by any of the methods described. 1.3 This guide offers an organized collection of information or series of options and does not recommend a specific course of action. This guide cannot replace education and experience and should be used in conjunction with professional judgement.

Standard Guide for Locating Abandoned Wells

SY/T 6313.1-1998 油气水界面确定方法.油气、油水界面

本标准规定了以构造因素控制为主的油藏不同类型储层原始油气、油水界面确定的内容、方法和要求。 本标准适用于以构造因素控制为主的油藏不同类型储层原始油气、油水界面的确定。

The method of determining the oil-gas-water contact.The oil-gas and oil-water contact

SY/T 6313.2-1998 油气水界面确定方法.气水界面

本标准规定了天然气藏气水界面确定的方法和要求。 本标准适用于具有同一水动力学系统的各种圈闭类型的气藏。

The method of determining the oil-gas-water contact.The gas-water contact

SY/T 6339-1998 油气相对渗透率测定.非稳态法

本标准规定了非稳态恒压法测定油气相对渗透率的方法和要求。 本标准适用于砂岩储层岩样空气渗透率大于5×10^(-3)μm^(2)的油气相对渗透测定。

Unsteady-state oil-gas relative permeability measurement

ASTM E1943-98(2010) 在石油开采现场通过自然衰减度地下水补救的标准指南

The approach presented in this guide is a practical and streamlined process for determining the appropriateness of remediation by natural attenuation and implementing remediation by natural attenuation at a given petroleum release site. This information can be used to evaluate remediation by natural attenuation along with other remedial options for each site. In general, remediation by natural attenuation may be used in the following instances: As the sole remedial action at sites where immediate threats to human health, safety and the environment do not exist or have been mitigated, and constituents of concern are unlikely to impact a receptor; As a subsequent phase of remediation after another remedial action has sufficiently reduced concentrations/mass in the source area so that plume impacts on receptors are unlikely; or As a part of a multi-component remediation plan. This guide is intended to be used by environmental consultants, industry, and state and federal regulators involved in response actions at petroleum release sites. Activities described in this guide should be performed by a person appropriately trained to conduct the corrective action process. The implementation of remediation by natural attenuation requires that the user exercise the same care and professional judgement as with any other remedial alternative by: Ensuring that site characterization activities focus on collecting information required to evaluate and implement remediation by natural attenuation; Evaluating information to understand natural attenuation processes present at the site; Determining whether remediation by natural attenuation is the most appropriate and cost-effective remedial alternative with a reasonable probability of achieving remedial goals; and Monitoring remedial progress. Application and implementation of remediation by natural attenuation is intended to be compatible with Guide E1739 or other risk-based corrective action programs. This guide does not address specific technical details of remediation by natural attenuation implementation such as site characterization (see Guide E1912), sampling, data interpretation, or quantifying rates. For additional discussion and guidance concerning these technical issues for remediation by natural attenuation see Appendix X1 through Appendix X7. This guide does not specifically address considerations and concerns associated with natural attenuation of non-petroleum constituents, such as chlorinated solvents. Care must be taken to ensure that degradation by-products will not cause harm to human health or the environment. In addition, if constituents are present which do not readily attenuate, such as methyl-t-butyl ether (MTBE), remediation by natural attenuation may not be a suitable remedial alternative or may need to be supplemented with other remedial technologies. This guide is intended to be consistent with Guide E1599 and U.S. EPA guidance for implementation of remediation by natural attenuation (U.S. EPA, 1995, Chapter 9). 1.1 This is a guide for determining the appropriateness of remediation by natural attenuation and implementing remediation by natural attenuation at a given petroleum release site, either as a stand alone remedial action or in combination with other remedial actions. 1.2 Natural attenuation is a potential remediation alternative for containment and reduction of the mass and concentration of petroleum hydrocarbons in the environment to protect human health and the environment. Remediation by natural attenuation depends upon natural processes such as biode......

Standard Guide for Remediation of Ground Water by Natural Attenuation at Petroleum Release Sites

SY/T 5363-1997 含油气层系划分

本标准规定了见油气显示岩层在垂向上的分级、定义、划分原则和方法。 本标准适用于油气勘探阶段对盆地内见油气显示岩层的划分。

The division of hydrocatbon bearing sequence

SY/T 6336-1997 沉积岩重矿物分离与鉴定方法

本标准规定了重矿物分离与鉴定方法。 本标准适用于石油天然气地质行业沉积岩重矿物的分离与鉴定。

The method of separation and examination of heavly minarals for sedimentary rock

SY/T 5120-1997 岩石氯仿抽提物及原油中饱和烃气相色谱分析方法

本标准规定了饱和烃气相色谱分析方法中的样品制备， 测定步骤， 定性、定量计算和质量要求等。 本标准适用于岩石氯仿抽提物及原油中饱和烃的正构烷烃、姥鲛烷、植烷等的测定。

Analytical method of gas chromatography on saturated hydrocarbons of rock chloroform extract and crude oil

SY/T 6316-1997 稠油油藏流体物性分析方法.原油粘度测定

本标准规定了稠油油藏原油粘度的测定方法及技术要求。其他旋转粘度计测定方法及要求可参照执行。 本标准适用于使用RV20旋转粘度计测定粘度在10mPa·s至10^（5）mPa·s范围内地面脱气原油。

Analytical approach of fluid physical property for heavy-oil reservoirs.Crude oil viscosity measurements

SY/T 6312-1997 砂岩粒度和孔隙特征的测定图象分析方法

本标准规定了砂岩薄片粒度和铸体薄片孔隙特征的图象分析方法。 本标准适用于砂岩岩样，其他岩样可参照执行。

Measurement of sandstone grain size and pore character -Method of image analysis

SY/T 6315-1997 稠油油藏驱油效率的测定

本标准规定了稠油油藏驱油效率测定方法及技术要求。 本标准适用于稠油油藏热水驱及蒸汽驱条件下的驱油效率测定。

Displacement efficiency measurement method for heavy-oil reservoirs

SY/T 6314-1997 沉积相描述方法.陆相部分

本标准规定了油气田开发阶段陆相碎屑岩储层沉积相描述方法。 本标准适用于油气田开发阶段陆相碎屑岩储层沉积相描述。

Methodology for sedimentary facies discription.Nonmarine facies

SY/T 6337-1997 油气井地层测试资料录取规范

本标准规定了油气井地层测试资料录取的项目和要求。 本标准适用于油气井地层测试资料的录取。

The standard of well testing data acquisition

SY/T 6338-1997 岩石可溶有机物和原油族组分棒薄层火焰离子化分析方法

本标准规定了岩石可溶有机物和原油族组分棒薄层火焰离子化分析方法。 本标准适用于各类生油岩、储集岩及原油的族组分分析，不适用于凝析油的族组分分析。

Analysis of family composition of rock extract and crude oil by tlc-fid

SY/T 6311-1997 蒸汽驱油三维比例物理模拟实验技术要求

本标准规定了蒸汽驱油三维比例物理模拟实验方法及技术要求。 本标准适用于蒸汽驱油三维高压比例物理模型、低压比例物理模型及真空比例物理模型的模拟实验。

The technical requirements of steamflooding three-dimensional scaled physical modelling experiment

SY/T 6310-1997 天然气田开发概念设计编制技术要求

本标准规定了大、中型天然气田开发概念设计编制的内容、方法及技术要求。 本标准适用于不同类型天然气田(藏)在天然气田(藏)发现后至申报控制储量前后进行天然气田开发概念设计的编制。大、中型凝析气田开发概念设计基本按此标准。但应根据其特点增加相态研究及合理开采天然气和凝析油的技术要求。复杂类型天然气田可根据自身特点要求增减内容。

Regulation for conceptual development design in gas field

SY/T 0599-1997 天然气地面设施抗硫化物应力开裂金属材料要求

本标准规定了含硫化氢油气田地面设施用金属材料抗硫化物应力开裂的要求。 本标准适用于与含硫化氢介质接触的地面设施。如井场、集气站、净化厂的工艺设备和采集气管线等。

Sulfide stress cracking resistant metallic material requirements for gas surface equipment

SY/T 5843-1997 气水相对渗透率测定

本标准规定了测定气水相对渗透率的基本原理、测定方法、资料处理和报告格式。 本标准包括稳态法和非稳态法两种测定方法。稳态法适用于测定渗透率范围为(0.500～1000)×10^(-3)μm^(2)的圆柱状岩样的气水相对渗透率；非稳态法适用于测定渗透率大于0.0100×10^(-3)μm^(2)的圆柱状岩样的气水相对渗透率。

Gas-water relative permeability measurement

SY/T 5162-1997 岩石样品扫描电子显微镜分析方法

本标准规定了扫描电子显微镜用于分析岩石样品的方法和技术要求。 本标准适用于碎屑岩、碳酸盐岩、火成岩等岩石样品的扫描电子显微镜分析。其他岩石样品的分析亦可参照执行。

Analytical method of rock sample by scanning electron microscope

SY/T 5483-1997 常规地层测试技术规程

本标准规定了常规地层测试技术规程。 本标准适用于常规钻杆测试和电缆地面直读测试。

Technology criteria for conventional drill stem testing