E33 溶剂油 标准查询与下载

JIS K 2243:1993 空气过滤器油

この規格は，ビルディング，工場などに設置するエアフィルタに用いられるエアフィルタ油(以下，フィルタ油という。)について規定する。

Air filter oil

SH/T 0118-1992 溶剂油芳香烃含量测定法

Determination of aromatic hydrocarbon content in solvent oil

SH/T 0245-1992 溶剂油芳烃含量测定法（色谱法）

Solvent oil aromatics content determination method (chromatographic method)

SH/T 0243-1992 溶剂汽油碘值测定法

Solvent gasoline iodine value determination method

ASTM D3827-92(2012) 估算石油和其他有机溶剂中气体溶解度的标准试验方法

Knowledge of gas solubility is of extreme importance in the lubrication of gas compressors. It is believed to be a substantial factor in boundary lubrication, where the sudden release of dissolved gas may cause cavitation erosion, or even collapse of the fluid film. In hydraulic and seal oils, gas dissolved at high pressure can cause excessive foaming on release of the pressure. In aviation oils and fuels, the difference in pressure between take-off and cruise altitude can cause foaming in storage vessels and interrupt flow to pumps. 1.1 This test method covers a procedure for estimating the equilibrium solubility of several common gases in petroleum and synthetic lubricants, fuels, and solvents, at temperatures between 0 and 488 K. 1.2 This test method is limited to systems in which polarity and hydrogen bonding are not strong enough to cause serious deviations from regularity. Specifically excluded are such gases as HCl, NH3, and SO2, and hydroxy liquids such as alcohols, glycols, and water. Estimating the solubility of CO2 in nonhydrocarbons is also specifically excluded. 1.3 Highly aromatic oils such as diphenoxy phenylene ethers violate the stated accuracy above 363 K, at which point the estimate for nitrogen solubility is 43 % higher than the observation. 1.4 Lubricants are given preference in this test method to the extent that certain empirical factors were adjusted to the lubricant data. Estimates for distillate fuels are made from the lubricant estimates by a further set of empirical factors, and are less accurate. Estimates for halogenated solvents are made as if they were hydrocarbons, and are the least accurate of the three. 1.5 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Estimation of Solubility of Gases in Petroleum and Other Organic Liquids

SH 0005-1990 油漆工业用溶剂油

Solvent oil for paint industry

SH 0004-1990 橡胶工业用溶剂油

Solvent oil for rubber industry

STAS 7897-1991 眼镜片．术语

Prezentul standard stabile?te termenii principali referitori la lentile de ochelari, denumite ?n continuare, prescurtat, lentile. Terminologia din prezentul standard nu este limitativ?.

Spectacle lenses. Terminology

BS 245:1976 涂料和其它用途用矿物溶剂(石油溶剂及有关烃类溶剂)规范

Types A and B solvents based on two ranges of aromatic content. Methods for colour and viscosity reduction power are appended and other BS methods referred to.

Specification for mineral solvents (white spirit and related hydrocarbon solvents) for paints and other purposes