E49 其他石油产品 标准查询与下载
共找到 64 条与 其他石油产品 相关的标准，共 5 页
Refrigerated hydrocarbon and nonpetroleum based liquefied gaseous fuels. Dimethylether (DME). Measurement and calculation on board ships
- ICS
- 75.180.30
- CCS
- E49
- 发布
- 2012-11-30
- 实施
- 2012-11-30
이 표준은 KS M ISO 12922(참고문헌 [4] 참조)와 KS M ISO 15380(
Petroleum and related products－Determination of the ageing behavior of inhibited oils and fluids using TOST test－Part 3：Anhydrous procedure for synthetic hydraulic fluids
- ICS
- 75.120
- CCS
- E49
- 发布
- 2012-10-12
- 实施
- 2012-10-12
이 표준은 KS M ISO 6743-4에서 분류하는 HFD 비수용성 유압유의 부식 성능을
Petroleum and related products－Determination of the corrosion resistance of fire-resistant hydraulic fluids－Part 2：Non-aqueous fluids
- ICS
- 75.120
- CCS
- E49
- 发布
- 2012-10-12
- 实施
- 2012-10-12
本标准规定了轻负荷和重负荷发动机冷却系统用乙二醇型和丙二醇型冷却液及其浓缩液的术语和定义、产品分类和技术要求、检验规则及包装、标志、运输和贮存。 本标准所属产品适用于轻负荷或重负荷内燃发动机冷却系统。
Ethylene glycol and propylene glycol base engine coolants
- ICS
- 75.100
- CCS
- E49
- 发布
- 2011-01-09
- 实施
- 2011-05-01
1．1 本标准规定了用电感耦合等离子体原子发射光谱(ICP—AES)仪测定发动机冷却液中的硅含量的方法。本标准适用于测定硅含量不低于5mg／L的发动机冷却液。本标准也可以用来测定发动机冷却液中其他元素的含量。本标准适用于溶解或者分散于冷却液中的元素含量测定。 1．2本标准适用于未使用过的发动机冷却液和用过的发动机冷却液。 1．3本标准采用国际单位制(SI)单位。 1．4本标准涉及某些与标准使用有关的安全问题，但并未对此有关的所有安全问题都提出建议。因此，用户在使用本标准之前有必要建立适当的安全和防护措施，并确定相应的管理制度。
Standard test method for determination of silicon and other elements in engine coolant by inductively coupled plasma-atomic emission spectroscopy
- ICS
- 75.080
- CCS
- E49
- 发布
- 2010-05-01
- 实施
- 2010-10-01
This test method provides for the qualitative and quantitative determination of denatonium ion in engine coolant in milligrams per liter to low percent range and requires approximately 100 mL per test, with results available in less than 30 min. Acceptable levels of denatonium vary with manufacturer’s blending specifications and applicable minimum or maximum industry and state specifications. Typically specification ranges from 30 to 50 ppm denatonium ion.1.1 This test method covers the chemical analysis of engine coolant for denatonium ion by high-performance liquid chromatography (HPLC).1.2 This test method is applicable to both new and used coolants. 1.3 Coelution of other ions may cause interferences in the detection of the denatonium cation. In the case of unfamiliar formulations, identification verification should be performed by either or both fortification and dilution of the sample matrix with denatonium ion..1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Denatonium Ion in Engine Coolant by HPLC
- ICS
- 71.100.45 (Refrigerants and antifreezes)
- CCS
- E49
- 发布
- 2006
- 实施
1.1 This practice covers the conversion tables and equations for converting kinematic viscosity in centistokes (cSt) at any temperature to Saybolt Universal viscosity in Saybolt Universal seconds (SUS) at the same temperature and for converting kinematic viscosity in centistokes at 122 and 210176F to Saybolt Furol viscosity in Saybolt Furol seconds (SFS) at the same temperatures. Kinematic viscosity values are based on water being 1.0038 mm2/s (cSt) at 68176F (20176C). Note 1-A fundamental and preferred method for measuring kinematic viscosity is by use of kinematic viscometers as outlined in Test Method D445, It is recommended that kinematic viscosity be reported in centistokes, instead of Saybolt Universal Seconds (SUS) or Saybolt Furol Seconds (SFS). Thus this method is being retained for the purpose of calculation of kinematic viscosities from SUS and SFS data which appear in past literature. One centistokes equals one millimetre squared per second (mm2/s). 1.2 The SI unit of kinematic viscosity, mm2/s, and temperature in degrees Fahrenheit are the standard in this practice.
Standard Practice for Conversion of Kinematic Viscosity to Saybolt Universal Viscosity or to Saybolt Furol Viscosity
- ICS
- 17.060 (Measurement of volume, mass, density, visc
- CCS
- E49
- 发布
- 2004
- 实施
Standard test method for detailed analysis of petroleum naphthas through n-nonane by capillary gas chromatography
- ICS
- 75.160.20
- CCS
- E49
- 发布
- 2002-05-31
- 实施
- 2002-07-01
Determination of DIRAC POWER in Gasoline
- ICS
- 75.140
- CCS
- E49
- 发布
- 2002-04-22
- 实施
- 2002-06-18
1.1 This test method is used to evaluate the ability of inhibited mineral oils, particularly steam-turbine oils, to aid in preventing the rusting of ferrous parts should water become mixed with the oil. This test method is also used for testing other oils, such as hydraulic oils and circulating oils. Provision is made in the procedure for testing heavier-than-water fluids.Note 18212;For synthetic fluids, such as phosphate ester types, the plastic holder and beaker cover should be made of a chemically resistant material, such as polytetrafluoroethylene (PTFE).1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 6.4-6.6.
Standard Test Method for Rust-Preventing Characteristics of Inhibited Mineral Oil in the Presence of Water
- ICS
- 75.080 (Petroleum products in general)
- CCS
- E49
- 发布
- 2002
- 实施
Detemination of FSA-JDQ1 in Gasoline
- ICS
- 75.140
- CCS
- E49
- 发布
- 2000-08-29
- 实施
- 2000-09-15
Standard test method for use of the refractometer for field test determination of the freezing point of aqueous engine coolants
- ICS
- CCS
- E49
- 发布
- 1999-12-08
- 实施
- 2000-05-01
Absorbent Material for Oils, Liquid Fuels and Water
Absorbant D'Huiles, De Combustibles Liquides Et D'Eau
- ICS
- CCS
- E49
- 发布
- 1996-07-01
- 实施
Determination of pH value of water extract from industrial ethylbenzene
- ICS
- CCS
- E49
- 发布
- 1992
- 实施
