K73 特殊灯具 标准查询与下载

JG/T 467-2014 建筑室内用发光二极管(LED)照明灯具

本标准规定了在建筑室内照明用发光二极管(LED)照明灯具的术语和定义、分类、要求、试验方法、检验规则、标识、包装、运输和贮存。本标准适用于以LED为光源的采用交流220 V/50 Hz电源供电的固定式通用灯具和嵌入式灯具。本标准不适用于一体化LED光源和应急特殊用途灯具。

Light emitting diode(LED) luminaire for building-indoor

IEC 62717:2014 普通照明用LED模块.性能要求

"General This International Standard specifies the performance requirements for LED modules@ together with the test methods and conditions@ required to show compliance with this standard. The following types of LED modules are distinguished and schematically shown in Figure 1: Type 1: integrated LED modules for use on d.c. supplies up to 250 V or on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. Type 2: LED modules operating with part of separate controlgear connected to the mains voltage@ and having further control means inside (""semi-integrated"") for operation under constant voltage@ constant current or constant power. Type 3: LED modules where the complete controlgear is separate from the module (nonintegrated) for operation under constant voltage@ constant current or constant power. The power supply of the controlgear for semi-ballasted LED modules (Type 2) is an electronic device capable of controlling currents@ voltage or power within design limits. The control unit of the controlgear for semi-ballasted LED modules (Type 2) is an electronic device to control the electrical energy to the LEDs. A LED module with separate controlgear can be either a non-ballasted LED module or a semi-ballasted LED module. This standard covers LED modules@ based on inorganic LED technology that produces white light. Life time of LED modules is in most cases much longer than the practical test times. Consequently@ verification of manufacturer's life time claims cannot be made in a sufficiently confident way@ because projecting test data further in time is not standardised. For that reason the acceptance or rejection of a manufacturers life time claim@ past an operational time as stated in 6.1@ is out of the scope of this standard. Instead of life time validation this standard has opted for lumen maintenance codes at a defined finite test time. Therefore@ the code number does not imply a prediction of achievable life time. The categories@ represented by the code@ are lumen-depreciation character categories showing behaviour in agreement with manufacturer's information which is provided before the test is started. In order to validate a life time claim@ an extrapolation of test data is needed. A general method of projecting measurement data beyond limited test time is under consideration. The pass/fail criterion of the life time test as defined in this standard is different from the life time metrics claimed by manufacturers. For explanation of recommended life time metrics@ see Annex C. NOTE When modules are operated in a luminaire@ the claimed performance data can deviate from the values established via this standard due to e.g. luminaire components that impact the performance of the LED module. The separate electronic controlgear for LED modules as mentioned in Type 2 and Type 3 is not part of the testing against the requirements of this standard. Protection for water and dust ingress@ see B.3."

LED modules for general lighting - Performance requirements

IEC 62722-2-1:2014 灯具性能.第2-1部分:LED灯具用详细要求

This part of IEC 62722 specifies the performance requirements for LED luminaires@ together with the test methods and conditions@ required to show compliance with this standard. It applies to LED luminaires for general lighting purposes. The following types of LED luminaires are distinguished. ?C Type A ?C Luminaires using LED modules where compliance with IEC 627171 has been proven. ?C Type B ?C Luminaires using LED modules where compliance with IEC 627171 has not been proven. ?C Type C ?C Luminaires using a LED lamp and covered in IEC 62722-1. The requirements of this standard only relate to type testing. This standard does not cover Type C luminaires. This standard does not cover LED luminaires that intentionally produce coloured light@ neither does it cover luminaires using OLEDs (organic LEDs). These performance requirements are additional to the requirements in IEC 62722-1@ Clauses 1 to 9@ except where in this Part 2-1 alternative methods of measurement or limits are specified. As this standard has been simultaneously developed and edited with the standard for LED modules@ where appropriate the compliance of the LED modules to the provisions of IEC 62717 may be transferred to the whole luminaire. Life time of LED luminaires is in most cases much longer than the practical test times. Consequently@ verification of manufacturer's life time claims cannot be made in a sufficiently confident way. For that reason the acceptance or rejection of a manufacturer's life time claim@ past 25 % of rated life (with a maximum of 6 000 h)@ is out of the scope of this standard. Instead of life time validation@ this standard has opted for lumen maintenance categories at a defined finite test time. Therefore@ the category number does not imply a prediction of achievable life time. The categories are lumen-depreciation character categories showing behaviour in agreement with manufacturer's information which is provided before the test is started. In order to validate a life time claim@ an extrapolation of test data is needed. A general method of projecting measurement data beyond limited test time is under consideration. For explanation of recommended life time metrics see IEC 62717@ Annex C. It may be expected that LED luminaires which comply with this standard will start and operate satisfactorily at voltages between 92 % and 106 % of rated supply voltage and at an ambient air temperature within the declared range of the manufacturer. Evaluation of LOR (light output ratio) for LED luminaire is under consideration. 1 To be published.

Luminaire performance - Part 2-1: Particular requirements for LED luminaires

DB43/T 672-2014 LED路灯

LED street light

IEC 62722-1:2014 灯具性能.第1部分:一般要求

Luminaire performance - Part 1: General requirements

DB51/T 1795-2014 安全社区建设与管理基本规范

Basic norms of safe community construction and management

IEC 60598-2-22:2014 灯具.第2-22部分:特殊要求.应急照明灯具

"This part of IEC 60598 specifies requirements for emergency luminaires for use with electrical lamps on emergency power supplies not exceeding 1 000 V. This part does not cover the effects of non-emergency voltage reductions on luminaires incorporating high pressure discharge lamps. This part gives general requirements for emergency lighting equipment. This part continues to use the term ""lamp"" which also includes ""light source(s)"" where appropriate."

Luminaires - Part 2-22: Particular requirements - Luminaires for emergency lighting

DB44/T 1335-2014 LED医用X线胶片观察灯

本标准规定了LED医用X线胶片观察灯的术语和定义，产品分类，技术要求，试验方法，检验规则，标志、产品使用说明书，包装、运输、贮存。 本标准适用于以LED为光源的医用X线胶片观察灯，供医院、诊所、科研单位等部门观察X线胶片用。

LED medical X-ray film observation lamp

DB44/T 1337-2014 汽车库LED照明设计标准

本标准规定了汽车库采用LED照明工程设计与应用相关技术标准。 本标准适用于以LED为光源的新建、改建、扩建的汽车库照明设计。

Garage LED Lighting Design Standards

DB44/T 1338-2014 汽车隧道LED照明设计标准

本标准规定了汽车隧道（包含公路、城市道路的新建或改扩建隧道）采用LED照明工程设计与应用相关技术标准。 本标准适用于以LED为光源的汽车车行隧道，不适用于轨道交通用隧道。

LED Lighting Design Standards for Automotive Tunnels

ANSI/UL 153-2014 便携式电灯安全性标准

Standard for Safety for Portable Electric Luminaires

ANSI E1.4-2014 环境技术.手动平衡操纵系统

Entertainment Technology - Manual Counterweight Rigging Systems

DB41/T 848-2013 微显示投影用LED光源

LED light source for micro display projection

WH/T 60-2013 LED舞台灯具通用技术条件

General technical conditions for LED stage lighting

WH/T 61-2013 演出场所电脑灯具性能参数测试方法

Test method for performance parameters of computerized lighting fixtures in performance venues

SN/T 1588.3-2013 进出口灯具检验规程 第3部分:游泳池及类似场所用灯具的特殊要求

SN/T 1588的本部分规定了进出口游泳池及类似场所用灯具的要求、抽样、检验及检验结果的判定。本部分适用于在水中使用或与水接触的固定式灯具,如游泳池水槽、喷水池、划水池和花园水池中,使用钨丝灯和LED的灯具的进出口检验。本部分不适用于不与水接触的灯具(如:安装在与灯具分开的玻璃板后面)或手提式灯具的进出口检验。

Rules for the inspection of luminaires for import and export.Part 3:Particular requirements of luminaries for swimming pools and similar applications

IEC 60601-2-41:2013 医疗电气设备.第2-41部分:手术灯具和诊断灯具基本安全性和基本性能的详细要求

Medical electrical equipment - Part 2-41: Particular requirements for basic safety and essential performance of surgical luminaires and luminaires for diagnosis

BS EN 60598-2-11:2013 灯具. 特殊要求. 水族箱灯具

Luminaires. Particular requirements. Aquarium luminaires

BS EN 60598-2-24:2013 灯具. 特殊要求. 限制表面温度的灯具

Luminaires. Particular requirements. Luminaires with limited surface temperatures

BS EN 60598-2-12:2013 灯具. 特殊要求. 电源插座安装的夜灯

Luminaires. Particular requirements. Mains socket-outlet mounted nightlights