K80 电源综合 标准查询与下载

KS C IEC 61249-5-4:2003 内部连接结构用材料.第5部分:有或无涂层的导电箔和导电薄膜分规范.第4节:导电墨水

이 규격은 접속 부분의 금속 마무리에 사용되는 전도성 잉크와 이의 품질에 대한 요구 사

Material for interconnection structures-Part 5:Sectional specification set for conductive foils and films with or without coatings-Section 4:Conductive inks

KS C IEC 60428:2003 标准电池

1.1 이 규격은 기전력으로 사용하는 다음 두 종류의 표준 전지에 적용한다. -포화

Standard cells

KS C 3832-2003 固定支柱绝缘子

이 규격은 공칭 전압 6.6 kV 이상의 전선로에 있어서, 도체의 지지 및 단로기 등에

Station post insulators

KS C IEC 60086-5:2003 原电池组.第5部分:水溶系电池的安全性

이 규격은 정상적인 전지 사용의 경우 안전 수칙과 논리적으로 예측 가능한 오용 사례를

Primary batteries－Safety of batteries with aqueous electrolyte

KS C IEC 60086-4:2003 原电池.第4部分:锂电池的安全性

이 규격은 소기의 용도로 사용하는 경우의 안전 수칙과 논리적으로 예측 가능한 오용 사례

Primary batteries－Safety of lithium batteries

KS C 4310-2003 不间断电源设备

이 규격은 직류 접속점에 전기적 에너지 축적 장치를 가지고 부하 전력의 연속성을 확보하여

Uninterruptible power system

KS C 8510-2003 摩托车用铅酸蓄电池

이 규격은 이륜 자동차의 시동, 점등, 점화 등에 사용하는 납 축전지(이하 축전지라 한다.

Lead-acid batteries for motorcycles

KS C 8515-2003 圆柱密封镉镍可充单体电池

이 규격은 원통상의 밀폐형 니켈ㆍ카드뮴 축전지(이하 전지라 한다.)에 대하여 규정한다.

Sealed nickel-cadmium, cylindrical rechargeable single cells

KS C IEC 60052:2003 标准(空)气隙法测量电压

KS C IEC 60052는 다음과 같은 4가지 형태의 첨두 전압을 측정하기 위한 표준

Voltage measurement by means of standard air gaps

BS EN 61800-5-1:2003 可调速的电驱动系统.安全要求.电、热及能量

This part of IEC 61800 specifies requirements for adjustable speed power drive systems, or their elements, with respect to electrical, thermal and energy safety considerations. It does not cover the driven equipment except for interface requirements. It applies to adjustable speed electric drive systems which include the power conversion, drive control, and motor or motors. Excluded are traction and electric vehicle drives. It applies to d.c. drive systems connected to line voltages up to 1 kV a.c, 50 Hz or 60 Hz and a.c. drive systems with converter input or output voltages up to 35 kV, 50 Hz or 60 Hz. Rating specifications for d.c. power drive systems connected to line voltages up to 1 kV a.c. are covered in IEC 61800-1. Rating specifications for a.c. power drive systems with converter input or output voltages up to 1 kV a.c. are covered in IEC 61800-2. EMC aspects are covered in IEC 61800-3. Rating specifications for a.c. power drive systems with converter input or output voltages greater than 1 kV a.c. and up to 35 kV a.c. are covered in IEC 61800-4. The scope of this part of IEC 61800 does not include devices used as component parts of a PDS if they comply with the safety requirements of a relevant product standard for the same environment. NOTE 1 In some cases, safety requirements of the overall PDS (for example, protection against direct contact) can necessitate the use of special components and/or additional measures. NOTE 2 For the purposes of this International Standard, energy hazards can be, for example, explosion of components or stored energy in capacitors.

Adjustable speed electrical power drive systems. Safety requirements. Electrical, thermal and energy

KS C 8302-2002 螺口式灯座

이 규격은 주파수 60 Hz의 교류 600 V 이하의 전로에 사용하는 KS C 7702에

Edison screw lampholders

KS C IEC 60686:2002 交流输出稳压电源

이 규격은 교류나 직류 전원으로부터 교류 전원을 공급하는 전원 장치에 적용한다. 전기 측정

Stabilized power supplies, a.c. output

UL 1778 PROPOSED-2002 (草案)不间断电源设备UL安全性标准.第三版提案;评议提交截止日期:2003年1月24日

1.1 Scope Replace this clause of the RD with the following: 1.1.1 Equipment covered by this standard This Standard applies to UNINTERRUPTIBLE POWER SYSTEMS (UPS). The primary function of the UPS for this Standard is to ensure continuity of an alternating power source. The UNINTERRUPTIBLE POWER SYSTEM may also serve to improve the quality of the power source by keeping it within specified characteristics. This Standard is applicable to movable, stationary, fixed, and built-in UPS for distribution systems up to 600 V a.c. This equipment is designed to be installed in accordance with the Canadian Electrical Code, Part I, CSA C22.1, or the National Electrical Code, ANSI/NFPA 70, and, unless otherwise identified, the Standard for the Protection of Electronic Computer Data-Processing Equipment, ANSI/NFPA 75. This Standard specifies requirements intended to ensure safety for the OPERATOR and, where specifically stated, for SERVICE PERSONNEL. This Standard is intended to reduce the risk of fire, electric shock, or injury to persons from installed equipment, both as a single unit or as a system of interconnected units, subject to installing, operating, and maintaining the equipment in the manner prescribed by the manufacturer. 1.1.2 Additional requirements: In addition to the requirements in this Standard, a UPS is to

(DRAFT) UL Standard for Safety Uninterruptible Power Supply Equipment Proposed Third Edition; Comments Due by January 24, 2003

KS C 8517-2002 通风式镉镍棱柱形蓄电池

이 규격은 직육면체형 배기식 니켈 카드뮴 축전지(이하 전지라 한다.)에 대하여 규정한다.

Vented nickel－cadmium prismatic secondary single cells

KS C 2206-2002 铅酸蓄电池玻璃毡片

이 규격은 납 축전지의 극판 사이에 넣어서 극관의 활물질을 유지하기 위하여 사용되는 납

Glass mats for lead－acid batteries

KS C 2207-2002 铅酸蓄电池槽

이 규격은 납 축전지에 사용하는 합성 수지 및 에보나이트 전조(이하 전조라 한다.)에

Containers for lead－acid batteries

DIN EN 61204:2001 直流输出低压供电装置.性能特征

Low-voltage power supply devices, d.c. output - Performance characteristics (IEC 61204:1993, modified + A1:2001); German version EN 61204:1995 + A1:2001

DIN EN 61204-3:2001 直流输出低压供电装置.第3部分:电磁兼容性(EMC)

Low-voltage power supplies DC output - Part 3: Electromagnetic compatibility (EMC) (IEC 61204-3:2000); German version EN 61204-3:2000

DIN EN 61204-6:2001 直流输出低压供电装置.第6部分:经过性能评定的低压供电装置要求

Low-voltage power supplies, DC output - Part 6: Requirements for low-voltage power supplies of assessed performance (IEC 61204-6:2000); German version EN 61204-6:2001

SANS 61204-6:2000 低压直流电源．第6部分：评定低压直流电源性能的要求

Applies to power supplies for general purpose applications. The power supplies carry out an a.c. to d.c. conversion or a d.c. to d.c. conversion. Applies to all d.c. or a.c. source voltages with a rated value of up to 600 V.

Low-voltage power supplies, d.c. output Part 6: Requirements for low-voltage power supplies of assessed performance