N21 电测模拟指示仪表 标准查询与下载

JJG 440-2008 工频单相相位表检定规程

本规程适用于新制造、使用中和修理后的额定频率为5OHz的单相模拟指针式相位表（包括相角表和功率因数表，下面简称为相位表。）的首次检定、后续检定和使用中的检验。 本规程不适用于电子式工频相位计、自动记录式相位表、移相补偿式相位表、非工频相位表、三相相位表以及与本规程不符的其他类型相位计量仪表。

Verification Regulation of Industry Frequency Singlemphase Phase Meter

GJB/J 5972-2007 非接触式静电电压表校准规范

本校准规范规定了非接触式静电电压表的计量特性、校准条件、校准项目、校准方法、校准结果的处理和复校时间间隔。 本校准规范适用于新制造（或新购置）、使用中和修理后的10V～2OKV非接触式静电电压表的校准。超过2OKV的非接触式静电电压表的校准也可参照使用。 本校准规范不适用于接触式静电电压表的校准。

Calibration specification for non-contact static voltmeter

JJF 1155-2006 30MHz～1.0GHz吸收式功率钳校准规范

本校准规范适用于对新制造、购进、使用中和修理调整后的，频率范围在(30～1000)MHz满足GB/T 6113.1-1995和GB/T 6113.2-1998标准要求的吸收式功率钳(吸收钳)校准。

Calibration specification for absorbing clamp in the range of 30MHz to 1.0GHz

AIR FORCE A-A-59322 A-2006 欧姆表

This Commercial Item Description (CID) describes an Ohmmeter herein referred to as equipment. This CID is meant as a minimum requirement in which only those manufactures meeting or surpassing the following requirements are to be supplied per this CID.

OHMMETER

JJG 494-2005 高压静电电压表

本规程适用于额定电压高于600V，用于测量工频高电压和直流高电压的指示式高压静电电压表(以下简称静电电压表)的首次检定、后续检定和使用中检验。

High Voltage Electrostatic Voltmeters

GJB/J 5413-2005 大电压高频电子电压表检定规程

本检定规程规定了大电压高频电子电压表（以下简称电压表）的技术要求、检定条件、检定项目、检定方法、检定结果和检定周期。 本检定规程适用于新制造、使用中和维修后的电压表大量程的检定。

Verification regulation for electronic voltmeter of high frequency and voltage

GJB/J 5415-2005 耐电压测试仪检定规程

本检定规程规定了100kV以下容量小于5kVA的耐电压测试仪的主要技术要求、检定条件、检定项目、检定方法、检定结果的处理和检定周期。 本检定规程适用于新制造、新购置、使用和修理后的容量小于5kVA交流（或直流）耐电压测试仪的检定。其输出电压为0~100kV以下的工频交流（或直流）电压。

Verfication regulation for withstanding voltage tester

BS EN 13757-4:2005 仪表和仪表远程读数用通信系统.无线仪表读数(在868 MHz 至870 MHz SRD频带上运行的无线电仪表读数)

This European Standard specifies the requirements of parameters for the physical and the link layer for systems using radio to read remote Meters. The primary focus is to use the Short Range Devices (SRD) unlicensed telemetry band, 868 MHz to 870 MHz. The standard encompasses systems for walk-by, drive-by and fixed installations. As a broad definition, this European Standard can be applied to various application layers.

Communication systems for meters and remote reading of meters - Wireless meter readout (radio meter reading for operation in the 868-870 MHz SRD band)

JJG 366-2004 接地电阻表

Earth Resistance Meters

IEC 61481:2004 带电作业.用于交流电压在1 kV 到 36 kV的可携式相位比较器

Is applicable to portable phase comparators with or without a built-in power source to be used on electrical systems for voltages from 1 kV to 36 kV a.c. and frequencies from 50 Hz to 60 Hz. This standard is applicable to two-pole phase comparators havin

Live working - Portable phase comparators for use on voltages from 1 kV to 36 kV a.c.

SJ 20878-2003 军用数字矢量信号源通用规范

General specification for military digital vector signal generator

JIS B 7536 ERRATUM 1:2003 JIS B7536 勘误表 1

ERRATUM

AIR FORCE A-A-59320-2003 欧姆表

This Commercial Item Description (CID) describes an ohmmeter. This CID is meant as a minimum requirement for the ohmmeter, in which only those manufacturers that meet or surpass the following requirements are supplied per this CID.

OHMMETER

SANS 61243-2:2003 带电操作.电压探测器.第2部分:在1千伏到36千伏交流电压情况下所使用的电阻类型

Is applicable to portable voltage detectors with or without a built-in power source to be used on electrical systems for voltages of 1 kV to 36 kV a.c., and frequencies from 15 Hz to 60 Hz. Applies only to resistive voltage detectors used in contact with the part to be tested, as a single unit or as a separate device completed by an adaptable insulating pole covered in IEC 60855 or IEC 61235.

Live working - Voltage detectors Part 2: Resistive type to be used for voltages of 1 kV to 36 kV a.c.

BS EN 62053-23:2003 电量计量设备(交流电).特殊要求.静态无功千瓦时计(2和3级)

This part of IEC 62053 applies only to newly manufactured static var-hour meters of accuracy classes 2 and 3, for the measurement of alternating current electrical reactive energy in 50 Hz or 60 Hz networks and it applies to their type tests only. For practical reasons, this standard is based on a conventional definition of reactive energy for sinusoidal currents and voltages containing the fundamental frequency only. It applies only to static var-hour meters for indoor and outdoor application consisting of a measuring element and register(s) enclosed together in a meter case. It also applies to operation indicator(s) and test output(s). If the meter has a measuring element for more than one type of energy (multi-energy meters), or when other functional elements, like maximum demand indicators, electronic tariff registers, time switches, ripple control receivers, data communication interfaces, etc. are enclosed in the meter case, then the relevant standards for these elements also apply. It does not apply to: - var-hour meters where the voltage across the connection terminals exceeds 600 V (line-to-line voltage for meters for polyphase systems); - portable meters; - data interfaces to the register of the meter; - reference meters. The dependability aspect is covered by the documents of the IEC 62059 series.

Electricity metering equipment (a.c.) - Particular requirements - Static meters for reactive energy (classes 2 and 3)

JJG 531-2003 直流电阻分压箱

The DC Resistive Volt Ratio Box

AIR FORCE A-A-59381-2003 欧姆表

This Commercial Item Description describes a soil resistance meter. The soil resistance meter is used to measure earth resistance and ground sensitivity. This CID is meant as a minimum requirement for the soil resistance meter, herein referred to as ohm

OHMMETER

JIS C 1302:2002 绝缘电阻检测器

この規格は，電池を内蔵する定格測定電圧1000V以下を測定対象とした，a),b)に使用する指針形及びディジタル形の携帯用直読形絶縁抵抗計について適用する。a)低電圧配電路交流I000V及び直流1500V以下の配電系統で電源が切断されて4，る電路，機器の絶縁測定b)機器.器具，部品などの絶縁測定備考 この規格の対応国際規格を，次に示す。なお，対応の程度を表す記号は，ISO/IEC Guide 21に基づき， IDT(一致している)，MOD（修正している），NEQ(同等でない)とする。

Insulation resistance testers

JIS C 1304:2002 接地检测器

この規格は，低圧配電系統において使用する交流電圧を用いた接地抵抗計について規定する。備考1.低電圧配電系統交流1000V及び直流1500V以下の配電系統を指す。2.接地抵抗計には，地電圧を測定するための交流電圧計など接地抵抗測定以外の機能を設けてもよい。

Earth testers

GOST 8.027-2001 ГСИ.测量电动力和直流电压器具的国家一级基准器和全苏检定系统

Настоящий стандарт распространяется на государственную поверочную схему для средств измерений постоянного электрического напряжения и

State system for ensuring the uniformity of measurements. State verification schedule for measuring instruments of direct electrical vortage and electromotive force