共找到 78 条与 机械设备安装工程 相关的标准,共 6 页
本规范适用于额定蒸汽压力不大于26MPa、额定蒸发量不大于150t/h、蒸汽温度400℃以下,以油、气为燃料的油田注汽用直流锅炉的制造的制造、安装、调试及验收。
Technical specification for manufacture and installation of steam generators used in oil-fields
本标准规定了重型自动扶梯、自动人行道的基本要求、要求、试验和检验、标志牌和警示牌。本标准适用于重型自动扶梯、自动人行道的设计和制造。
Technical requirements for heavy escalators and moving walks
Guidelines for Energy Efficiency Evaluation of Industrial Boiler Room System
Evaluation method of energy efficiency grade for installation and acceptance of industrial boilers
This European Standard specifies the elements necessary for the preparation of the instructions for the maintenance operations, as in 3.1, which are provided for new installed passenger lifts, goods passenger lifts, accessible goods only lifts, service lifts, escalators and passenger conveyors. This European Standard does not cover: a) instructions for the installation and the dismantling; b) any legal examinations and tests based on national regulations. Existing installations are not covered by this Standard, but it can be taken as a reference.
Maintenance for lifts and escalators - Rules for maintenance instructions
本标准规定了工具箱柜的术语和定义、分类和标记、技术要求、试验方法、检验规则和标志、包装、运输、贮存。 本标准适用于用钢板制作的工具箱柜(以下简称“工具箱柜”)。
Tool stowage.General technical requirements
SY 4201的本部分规定了设备安装工程机泵类设备安装工程的检验批、分项工程施工现场质量管理和质量控制规定。 本部分适用于石油天然气建设工程的设备安装工程机泵类设备施工质量的验收,包括离心泵(含输油泵组、45MPa以下注水泵)、轴流泵、井用泵、螺杆泵、往复式柱塞泵的整体安装;活塞式气体压缩机、离心通风机、离心鼓风机、轴流通风机、离心压缩机整体安装;游梁式抽油机安装;具有风管式燃烧室和水平结合面结构的燃气轮机动力装置的安装。
Code for quality accptance of oil and gas construction engineering Equipment installation engineering Part 1: Mechanism and pump device
규격은 정격 속도 60 m/min을 초과하는 엘리베이터용 유입 완충기(이하, 완충기라 한다
Oil buffers for elevator
Supervision and Inspection Rules for Boiler Installation
건설 공사용 리프트 승강구에 설치하는 리프트 승강구 안전문(이하 “안전문”이라 한다.)에
Access door for lifter
This part of Standard defines requirements for rubber vibration isolator for lift (called "isolator" hereinafter) which are used to block or buffer vibrations originating from traction machine of lift.
Rubber vibration isolators for elevator
a) This part of Standard establishes requirements for safety limit switch used on lifts. b) This device shall prevent lift from passing terminal floors. c) This device shall actuate before lift (or counterweight) hits buffer.
Safety limit switch for elevators
This part of Standard establishes requirements for device for communication between inside of lift car and outside of it. It applies to two-way voice communication device among emergency call button in the car and external alarm device.
Emergency signaling device for elevators
This part of Standard establishes requirements for emergency car operation key switch for firefighter's lift which is used to operate the lift by firefighter inside the car during rescue and firefighting operation (called "emergency operation switch" hereinafter).
Emergency in-car operation key switch for firefighters’ elevators
Specifications for construction and acceptance of industrial boiler installation engineering
本规程适用于采用水泥为结合剂的耐火浇注料制作的各种工业炉和设备内衬的冬期施工及维护。
SPECIFICATION FOR CEMENT REFRACTORY MATERIALS GROOLING IN WINTER FOR INDUSTRIAL FURNACE CONSTRUCTION
Supervision and management rules for boiler installation and transformation units
Technical regulations for the installation of basic spring isolators for large chemical units
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号