Q50 炭素材料综合 标准查询与下载

DIN 51944 Corrigendum 1:2006 碳素材料的试验. 用四点法测定弯曲强度. 固体材料. DIN 51944: 1999-01的英文版本勘误表1

Testing of carbonaceous materials - Determination of flexural strength by four point method - Soild materials Corrigendum 1 to English version of DIN 51944:1999-01

DIN 51944 Berichtigung 1:2006 碳素材料的试验.四点法测定弯曲强度.固体材料.DIN 51944-1999勘误表

The document specifies a method for the determination of flexural strength of carbonaceous materials (solid matters) by four point method.

Testing of carbonaceous materials - Determination of flexural strength by four point method - Solid materials, Corrigendum to DIN 51944:1999-01

KS L 3415-2006 氧化铝.氧化镁耐火物化学分析方法

이 규격은 알루미나-마그네시아질 내화물의 화학 분석 방법에 대하여 규정한다.

Methods for chemical analysis of refractories containing alumina and magnesia

KS L 3414-2006 氧化铝.氧化锆.二氧化硅耐火物化学分析方法

이 규격은 알루미나-지르코니아-실리카질 내화물의 화학 분석 방법에 대하여 규정한다.

Methods for chemical analysis of refractories containing alumina, zirconia and silica

DIN 51908:2006-05 炭素材料试验.用比较法测定室温导热率.固体物质

This standard specifies a method for the determination of thermal conductivity at room temperature by means of a comparative method.

Testing of carbon materials - Determination of thermal conductivity at room temperature by means of a comparative method - Solid material

DIN 51930:2006 炭素材料的试验.焙烧焦炭挤压试样的制备.固体材料

The method is used for the preparation of extruded samples of calcinated cokes.

Testing of carbonaceous materials - Preparation of extruded samples of calcinated cokes - Solid materials

JWWA A114-2006 供水系统用粒状活性炭

Granular Activated Carbon for water supply

BS ISO 20203:2006 铝生产用碳素材料.煅烧焦炭.用X射线衍射法测定煅烧石油焦炭的晶体粒度

ISO 20203:2005 describes a test method for the determination of the mean crystallite height of a representative, pulverized sample of calcined petroleum coke by interpretation of an X-ray diffraction pattern produced through conventional X-ray scanning techniques. ISO 20203:2005 applies to carbonaceous materials used in the production of aluminium.

Carbonaceous materials used in the production of aluminium - Calcined coke - Determination of crystallite size of calcined petroleum coke by X-ray diffraction

KS F 2518-2005 石材吸水量和比重试验方法

이 규격은 천연산 슬레이트를 제외한 모든 천연산 석재의 흡수율 및 비중 시험 방법에 대하여

Testing method for absorption and bulk specific gravity of stone

KS L 3417-2005 钛酸钡、铅和镉的定量方法

이 규격은 전자 재료로 사용되는 티타늄산바륨 원료 분말의 납 및 카드뮴을 정량하는 방법에

Determination of lead and cadmium content in bariumtitanate raw powders

KS L 3418-2005 钛酸钡、铅和镉的定量方法

이 규격은 전자 부품에 사용되는 알루미나 중의 납과 카드뮴 분석을 위한 원자 흡수 분광법과

Determination of lead and cadmium content in alumina powders(alkali fusion)

KS L 3419-2005 氧化铝粉的铅和镉的定量方法(碱熔法)

이 규격은 전자 재료용 알루미나 원료 분말을 가압 황산 분해한 후 유도 결합 플라스마 방출

Determination of lead and cadmium content in alumina raw powders(high pressure bomb digestion method)

YS/T 62.1-2005 铝用炭素材料取样方法.第1部分:底部炭块

本部分规定了底部炭块交货时的抽样及从单个底部炭块上取样的方法。

Carbonaceous materials used in the production of aluminium - Sampling methods - Part 1: Cathode blocks

YS/T 62.2-2005 铝用炭素材料取样方法.第2部分:侧部炭块

本部分规定了侧部炭块交货时的抽样及从单个侧部炭块上取样的方法。

Carbonaceous materials used in the production of aluminium - Sampling methods - Part 2: Sidewall blocks

YS/T 62.3-2005 铝用炭素材料取样方法.第3部分:预焙阳极

本部分规定了大宗或成批交货时预焙阳极的抽样方案的制定和实施。 本部分同时还规定了从单块预焙阳极上取试样的最佳位置选择。

Carbonaceous materials used in the production of aluminium - Sampling methods - Part 3: Prebaked blocks

YS/T 62.4-2005 铝用炭素材料取样方法.第4部分:阴极糊

本部分规定了铝生产用炭素材料中阴极糊的取样方法和条件。

Carbonaceous materials used in the production of aluminium - Sampling methods - Part 4: Cathodic pastes

ANSI/AWWA B604-2005 颗粒活性炭

This standard describes virgin granular and extruded activated carbons for use as a filter medium and adsorbent in water treatment. It involves the selection, placement, and use of granular activated carbon (GAC) in filter-adsorbers where the GAC must function as both a filter medium and adsorbent, as well as those systems where the primary function is adsorption.

Granular Activated Carbon

DIN 51909 Berichtigung 1:2005 对DIN 51909-1998的勘误

The document specifies a method for the determination of coefficient of linear thermal expansion of carbonaceous materials (solid materials) a temperatur between 20 and 1000 ?

Corrigenda to DIN 51909:1998-04

DIN 51917:2002 碳素材料试验.洛氏硬度试验.布式硬度试验方法.固体材料

The document specifies a method about the Rockwell hardness test for carbon materials. A ball is used for this method.

Testing of carbonaceous materials - Rockwell hardness test - Ball indentation method; Solid materials

GSA FED-STD-832-2002 穹顶的施工方法和材料

Thisdocment establishes minimmconstmction requirements forhighsecmity vaults for storage of classified information and weapons.

CONSTRUCTION METHODS AND MATERIALS FOR VAULTS