Q70 建筑构配件与设备综合 标准查询与下载
共找到 783 条与 建筑构配件与设备综合 相关的标准，共 53 页
Base Test Method for Purlins Supporting a Standing Seam Roof System
- ICS
- 91.060.20
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
Guide Specification for Commercial Security Hollow Metal Doors
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
Industry Standard for Interio0r Architectural Wood Flush Doors
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
POWER ASSIST AND LOW ENERGY POWER OPERATED DOORS
- ICS
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
Standard for Door, Drapery, Gate, Louver, and Window Operators and Systems
- ICS
- 91.190
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
Standard for Safety for Wall- and Ceiling-Mounts and Accessories
- ICS
- 97.140
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
Industry Standard for Interior Architectural Wood Stile and Rail Doors
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013-01-01
- 实施
8.1 This specification recognizes that the effectiveness of a sheet radiant barrier is dependent on proper installation. Practices C1743 and C1744 address use and installation of radiant barriers. 8.2 This specification identifies the material properties that are important for sheet radiant barrier products. When appropriate, values for the properties have been stated. 8.3 When specific material properties are required for a particular application the user shall consult the manufacturer. 8.4 Radiant barriers shall be free of dust or other contaminants to remain effective. 1.1 This specification covers the general physical property requirements of radiant barrier materials for use in building construction. The scope is specifically limited to requirements for radiant barrier sheet materials that consist of at least one surface having a far-infrared emittance of 0.1 or less, such as metallic foils or metallic deposits mounted or unmounted on substrates. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 The following safety hazards caveat pertains only to the test methods (Section 10) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Sheet Radiant Barriers for Building Construction Applications
- ICS
- 91.120.10 (Thermal insulation of buildings)
- CCS
- Q70
- 发布
- 2013
- 实施
Test Method for Louvers Impacted by Wind Borne Debris
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013
- 实施
Structural Performance Ratings of Side-Hinged Exterior Door Systems and Procedures for Component Substitution
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013
- 实施
This European Standard specifies requirements and test/assessment/calculation methods for external and internal power operated pedestrian doorsets, other than swing type, initially designed for installation with power operation without resistance to fire and smoke leakage characteristics. Such doorset constructions may be operated electro-mechanically, electro-hydraulically or pneumatically. These doorsets include power operated pedestrian sliding doorsets, revolving doorsets, balanced (sliding/swing) doorsets and folding doorsets with one or more horizontally moving leaves. This European Standard applies to power operated pedestrian doorsets with flush or panelled leaves, complete with: integral fanlights, if any; NOTE 1 A fanlight is a panel over a door which is part of the doorset. side panels that are contained within a single frame for inclusion in a single aperture, if any. The intended uses of the products covered by this European Standard are: doorsets for external use in escape routes and other declared specific uses and/or uses subject to other specific requirements, in particular noise, energy, tightness and safety-in-use in construction works; doorsets for internal use in escape routes, communication and other declared specific uses and/or uses subject to other specific requirements, in particular noise and safety-in-use in construction works; doorsets for internal use in escape routes, communication and other declared specific uses and/or uses subject to other specific requirements, in particular noise, energy and safety-in-use in construction works. The products covered by this European Standard are not assessed for structural applications of the building. This European Standard does not cover operation in environments where the electromagnetic disturbances are outside the range of those specified in EN 61000-6-2. This European Standard does not apply to: external pedestrian doorsets according to EN 14351-1; internal pedestrian doorsets according to pr
Power operated pedestrian doors - Product standard, performance characteristics - Pedestrian doorsets, other than swing type, initially designed for installation with power operation without resistance to fire and smoke leakage characteristics
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013
- 实施
- 2013-10-01
Standard for Power Assist and Low Energy Power Operated Doors
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2013
- 实施
Extended application of test results for fire resistance and/or smoke control for door, shutter and openable window assemblies, including their elements of building hardware.Part 2: Fire resistance of hinged and pivoted steel doorsets; German version EN 1
- ICS
- 13.220.50;91.060.50
- CCS
- Q70
- 发布
- 2012-12
- 实施
Power operated pedestrian doorsets. Safety in use. Requirements and test methods
- ICS
- 91.060.50
- CCS
- Q70
- 发布
- 2012-10-31
- 实施
- 2012-10-31
Thermal performance of windows, doors and shutters - Calculation of thermal transmittance - Part 2: Numerical method for frames (ISO 10077-2:2012); German version EN ISO 10077-2:2012, Corrigendum to DIN EN ISO 10077-2:2012-06; German version EN ISO 10077-
- ICS
- 91.060.50;91.120.10
- CCS
- Q70
- 发布
- 2012-10
- 实施
이 표준은 실내 공간에서의 잔향 시간(RT) 측정 방법 및 중요한 실내 음향 변수, 즉 음
Measurement of the reverberation time of rooms with reference to the other acoustical parameters
- ICS
- 91.120.20
- CCS
- Q70
- 发布
- 2012-09-13
- 实施
- 2012-09-13
