R04 基础标准与通用方法 标准查询与下载

AASHTO BPCSS-2006 美国国家公路与运输协会卓越环境中心-解决方法的最佳实践

This report documents the AASHTO Center for Environmental Excellence’s second national competition to recognize best practices in context sensitive solutions (CSS).

AASHTO Center for Environmental Excellence - Best Practices in Context-Sensitive Solutions Revision 2

KS R ISO 12353-2:2005 道路车辆.交通事故分析.第2部分:碰撞损伤程度测定指南

이 규격은 도로 차량 충돌 사고시 충돌의 손상 정도를 측정하는 여러 가지 방법의 적합성을

Road vehicles-Traffic accident analysis-Part 2:Guidelines for the use of impact severity measures

KS R ISO 13216-1:2005 道路车辆.儿童约束系统在车内的固定点及主固定点的安装.第1部分:座椅座面与靠背之间的固定点及其连接

이 규격은 차량의 어린이 보호 장치(CRS)를 장착하기 위한 강체 고정부에 요구되는 치수,

Road vehicles-Anchorages in vehicles and attachments to anchorages for child restraint systems-Part 1:Seat bight anchorages and attachements

KS R ISO 12350:2005 道路车辆.评估侧向碰撞中乘员保护的伤害风险曲线

이 기술 보고서는 도로 차량의 측면 충돌시 탑승자 보호 평가를 위한 상해 위험 곡선을 제공

Road vehicles-Injury risk curves for evaluation ofoccupant protection in side impact

KS X ISO 15662:2005 智能传输系统.广域通信.协议管理信息

? ??? ISO/TC204 ?? ?? ??? ?? ??? ??? ??? ITS(Intel

Intelligent Transport Systems-Wide Area Communication-Protocol Management Information

JT/T 646-2005 公路声屏障材料技术要求和检测方法

本标准规定了公路声屏障材料的分类、技术要求和检测方法。 本标准适用于各等级公路降低公路交通噪声的声屏障。

Specifications and examining methods for highway noise barriers materials

JT/T 647-2005 公路绿化设计制图

本标准规定了公路绿化设计制图的一般要求、图例图示和图样画法等内容。 本标准适用于公路绿化设计及专业工程的手工制图、计算机制图。

Drawings for highway revegetation design

JT/T 643-2005 公路环境保护术语

本标准规定了公路环境保护的术语和定义。 本标准适用于公路的环境保护。

Terminology for highway environmental protection

JT/T 644-2005 公路绿化术语

本标准规定了公路绿化工作中的相关术语，适用于公路绿化规划、设计、施工、管理、养护、验收以及科研等相关工作。

Terminology for highrway revegetation

JT/T 645.3-2005 公路服务区生活污水再生利用　第3部分：处理系统操作管理要求

JT/T 645-2005的本部分规定了污水再生利用处理系统操作管理的基本要求和主要设施操作管理要求。 本部分适用于公路服务区生活污水再生利用处理系统。

Living wastewater reuse of highway service area Part3: Operation management requirements of treatment system

BS CWA 15295:2005 分类用参考资料和数据模型描述

Description of references and data models for classification

DIN 30786-2:2005 运输载荷.动态机械载荷的数据收集.第2部分:数据收集

The standard describes the finding of datas of dynamic mechanical loads for goods are carried by road, sea, air, rail and combined transport. The standard covers data collections of dynamic mechanical loads.#,,#

Transportation loads - Data collection of dynamic mechanical loads - Part 2: Collection of data

AASHTO EMSO-2005 美国国家公路与运输协会卓越环境中心-利用环境管理体系来应对运输挑战和机遇-事实指南

This Guide addresses the goals listed below in Sections 2.0 through 5.0. Following are the goals and brief descriptions of the information provided in each section to address each goal.

AASHTO Center for Environmental Excellence - Using an Environmental Management System to Meet Transportation Challenges and Opportunities - An Implementation Guide Revision 1

AASHTO CSS-1-2005 卓越环境中心解决方法的最佳实践

AASHTO’s Center for Environmental Excellence is pleased to announce the winners of the 2005 Best Practices in Context-Sensitive Solutions (CSS) competition. AASHTO received 75 applications from 33 states. After careful review by a diverse expert review

Center for Environmental Excellence Best Practices in Context-Sensitive Solutions

ASTM E2467-05 轴数调节系数设计的标准实施规范

This practice addresses the development of axle count adjustment factors, using axle counts and vehicle classification counts. This practice provides information for use with professional judgment by governmental agencies and private firms in the management of roads and roadway traffic. Traffic monitoring is important to the safe and efficient movement of people and goods. The purpose of this practice is to ensure that traffic monitoring procedures produce traffic data and summary statistics that are adequate to satisfy diverse and critical traffic information needs.1.1 This standard practice describes techniques for adjusting observed or assumed axle counts so that they will represent corresponding estimated vehicle counts as part of roadway traffic monitoring.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Standard Practice for Developing Axle Count Adjustment Factors

KS R ISO 13215-3:2004 道路车辆.儿童保护系统误用危险的减少.第3部分:误用模式和效果分析(MMEA)对误用的预测和评估

이 규격은 연소자 보호 장치의 오용을 예측하고 정량화하기 위한 ‘오용 상태와 영향 분석’(

Road vehicles－Reduction of misuse risk of child restraint systems－Part 3：Prediction and assessment of misuse by Misuse Mode and Effect Analysis(MMEA)

KS R ISO 12349-1:2004 道路车辆.减震系统试验标样.第1部分:成年人标样

이 기술 보고서는 앞면 및 측면 충돌 시험 절차에서 보호 장치의 탑승자 보호 가능성을 평가

Road vehicles-Dummies for restraint system testing-Part 1:Adult dummies

KS R ISO 12349-2:2004 道路车辆.减震系统试验标样.第2部分:少年人标样

이 기술 보고서는 에어백 전개로 어린이 보호 및 이들의 상호 작용을 평가하는데 사용하기 위

Road vehicles-Dummies for restraint system testing-Part 2:Child dummies

KS R ISO 13214:2004 道路车辆.儿童保护系统.规则和标准的编制

이 규격에는 도로 차량의 연소자 보호 장치(CRS)에 적용되는 주요 안전 기준과 공적 표준

Road vehicles-Child restraint systems-Compilation of Regulations and standards

DIN CEN/TS 13853:2004 联合运输用交换部件.C 745-S16类型的可堆放交换部件.尺寸、设计要求和试验

Swap bodies for combined transport - Stackable swap bodies type C 745-S16 - Dimensions, design requirements and testing; German version CEN/TS 13853:2003