共找到 310 条与 舱室设备 相关的标准,共 21 页
이 표준은 국제 항해에 종사하는 여객선 및 화물선에 적용할 수 있는 KS V ISO 175
Ship’s side scuttles-Positioning
이 표준은 국제 항해에 종사하는 여객선 및 화물선에 적용할 수 있는 KS V ISO 390
Ship’s ordinary rectangular windows-Positioning
本标准规定了船用耐火窗的分类和标记、要求、试验方法、检验规则及标志、包装和运输。 本标准适用于安装在船舶及海洋结构物上A60级耐火结构矩形窗和圆形窗的设计、制造和验收。
Marine fireproof windows
This International Standard specifies the requirements for the approval, installation and maintenance of lowlocation lighting systems as defined in Chapter II-2, Regulation 13.3.2.5.1 of the International Convention for the Safety of Life at Sea, 1974 (SOLAS 74), as amended in 2000, and the IMO International Code for Fire Safety Systems.
Ships and marine technology - Low-location lighting (LLL) on passenger ships - Arrangement
1.1 This specification provides the requirements for mattresses and box springs that are for use in berths for officers, crew, and passengers in marine vessels. This shall be considered a minimum standard. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses, in inch-pound units, are for information only. 1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of the materials, products, or assemblies under actual fire conditions. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Mattress and Box Springs for Use in Berths in Marine Vessels
SPECIFICATION FOR MATTRESS AND BOX SPRINGS FOR USE IN BERTHS IN MARINE VESSELS
Surface ship mooring and sea trial procedures part 158: Deck drainage and sanitary sewage system tests
Surface ship mooring and sea trial procedures part 157: Potable water and wash water system tests
Surface ship mooring and sailing test procedures part 200: galley equipment test
This International Standard specifies design conditions and methods of calculation for air-conditioning and ventilation of accommodation spaces and the radio cabin on board seagoing merchant ships for all conditions except those encountered in extremely cold or hot climates (i.e. with lower or higher conditions than those stated in 4.2 and 4.3). Annex A provides guidance and details of good practice in the design of ventilation and air-conditioning systems in ships. Annex B gives the thermal conductivities of commonly used construction materials. Users of this International Standard should note that, while observing the requirements of this International Standard, they should at the same time ensure compliance with statutory requirements, rules and regulations as may be applicable to the individual ship concerned,N1)
Ships and marine technology - Air-conditioning and ventilation of accomodation spaces - Design conditions and basis of calculations (ISO 7547:2002)(includes Corrigendum AC:2009); English version of DIN EN ISO 7547:2009-09
Ships and marine technology - Dimensioning for air condition and air ventilation plants for accommodation on ships
Shipbuilding - Ventilation and air-treatment of galleys and pantries with cooking appliances
Ships and marine technology - Fire-extinguishing systems for protection of galley cooking equipment
이 표준은 선박에 사용되는 기관실 구역 개방형 선반(이하 선반이라 한다.)에 대하여 규정한
Open shelves in engine room for marine use
Specifies requirements and describes test methods for measuring the airflow of fans intended for use in engine compartments, galley areas and other spaces on small craft in which mechanical ventilation is desirable. Applies to electrically operated fans
Small craft - Electric fans
Specifies the design and installation of permanently installed galley stoves using fuels which are liquids at atmospheric pressure on small craft of hull length up to 24 m. Does not cover cooking appliances designed or intended solely as portable self-co
Small craft - Liquid-fuelled galley stoves
This European standard specifies safety and ergonomic for wheelhouses on inland navigation vessels.
Inland navigation vessels - Wheelhouse - Ergonomic and safety requirements; English version of DIN EN 1864:2008-06
本标准规定了船用金属桌的分类、要求、试验方法、检验规则和标志、包装、运输、储存等。 本标准适用于金属结构的各种船用桌。
Marine type and dimension of metal table
本标准规定了船用金属吊床和柜床的分类、要求、试验方法、检验规则和标志、包装和运输。 本标准适用于船用金属吊床和柜床。
Marine type and dimension of metal hanging bed and bed
1.1 This specification provides the requirements for mattresses and box springs that are for use in berths for officers, crew, and passengers in marine vessels. This shall be considered a minimum standard. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses, in inch-pound units, are for information only. 1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of the materials, products, or assemblies under actual fire conditions. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Mattress and Box Springs for Use in Berths in Marine Vessels
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号