W22 毛纱、线 标准查询与下载

ASTM D2817-05(2009) 开士米毛线中最大粗毛节含量的标准规范

This specification sets the maximum permissible cashmere coarse-hair content for cashmere in the form of roving, yarn, or fabric. When agreed upon by parties in interest, this specification provides a basis for acceptance testing of roving, yarn, or fabric of cashmere, or blends of cashmere and other fibers in such products.1.1 This specification covers the allowable cashmere coarse-hair content in cashmere which has been processed at least to the roving stage. 1.2 For blends of cashmere hair and other fibers, this specification is applicable only to the cashmere hair content of such blends. Note 18212;For the determination of the cashmere coarse-hair content in cashmere, refer to Test Method D 2816. For the identification of textile fibers see Methods D 276. For the quantitative determination of the composition of textile blends, see Test Methods D 629. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Maximum Cashmere Coarse-Hair Content in Cashmere

ASTM D2816-05(2009) 开士米毛线中粗毛节含量的标准试验方法

This test method may be used for determining compliance with a specification for maximum cashmere coarse-hair content and is required to be used for determining compliance with Specification D 2817. In case of a dispute arising from differences in reported test results when using Test Method D 2816 for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student''s t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the light of the known bias. When the product being tested has a cashmere coarse-hair content that departs significantly either way from the specified amount, the sequential test procedure described herein will result in a substantial reduction in the number of observations required for a decision at the stated level of confidence. On the other hand, when the product being tested has a cashmere coarse-hair content that approaches the specified amount, the sequential procedure ensures that the necessary increased number of observations shall be made to secure a correct decision at the stated level of confidence.1.1 This test method covers a sequential procedure for determining whether or not the cashmere coarse-hair content of a sample exceeds a specified value. Note 18212;For the maximum allowable cashmere coarse-hair content in cashmere, refer to Specification D 2817. Note 28212;For the quantitative analysis of cashmere hair and blends of cashmere hair and other fibers, refer to Test Methods D 629. 1.2 This test method is applicable only to cashmere hair in the form of roving, yarn, or fabric, and to the cashmere hair content of blends with other fibers, where the expected cashmere coarse-hair content is not more than five mass percent (see Footnote C of Table 1). For greater expected mass percentages of cashmere coarse-hair, see Test Methods D 629. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. TABLE 1 Sequential Accept-Reject Numbers for Selected SpecificationsA Number of Fi- bers CountedSpecification, Length %B 0.20.30.40.5

Standard Test Method for Cashmere Coarse-Hair Content in Cashmere

ASTM D2816-05 开士米毛线中粗毛节含量的标准试验方法

This test method may be used for determining compliance with a specification for maximum cashmere coarse-hair content and is required to be used for determining compliance with Specification D 2817. 5.1.1 In case of a dispute arising from differences in reported test results when using Test Method D 2816 for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Studentrsquo;t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the light of the known bias. When the product being tested has a cashmere coarse-hair content that departs significantly either way from the specified amount, the sequential test procedure described herein will result in a substantial reduction in the number of observations required for a decision at the stated level of confidence. On the other hand, when the product being tested has a cashmere coarse-hair content that approaches the specified amount, the sequential procedure ensures that the necessary increased number of observations shall be made to secure a correct decision at the stated level of confidence.1.1 This test method covers a sequential procedure for determining whether or not the cashmere coarse-hair content of a sample exceeds a specified value. Note 1For the maximum allowable cashmere coarse-hair content in cashmere, refer to Specification D 2817.Note 2For the quantitative analysis of cashmere hair and blends of cashmere hair and other fibers, refer to Test Methods D 629.1.2 This test method is applicable only to cashmere hair in the form of roving, yarn, or fabric, and to the cashmere hair content of blends with other fibers, where the expected cashmere coarse-hair content is not more than five mass percent (see Footnote C of ). For greater expected mass percentages of cashmere coarse-hair, see Test Methods D 629.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Cashmere Coarse-Hair Content in Cashmere

FZ/T 22001-2002 精梳机织毛纱

本标准规定了精梳机织毛纱的技术要求、试验方法、验收规则、包装和标志等技术特征。 本标准适用于鉴定精梳机织纯毛、毛混纺、毛型化纤毛纱的品质。

Worsted woven wool yarn

FZ/T 22002-2002 粗梳机织毛纱

本标准规定了精梳机织毛纱的技术要求、试验方法、验收规则、包装和标志等技术特征。 本标准适用于鉴定精梳机织纯毛、毛混纺、毛型化纤毛纱的品质。

Woolen woven wool yarn

FZ/T 71007-1999 粗梳牦牛绒针织绒线

本标准规定了粗梳牦牛绒线的技术要求、试验方法、检验规则和包装、标志等全部技术特征。 本标准适用于鉴定粗梳纯牦牛绒针织绒线和含牦牛绒30%及以上的牦牛绒混纺针织绒线的品质。

Wollen yak hair knitting yarn

QB/T 3645-1999 地毯用毛纱色牢度试验方法

本标准适用于合成染料所染的地毯用色毛纱。 本方法适用于测定地毯用毛纱的色泽耐干摩擦的能力。

Test method for color fastness of wool yarn for carpet

ARMY MIL-PRF-46190 A (1)-1999 树脂注入預浸没碳纤维机织织物

This amendment forms a paortf MIL-PRF-46190A, dated2 2 May 1997, and is approved for use by allD epartments and Agencieosf theD epartment of Defense.

PREPREGS, WOVEN FABRIC, CARBON FIBER, RESIN IMPREGNATED

FZ/T 52004-1998 粗梳牦牛绒针织绒线

本标准规定了充填用三维卷曲中空涤纶短纤维的要求、试验方法、检验规则、标志、包装、运输和贮存的要求。 本标准主要适用于名义线密度为6.67~7.78 dtex、单孔、无硅、半消光的充填用三维卷曲中空涤纶短纤维。其他规格及用途的涤纶短纤维可参照使用。

Carded yak wool knitting yarn

ARMY MIL-F-64156 NOTICE 1-1998 镍涂层的碳(石磨)纤维织物

MIL-F-64156, dated 15 October 1990, is inactive for new design and is no longer used, except for replacement purposes.

FABRIC, CARBON (GRAPHITE) FIBER, NICKEL-COATED

FZ/T 21004-1998 国产细羊毛及其改良毛毛条

本标准规定了国产细羊毛及其改良毛毛条的技术要求、分支、分级、分等、包装验收和试验方法。 本标准定为全国毛纺织工业鉴定国产细羊毛及其改良毛毛条品质和交接验收的统一规定。

Domestic fine wool and its modified tops

FZ/T 24008-1998 精梳高支轻薄型毛织品

本标准规定了精梳高支轻薄型毛织品的技术要求、试验方法、包装标志及检验规则。 本标准适用于鉴定各类机织服用精梳高支轻薄型纯毛、毛混纺(羊毛及其他动物纤维含量30%及以上)及交织品的品质和交货验收的统一规定。

Worsted high counts light-weight fabrics

ARMY MIL-PRF-46190 A-1997 树脂注入預浸没碳纤维机织织物

This specification is approved for useb y all Departments and Agenciesof the Department of Defense.

PREPREGS, WOVEN FABRIC, CARBON FIBER, RESIN IMPREGNATED

JIS R 3417:1995 羊毛粗纱玻璃纤维

Woven roving glass fabrics

CGSB 4.31-95-CAN/CGSB-1995 毛巾 代替4-GP-31Ma

Terry Towels and Towelling

Serviettes Et Essui-Mains En Tissu Eponge, Sur Rouleau

ARMY MIL-T-47052 NOTICE 2-1995 热硬化性的环氧玻璃织物类压敏粘合剂

This notice should be filed in front of MIL-T-47052(MI),dated 10 May 1974, with Amendment 1, dated 24 March 1978.

TAPE, EPOXY-GLASS CLOTH, THERMOSETTING, PRESSURE SENSITIVE ADHESIVE

DOD A-A-54871-1993 枕头套(可任意试用的白色非纺织织物)

This Commercial Item Description covers a disposable, white, nonwoven pillowcase.

PILLOWCASE (NONWOVEN FABRIC, WHITE, DISPOSABLE)

NAVY MIL-S-18313 G VALID NOTICE 1-1991 尼龙带状织物网,货物吊索

MIL-S-l8313G, dated 11April 1978, has beenr eviewed and determined to be valid for use in acquisition.

SLINGS, CARGO, NET, NYLON WEBBING

NAVY A-A-50532-1990 聚酯或羊毛斜纹哔叽布料织物

Intended use. The cloth is intended for use in the manufacturing of maternity uniforms.

CLOTH, SERGE: POLYESTER/WOOL

ARMY MIL-T-47052 VALID NOTICE 1-1990 热硬化性的环氧玻璃织物类压敏粘合剂

MIL-l+47052(MI), dated 10 May i974, with Amendment 1, dated 24 March 1978, has been reviewed a& determinedto be.valid for use in acquisition.

TAPE, EPOXY-GLASS CLOTH, THERMOSETTING, PRESSURE SENSITIVE ADHESIVE