91.090 外围建筑物 标准查询与下载

GB 4706.68-2008 家用和类似用途电器的安全.住宅用垂直运动车库门的驱动装置的特殊要求

GB 4706.1-2005的该章由下列内容代替： 本部分涉及住宅用垂直开启和关闭的车库门的电驱动装置的安全。其额定电压对于单相器具不超过250V；对于其他器具不超过480V。本部分也包含与电动车库门的运动有关的附加危险。 就实际情况而言，本部分涉及到住宅内和住宅周围所有人员遇到的由器具产生的共同危险。 本部分一般未考虑幼儿玩耍器具的情况，但考虑到儿童可能接触车库门。

Household and similar electric appliances.Safety.Partticular requirements for drives for vertically moving garage doors for residential use

GB 4706.68-2003 家用和类似用途电器的安全 住宅用垂直运动车库门的驱动装置的特殊要求

GB 4706.1—1998的该章用下列内容代替： GB 4706的本部分涉及住宅用垂直开启和关闭的车库门的电驱动装置的安全。其额定电压对于单相器具不超过250V；对于其他器具不超过480V。本部分也包含与电动车库门的运动有关的附加危险。 就实际而言，本部分涉及到住宅内和住宅周围所有人员遇到的由器具产生的共同危险。 本部分一般未考虑幼儿玩耍器具的情况，但考虑到儿童可能接近车库门。

Safety of household and similar electrical appliances--Particular requirements for drives for vertically moving garage doors for residential use

ASTM F3558-24 链式匹克球场围栏标准指南

Standard Guide for Chain-Link Pickleball Court Fences

DB3502/T 118-2023 户外广告和招牌设施设置技术规范

Technical specifications for setting up outdoor advertising and signboard facilities

IEC 60335-2-95-EXV-CMV:2023 家用和类似用途电器.安全.第2-95部分:住宅用垂直移动车库门驱动器的特殊要求

Household and similar electrical appliances - Safety - Part 2-95: Particular requirements for drives for vertically moving garage doors for residential use

T/CECS 10344-2023 绿色装配式边坡防护面层

本文件规定了绿色装配式边坡防护面层的术语和定义，分类与标记，一般要求，要求，试验方法，检验规则，标志及包装、运输、贮存。

Green assembled slope protection surface layer

ASTM F1345-10a(2023) 锌 5% 铝混合稀土合金涂层钢勾花栅栏织物的标准规范

1.1  This specification covers zinc-5 % aluminum-mischmetal (Zn-5A1-MM) alloy-coated steel chain-link fence fabric, Zn-5A1-MM alloy-coated, before weaving. 1.2  The values stated in inch-pound units are to be regarded as the standard. 1.3  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Zinc-5 % Aluminum-Mischmetal Alloy-Coated Steel Chain-Link Fence Fabric

GSO ASTM F1910:2023 长刺带障碍物的标准规范

This specification covers barbed tape materials and configurations used for security barriers. Barbed tape shall be manufactured from stainless and galvanized steel. Stainless steel strip shall be either ferretic or austenitic. Coil loops shall not be kinked, unless it is part of the design.

Standard Specification for Long Barbed Tape Obstacles

T/NDAS 78-2023 道路工程绿化建设规范

本文件规定了道路工程管理绿化建设的一级养护质量标准、道路工程绿化养护管理技术措施及要求等内容。

Road engineering greening construction specifications

T/HSSIA 007-2023 锌钢护栏

4　产品分类 5　要求 6　试验方法 7　检验规则

Zinc steel guardrail

ASTM F567-23 勾花网安装的标准实施规程

1.1 This practice covers the installation procedure for chainlink fence. 1.2 This practice is intended primarily to guide those responsible for or concerned with the installation of chain-link fence. 1.3 This practice does not intend to preclude any practice that has proven equal to or given better performance under varying conditions, that is, location, weather, intended use, materials, etc. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 13. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Practice for Installation of Chain-Link Fence

GSO ASTM F1999:2023 刚性聚氯乙烯 (PVC) 栅栏系统安装的标准实施规程

This practice covers the minimum requirement for and methods of installation for rigid poly(vinyl chloride) (PVC) fencing systems and fence accessories, it is intended to guide those responsible for or concerned with installation of rigid (PVC) fence systems. The procedure for installation of posts, installation of rails and section, installation of post caps and picket tops, and installation of gates on posts are presented in details.

Standard Practice for Installation of Rigid Poly(Vinyl Chloride) (PVC) Fence Systems

T/CUPTA 022-2023 公交场站充电设施工程建设及验收规范

本文件规定了公交场站充电设施工程建设和验收的总体标准以及建设规划、工程施工、建设验收等标准。 本文件适用于城市公交首末站、公交停车场、综合交通枢纽站等既有和新建场站的充电基础设施规划、建设及验收。

Specifications for the construction and acceptance of charging facilities at bus stations

GSO ASTM F537:2023 木材及相关材料建造的栅栏的设计、制造和安装标准规范

This specification covers the design, fabrication, and installation practices for wood fences, including fences combined with wood and other materials, that are based on fundamental construction principles combined with long-standing traditional fence building skills. This specification also provides a systematic method of purchase, inspection with basis for rejection, and certification of manufactured wood fences by the fence industry. The generic classifications for wood fencing covered here are the rail fences (Type I), board fences (Type II), picket fences (Type III), and solid panel fences (Type IV).

Standard Specification for Design, Fabrication, and Installation of Fences Constructed of Wood and Related Materials

T/SCDA 116-2023 装配整体式混凝土结构预制构件生产安装及验收标准

在混凝土预制构件的制作、材料选用及预制安装设备选用、安装要求等项目进行深化

Standards for production, installation and acceptance of prefabricated components of assembled monolithic concrete structures

ASTM F1184-23 工业和商业水平滑动闸门标准规范

Standard Specification for Industrial and Commercial Horizontal Slide Gates

ASTM F1184-23e1 工业和商业水平滑动闸门标准规范

1.1 This specification covers detailed requirements for rolling, cantilever and overhead slide gates, gate posts, and accessories for industrial and commercial applications. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Industrial and Commercial Horizontal Slide Gates

ASTM F2408-16(2023) 使用镀锌钢管镐的装饰围栏标准规范

1.1 This specification establishes the minimum requirements for coated tubular picket ornamental fence systems fabricated from galvanized steel components. 1.2 The requirements of this specification do not apply to vertical bar fence systems utilizing solid bar or wrought iron materials. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Ornamental Fences Employing Galvanized Steel Tubular Pickets

T/GDJSKB 009-2022 机场建筑围护结构抗风技术标准

总则、术语和符号、基本规定、风荷载、幕墙抗风设计、金属屋面抗风设计、门窗抗风设计、风洞试验、抗风性能检测与监测、施工与验收、维护等。

Technical standard for wind resistance of airport building envelope

ASTM F1910-98(2022) 长倒钩带障碍物标准规范

1.1 This specification covers barbed tape materials and configurations used for security barriers. 1.2 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Specification for Long Barbed Tape Obstacles