ISO 1996-1:2003
声学 环境噪声的描述、测量和评价 第1部分:基本参量和评价方法

Acoustics - Description, measurement and assessment of environmental noise - Part 1: Basic quantities and assessment procedures

被代替

标准号

ISO 1996-1:2003

发布

2003年

中文版

GB/T 3222.1-2006 (等同采用的中文版本)

发布单位

国际标准化组织

替代标准

ISO 1996-1:2016

当前最新

ISO 1996-1:2016

 

 

引用标准

IEC 61672-1

适用范围

This part of ISO 1996 defines the basic quantities to be used for the description of noise in community environments and describes basic assessment procedures. It also specifies methods to assess environmental noise and gives guidance on predicting the potential annoyance response of a community to long-term exposure from various types of environmental noises. The sound sources can be separate or in various combinations. Application of the method to predict annoyance response is limited to areas where people reside and to related long-term land uses. Community response to noise can vary differently among sound sources that are observed to have the same acoustic levels. This part of ISO 1996 describes adjustments for sounds that have different characteristics. The term “rating level” is used to describe physical sound predictions or measurements to which one or more adjustments have been added. On the basis of these rating levels, the long-term community response can be estimated. The sounds are assessed either singly or in combination, allowing for consideration, when deemed necessary by responsible authorities, of the special characteristics of their impulsiveness, tonality and low-frequency content, and for the different characteristics of road traffic noise, other forms of transportation noise (such as aircraft noise) and industrial noise. This part of ISO 1996 does not specify limits for environmental noise. NOTE 1 In acoustics, several different physical measures describing sound can have their level expressed in decibels (e.g. sound pressure, maximum sound pressure, equivalent continuous sound pressure). The levels corresponding to these physical measures normally will differ for the same sound. This often leads to confusion. Therefore, it is necessary to specify the underlying physical quantity (e.g. sound pressure level, maximum sound pressure level, equivalent continuous sound pressure level). NOTE 2 In this part of ISO 1996, quantities are expressed as levels in decibels. However, some countries validly express the underlying physical quantity, such as maximum sound pressure in pascals, or sound exposure in pascalsquared seconds. NOTE 3 ISO 1996-2 deals with the determination of sound pressure levels.

推荐

谁引用了ISO 1996-1:2003 更多引用