75.160.10 固体燃料 标准查询与下载
共找到 1886 条与 固体燃料 相关的标准，共 126 页
Solid recovered fuels - Determination of calorific value (ISO 21654:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-15
- 实施
- 2021-09-15
Solid recovered fuels – Determination of elemental composition by X-ray fluorescence (ISO 22940:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-13
- 实施
- 2021-09-13
Solid recovered fuels. Determination of elemental composition by X-ray fluorescence
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-10
- 实施
- 2021-09-10
Solid recovered fuels – Determination of elemental composition by X-ray fluorescence
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-08
- 实施
- 2021-09-08
Coke. Determination of bulk density in a small container
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-08
- 实施
- 2021-09-08
1.1 This test method covers the analysis of the commonly determined major and minor elements in ash from coal using X-ray fluorescence (XRF) techniques. NOTE 1—Test Method D5016 is used for determination of sulfur. NOTE 2—Although not included in the present method, the determination of barium, strontium, and manganese may be required to yield adequate totals. 1.2 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Major and Minor Elements in Coal Ash By X-Ray Fluorescence
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-01
- 实施
1.1 This test method covers a procedure for the analysis of the commonly determined major and minor elements in coal, coke, and solid residues from combustion of coal and coke. These residues may be laboratory ash, bottom ash, fly ash, flue gas desulfurization sludge, and other combustion process residues. NOTE 1—There are two interlaboratory studies associated with this test method. The first was conducted in 1997 (RR:D05-1035)2 and the second was conducted in 2007 (RR:D05-1032).3 Sulfur trioxide was only included in the 2007 study, and that study only included combustion residues derived from ash and no combustion residues derived from coke. 1.2 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Determination of Major and Minor Elements in Coal, Coke, and Solid Residues from Combustion of Coal and Coke by Inductively Coupled Plasma—Atomic Emission Spectrometry
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-01
- 实施
The method should be useable for all SRF and will make it possible to obtain a representative sample from a large stock of SRF.
Solid recovered fuels - Methods for sampling (ISO 21645:2021); German version EN ISO 21645:2021
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-00
- 实施
Solid recovered fuels - Determination of elemental composition by X-ray fluorescence (ISO 22940:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-09-00
- 实施
This document specifies the procedure for a determination of major and minor element concentrations in solid recovered fuel material by energy-dispersive X-ray fluorescence (EDXRF) spectrometry or wavelength-dispersive X-ray fluorescence (WDXRF) spectrometry using a calibration with solid recovered fuel reference materials or solid recovered fuel samples with known content. A semiquantitative determination can be carried out using matrix independent standards. This document is applicable to the following elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Br, Mo, Cd, Sb, Sn, Tl and Pb. Concentration levels between approximately 0,0001 % and 100 % can be determined depending on the element, the calibration materials used and the instrument used. NOTE X-ray fluorescence spectrometry can be used as a fast method for a qualitative overview of elements and impurities and after suitable calibration it is very useful for determining major elements or even minor elements (except Hg) in order to quickly identify increased concentrations of minor elements in solid recovered fuels (SRF), for example during SRF-production.
Solid recovered fuels — Determination of elemental composition by X-ray fluorescence
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-25
- 实施
Solid recovered fuels -- Determination of the content of volatile matter (ISO 22167:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-25
- 实施
- 2021-08-25
Solid recovered fuels -- Determination of ash content (ISO 21656:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-24
- 实施
- 2021-08-24
Solid recovered fuels -- Determination of moisture content using the oven dry method -- Part 3: Moisture in general analysis sample (ISO 21660-3:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-24
- 实施
- 2021-08-24
Solid recovered fuels -- Safe handling and storage of solid recovered fuels (ISO 21912:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-24
- 实施
- 2021-08-24
Solid recovered fuels - Specifications and classes (ISO 21640:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-16
- 实施
- 2021-08-16
Solid recovered fuels - Safe handling and storage of solid recovered fuels (ISO 21912:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-15
- 实施
- 2021-08-15
Solid recovered fuels - Determination of ash content (ISO 21656:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-15
- 实施
- 2021-08-15
Solid recovered fuels - Determination of the content of volatile matter (ISO 22167:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-15
- 实施
- 2021-08-15
Solid recovered fuels - Determination of moisture content using the oven dry method - Part 3: Moisture in general analysis sample (ISO 21660-3:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-15
- 实施
- 2021-08-15
Solid recovered fuels - Determination of calorific value (ISO 21654:2021)
- ICS
- 75.160.10
- CCS
- 发布
- 2021-08-00
- 实施
- 2021-08-01
