C82 防火技术 标准查询与下载

EN 1366-1:2014 服务设施的耐火试验.第1部分:管道

This European Standard specifies a method for determining the fire resistance of vertical and horizontal ventilation ducts including those access panels, which are integral part of the tested ducts. The test examines the behaviour of ducts exposed to fire from the outside (duct A) and fire inside the duct (duct B). This European Standard is used in conjunction with EN 1363-1. Annex A provides general guidance and gives background information. This European Standard is not applicable to: a) ducts whose fire resistance depends on the fire resistance performance of a ceiling or wall (where ducts are located in cavities enclosed by fire-resistant shafts or ceilings); b) ducts containing fire dampers at points where they pass through fire separations; c) one, two or three sided ducts; d) fixing of suspension devices (e. g. anchors) to floors or walls.

Fire resistance tests for service installations - Part 1: Ventilation ducts

ISO 7240-15:2014 火灾探测和警报系统. 第15部分: 利用烟雾和热量传感器的点型火灾探测器

This part ofISOO 7240 specifies reduirements, test methods, and performance criteria for pointrtype fire detectors using Smoke and heat sensors, incorporating in one mechanical enclosure at least one Smoke SenSsor and at least one other Sensor which responds to heat and in which the signal(s) of the Smoke Sensor(Sj is (are) combined with the signal(s) ofthe heat sensor(S). The performance of a single Sensor within the detector covered by this part of ISO 7240 cannot be sufficient for conformity to other parts of ISO 7240 for the single sensor detector. Certain types of detectors can contain radioactive materials. The national requirements for radiation protection differ from country to country and they are not therefore specified in this standard. Howeven Such detectors are expected to conform to the national reduirements and be in line with the recommendations ofthe Nuclear EnergyAgency (NEA)] ofthe Organization for Economic Co-operation and Development (OECD)D， For the testing of other types of detectors, or detectors working on different principles, this part of risks, are not covered in this partofIS907240.

Fire detection and alarm systems - Part 15: Point-type fire detectors using smoke and heat sensors

BS PD ISO/TR 17755:2014 防火安全. 全国火灾统计实践概述

Fire safety. Overview of national fire statistics practices

UL 2846-2014 可见火焰和烟气特性用水分布水暖塑料管着火点试验的UL安全要求 (第一版)

UL Standard for Safety Fire Test of Plastic Water Distribution Plumbing Pipe for Visible Flame and Smoke Characteristics (First Edition; Reprint with Revisions Through and Including December 20, 2016)

DIN 14096:2014 火灾预防措施规定. 起草和公布规则

Fire precaution regulation - Rules for drafting and placarding

GA 1157-2014 消防技术服务机构设备配备

本标准规定了消防技术服务机构设备配备的术语和定义、设备分类和配备级别、配备要求、设备的管理与维护等内容。本标准适用于消防技术服务机构的设备配备,以及公安机关消防机构依法对其实施的监督管理活动。

Equipment configuration for fire protection technical service providers

DIN SPEC 14507-2:2014 指挥和控制设备.第2部分:指挥和控制车ELW 1

Command and control appliances - Part 2: Command and control car ELW 1

ISO 7240-12:2014 火灾探测和警报系统. 第12部分: 利用传输光束的线型感烟探测器

Fire detection and alarm systems - Part 12: Line type smoke detectors using a transmitted optical beam

UL 486F-2014 安全的裸露和覆盖套圈的UL标准 (第一版)

UL Standard for Safety Bare and Covered Ferrules (First Edition; Reprint with Revisions Through and Including August 7, 2015)

EN 1364-4:2014 非承重构件的防火测试.第4部分:幕墙部分配置

This European Standard specifies a method for determining the fire resistance of parts of curtain walling and of the perimeter seal. It examines the fire resistance to internal and external fire exposure of:- the spandrel panel, i.e. downstand, upstand or a combination thereof, or; - the perimeter seal, or; - the fixing of the framing system (anchoring) used to attach the curtain walling to the floor element, or; - combinations thereof. Results from tests according to this standard form the basis for classification of curtain walling type A (see 3.3 for definition). For curtain walling type B (see 3.4 for definition) results may be used to determine fire resistance of parts of a curtain walling to increase the field of application when previously tested to EN 1364-3. For intended classification EW and for corner/faceted specimens EN 1364-3 should be used. This European Standard does not cover double skin façades, over-cladding systems and ventilated façade systems on external walls. It does not deal with the reaction to fire behaviour of curtain walling. This standard is intended to be read in conjunction with EN 1363-1 and EN 1363-2 as well as EN 1364-3 for curtain walling type B. NOTE Annex A gives informative guidance on the principles of testing parts of curtain walling and the test method.

Fire resistance tests for non-loadbearing elements - Part 4: Curtain walling - Part configuration

GA 1131-2014 仓储场所消防安全管理通则

本标准规定了仓储场所消防安全管理的一般要求、消防安全职责、消防安全检查、储存管理、装卸安全管理、用电安全管理、用火安全管理、消防设施和消防器材管理、氨制冷储存场所管理、石油库管理、棉花储存场所管理、粮食储存场所管理等。本标准适用于既有仓储场所,不适用于炸药仓库、花炮仓库。

General rules for fire safety management of storage occupancies

EN 1364-3:2014 非承重构件的防火测试.第3部分:幕墙（全配置完成组装）

This European Standard specifies a method for determining the fire resistance of curtain walling - full configuration. This European Standard is used in conjunction with EN 1363-1. NOTE Annex B gives further information on the test method. The test method is applicable to curtain walling type B (for definition see 3.4). The test is not appropriate for testing curtain walling type A (for definition see 3.3). The fire resistance of curtain walling may be determined under internal or external exposure conditions. In the latter case the external fire exposure curve given in EN 1363-2 may be used, subject to deviating national regulations. Tests on individual parts of a curtain walling (e. g. perimeter seal, infill panel or fixing of the framing system (anchoring) used to attach the curtain walling to the floor element) or systems with fire resistance requirements only to the spandrel area may be performed using EN 1364-4. For vertical linear gap seals, this part of the standard applies. This European Standard does not cover double skin façades, over-cladding systems and ventilated façade systems on external walls. It does not deal with the reaction to fire behaviour of curtain walling. This standard is intended to be read in conjunction with EN 1363-1 and EN 1363-2.

Fire resistance tests for non-loadbearing elements - Part 3: Curtain walling - Full configuration (complete assembly)

EN 1634-1:2014 门,卷帘,可开启窗户防火和烟雾控制测试和建筑五金件.第1部分:门,卷帘,可开启窗户防火

This European Standard specifies a method for determining the fire resistance of door and shutter assemblies and openable windows designed for installation within openings incorporated in vertical separating elements, such as: a) hinged and pivoted doors; b) horizontally sliding and vertically sliding doors including articulated sliding doors and sectional doors; c) folding doors, sliding folding doors /shutters; d) tilting doors; e) rolling shutter doors; f) openable windows; g) operable fabric curtains. This European Standard is used in conjunction with EN 1363-1. The testing of fire dampers is covered by EN 1366-2. The testing of closures for conveyor systems is covered by EN 1366-7. By prior agreement with the test sponsor, additional information may be gained for individual elements of building hardware in order to fulfil the performance criteria identified in EN 1634-2. Based on the observations recorded during the test, the results may be presented in a separate report which should be in accordance with the requirements of EN 1634-2.

Fire resistance and smoke control tests for door and shutter assemblies@ openable windows and elements of building hardware - Part 1: Fire resistance test for door and shutter assemblies and openable windows (Incorporates Amendment A1: 2018)

DB11/ 1026-2013 吸气式感烟火灾探测报警系统设计、施工及验收规范

Code for design, construction and acceptance of aspirating smoke detection and alarm system

DB11/ 1023-2013 疏散用门安全控制与报警逃生门锁系统设计、施工及验收规程

Regulations for design, construction and acceptance of evacuation door safety control and alarm escape door lock system

EN 16081:2011+A1:2013 高压氧舱.对消防系统的特殊要求.性能,安装和测试

This European Standard is applicable to the performance and safety requirements of fire extinguishing systems and their associated test methods for multi-place chambers designed for pressures in excess of ambient atmospheric pressure and employed in medical installations for therapeutic purposes, in the following referred to as chambers.

Hyperbaric chambers - Specific requirements for fire extinguishing systems - Performance, installation and testing

BS 7346-7:2013 烟和热控制系统部件.有顶棚停车场烟和热控制系统的功能建议和计算方法的实施规程

This part of BS 7346 gives guidance on functional recommendations and calculation methods for smoke and heat control systems for covered parking areas for cars and light commercial vehicles.

Components for smoke and heat control systems. Code of practice on functional recommendations and calculation methods for smoke and heat control systems for covered car parks

NF X65-023:2013 不同物理火灾模型和比例之间有毒气体数据对照导则

Guidance for comparison of toxic gas data between different physical fire models and scales

NF S61-970:2013 安装火灾探测系统(SDI)的规则

Règles d'installation des Systèmes de Détection Incendie (SDI)

ANSI/UL 300-2013 商用烹饪设备保护用消防系统火灾试验的安全性标准

Standard for Safety for Fire Testing of Fire Extinguishing Systems for Protection of Commercial Cooking Equipment