G44 胶乳制品 标准查询与下载

DIN ISO 2004:2012 天然浓缩胶乳. 离心或膏化, 氨保存类型. 规范(ISO 2004-2010)

Natural rubber latex concentrate - Centrifuged or creamed, ammonia-preserved types - Specifications (ISO 2004:2010)

HG/T 2487-2011 橡胶胶丝试验方法

Rubber thread test method

HG/T 2889-2011 胶乳胶丝

本标准规定了胶乳胶丝的技术要求、试验方法、检验规则及标识、包装、运输和贮存。 本标准适用于以天然胶乳为原料制成的圆形单丝和并带乳胶丝。

Latex thread

ASTM E1731-11 清洗房间手套上的非挥发性残留物重力测定用标准试验方法

The NVR obtained by this test method is that amount which is available for release by the gloves onto handled surfaces. Evaporation of solvent at the stated temperature is to quantify the NVR that can be expected to exist at room temperature, since the slight difference between room temperature and the test temperature is not likely to result in significant variances. This method may be more aggressive than necessary to determine the suitability of cleanroom gloves that are restricted to dry operations only. Various other methods exist for determining NVR, for example Practice G120 and IES-RP-CC005. This test is not intended to replace test methods used for other purposes.1.1 This test method covers the determination of solvent extractable nonvolatile residue (NVR) from gloves used in cleanrooms where spacecraft are assembled, cleaned, or tested. 1.2 The NVR of interest is that which can be extracted from gloves using a specified solvent that has been selected for its extracting qualities, or because it is representative of solvents used in the particular facility. Alternative solvents may be used, but since their use may result in different values being generated, they must be identified in the procedure data sheet. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves

HG/T 2888-2010 橡胶家用手套

本标准规定了橡胶家用手套的抽样和试样选择、要求、试验方法以及标识、包装、运输和贮存的方法。手套的安全和正确使用方法不在本标准范围之内。 本标准适用于以橡胶胶乳为主体材料制成的可作为家用的绒里及光里手套。

Rubber household gloves

KS M ISO 10282:2009 一次性无菌外科橡胶手套的规范

이 표준은 환자와 사용자 간의 오염을 방지하기 위하여 수술과정에 사용되는 멸균 포장된 고무

Single-use sterile rubber surgical gloves-Specification

ISO 25518:2009 一次性使用橡胶手套.技术规范

Single-use rubber gloves for general applications - Specification

KS M ISO 4074:2009 天然乳胶避孕套.要求和试验方法

이 표준은 성병 예방과 피임을 목적으로 소비자에게 공급되는 천연 라텍스 고무로 만들어진 콘

Natural latex rubber condoms-Requirements and test methods

KS M ISO 16037:2008 临床试验用橡胶避孕套.物理特性的测量

이 표준은 콘돔으로 임상 조사를 수행하는 연구원을 위한 지침으로 의도된 것이다. 사용된 콘

Rubber condoms for clinical trials-Measurement of physical properties

DIN EN ISO 4074 Berichtigung 2:2008 天然橡胶避孕套.要求和试验方法.技术勘误DIN EN ISO 4074-2002

Natural rubber latex condoms - Requirements and test methods (ISO 4074:2002); German version EN ISO 4074:2002, Corrigendum to DIN EN ISO 4074:2002-07; German version EN ISO 4074:2002/AC:2008

ASTM D6736-08(2013) 乳胶漆耐磨光性的标准试验方法

5.1 Interior flat paints may become burnished in areas where clothing or upholstered furniture rub against a wall. This rubbing may cause a smoother, glossier surface at the contacted area, depending on the level or type of pigments in the paint and binder hardness. This method permits a more quantitative estimate of burnish resistance than those using manual rubbing techniques. 1.1 This test method covers a procedure for measuring the resistance of latex paints to burnishing under dry conditions. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Burnish Resistance of Latex Paints

KS M ISO 12243:2007 医用天然胶乳手套.用改良的半细胞法测定水可萃取蛋白质

이 규격은 의료용 천연고무 장갑 내의 수용성 단백질의 양을 측정하기 위한 시험방법에 대하여

Medical gloves made from natural rubber latex－Determination of water-extractable protein using the modified Lowry method

SN/T 1819-2006 进出口医用手套中胶乳蛋白质的测定.改进的Lowry法

本标准规定了医用手套中胶乳蛋白质含量的测定方法。 本标准适用于医用手套中胶乳蛋白质含量的测定。 本标准胶乳蛋白质含量的测定范围：7μg/dm～200μg/dm。

Determination of latex protein in medical gloves for import and export.Modified Lowry method

NY/T 1037-2006 天然胶乳 表观黏度的测定 旋转粘度计法

警告：使用本标准的人员应该熟悉正规实验室的操作规程。本标准无意涉及因使用本标准可能出现的所有安全问题。使用者应制定相应的安全和健康细则，并确保符合国家有关法规规定。 本标准规定了用L型旋转黏度计测定天然乳胶黏度的方法。 本标准适用于天然乳胶黏度的测定，也适用于以天然乳胶为原料制备的特种乳胶表现黏度的测定。

Natural rubber latex-Determination of apparent viscosity by the Brookfield test

NY/T 1038-2006 天然生胶初加工原料 凝胶 验收方法

本标准规定了天然生胶初加工原料--凝胶的外观分级及其含胶量的测定。

Material for primary processing.Natural coagulate rubber.Method of check and accept

ASTM D4026-06 橡胶胶乳的标准试验方法.苯乙烯-丁二烯共聚物.残留苯乙烯测定

The amount of residual styrene (unreacted styrene) in an SBR latex must be studied from health, safety, economic, and environment viewpoints. This test method is useful in studying these aspects of residual styrene and also in research, development, and factory processing problems. 1.1 This test method covers the determination of the residual styrene content of styrene butadiene (SBR) latex. This test method is based upon direct injection of a diluted latex into a gas chromatograph. The amount of residual styrene is calculated using an internal standard technique.1.2 The range of residual styrene covered is approximately 100 to 3000 mg/kg (ppm) with a lower detection limit of approximately 50 mg/kg (ppm).1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific safety statements, see Section 8.)

Standard Test Method for Rubber Latex8212;Styrene-Butadiene Copolymer8212;Determination of Residual Styrene

SN/T 1532-2005 出口橡胶气球检验规程

本标准规定了出口橡胶气球的技术要求、抽样、检验和检验结果的判定。 本标准适用于10g以下出口橡胶气球的检验。

Rule for the inspection of latex balloon for export

ASTM D6324-05 合成材料制男性避孕套的标准试验方法

New polymer materials for male condoms are being developed. This standard is intended to describe the test methods whose results shall adequately describe the design and the quality of the condoms. These test methods are not intended to be design or material restrictive. The design requirements for each material are unique to that material and shall be validated prior to use.p>1.1 These test methods cover and shall be used to evaluate male condoms made of various synthetic materials. These test methods also describe the minimum inspection and quality levels that shall be utilized in referee tests. It is not intended to be a routine quality control specification for synthetic condom manufacturing operations.1.2 These test methods are intended to assist buyers in obtaining synthetic condoms of consistent quality. The safe and proper use of synthetic condoms is excluded from the scope of these test methods.1.3 The annexes in these test methods include important information, such as that on apparatus or materials, that is a mandatory part of these test methods but too detailed for inclusion in the main text.1.4 The appendixes in these test methods contain information intended to provide guidance.1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Male Condoms Made from Synthetic Materials

ASTM D3578-05 橡胶检查手套的标准规范

1.1 This specification describes certain requirements for natural rubber gloves used in conducting medical examinations and diagnostic and therapeutic procedures. It also covers natural rubber gloves used in handling contaminated medical material.1.2 This specification provides for natural rubber gloves that fit either hand, paired gloves, and gloves by size. It also provides for packaged sterile natural rubber gloves and packaged or bulk nonsterile natural rubber gloves.

Standard Specification for Rubber Examination Gloves

ASTM D6978-05 防化学理疗药物渗透的医用手套的评定的标准实施规程

The objective of this practice is to provide a uniform procedure for assessing the resistance of medical glove materials to permeation by chemotherapy drugs, and to establish a consistent reporting of the test data.1.1 This practice covers a protocol for the assessment of resistance of medical glove materials to permeation by potentially hazardous cancer chemotherapy drugs under conditions of continuous contact. An assessment is made based on the permeation (breakthrough) of nine chemotherapy drugs through the glove material over a certain period of time.1.2 It is emphasized that the conditions used in this assessment are intended to approximate the worst-case condition for clinical uses. The data should be restricted to use on a relative basis when comparing glove materials.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Assessment of Resistance of Medical Gloves to Permeation by Chemotherapy Drugs