G44 胶乳制品 标准查询与下载

HG/T 2487-2003 橡胶胶丝-试验方法

本标准规定了测定胶丝的某些物理和机械性能的试验方法。由于胶丝截面较小，而且这种材料的使用条件特殊，所以制定了某些专用的试验方法。 本标准中的某些试验，不完全适用于合成橡胶制成的胶丝，例如聚氨酯橡胶。这些试验供天然橡胶或合成的聚异戊二烯橡胶使用。必须指出，比较只可以在新胶丝上或与这些加工过程相同的胶丝上进行。从经过缠绕成型或其他生产过程的胶丝得出的试验结果进行分析时，必须记住过去的加工过程是非常重要的，并且要将所知道的以及所使用的松弛处理都在试验报告中说明。

Rubber threads-Methods of test

DIN EN 374-1:2003 耐化学腐蚀和微生物的防护手套.第1部分:术语和性能要求

The document specifies the requirements for gloves to protect the user against chemicals and/or micro-organisms and defines terms to be used. It should be used in conjunction with EN 420. It does not specify requirements for protection against any mechanical hazards.

Protective gloves against chemicals and micro-organisms - Part 1: Terminology and performance requirements; German version EN 374-1:2003

DIN EN 374-2:2003 耐化学腐蚀和微生物的防护手套.第2部分:耐渗透性的测定

This document specifies a test method for the penetration resistance of gloves that protect against chemicals and/or micro-organisms. At this time it is believed that gloves which resist penetration, when tested according to this part of EN 374, will form an effective barrier to micro-biological hazards.

Protective gloves against chemicals and micro-organisms - Part 2: Determination of resistance to penetration; German version EN 374-2:2003

DIN EN 374-3:2003 耐化学腐蚀和微生物的防护手套.第3部分:耐化学品渗透性的测定

This European Standard specifies the determination of the resistance of protective glove materials to permeation by potentially hazardous non-gaseous chemicals under the condition of continuous contact. It is emphasized that the test does not represent conditions likely to be found in service, and the use of test data should be restricted to comparing materials chiefly on a relative basis in broad categories of breakthrough times.#,,#

Protective gloves against chemicals and micro-organisms - Part 3: Determination of resistance to permeation by chemicals; German version EN 374-3:2003

ISO 12243:2003 医用天然胶乳手套.用改良的半细胞法测定水可萃取蛋白质

This International Standard specifies a method for the determination of the amount of water-extractable protein in natural rubber (NR) gloves for medical use. The method is potentially suitable for the determination of extractable protein in other articles made from NR latex; however the extraction procedures and times have not been validated and will vary with the type of article to be tested. Other methods for the determination of specific proteins in medical gloves exist (see Annex C) but they are not of general applicability. This International Standard is concerned solely with the method of assay. It is not concerned with sampling nor does it purport to address the safety implications of the values obtained or requirements for labelling.

Medical gloves made from natural rubber latex - Determination of water-extractable protein using the modified Lowry method

ASTM D6976-03 橡胶避孕套标准规范.阴道膜

1.1 This specification covers requirements for contraceptive vaginal diaphragms, hereafter called diaphragms.1.2 Vaginal barrier devices known as cervical caps, vaginal sponges and female condoms are not included in this specification.

Standard Specification for Rubber Contraceptives8212;Vaginal Diaphragms

ISO 10282:2002 一次性使用灭菌橡胶外科手套.规范

This International Standard specifies requirements for packaged sterile rubber gloves intended for use in surgical procedures to protect the patient and the user from cross-contamination. It is applicable to single-use gloves that are worn once and then discarded. It does not apply to examination or procedure gloves. It covers gloves with smooth surfaces and gloves with textured surfaces over part or all of the glove. This standard is intended as a reference for the performance and safety of rubber surgical gloves. The safe and proper usage of surgical gloves and sterilization procedures with subsequent handling, packaging and storage procedures are outside the scope of this International Standard.

Single-use sterile rubber surgical gloves - Specification

DIN EN ISO 4074:2002 天然橡胶避孕套.要求和试验方法 (ISO 4074:2002); 德文版本 EN ISO 4074:2002

This Standard specifies the minimum requirements and test methods to be used for condoms made from natural rubber latex which are supplied to consumers for contraceptive purposes and to assist in the preparation of sexually transmitted infections.

Natural latex condoms - Requirements and test methods (ISO 4074:2002); German version EN ISO 4074:2002

ISO 16037:2002 临床试验用橡胶避孕套.物理特性的测量

This International Standard is intended as a guideline for clinical researchers working with condoms. It suggests a series of laboratory tests to be conducted on the products to be used in any clinical investigation, so that it will be easier to relate the clinical results to the design and quality of the condoms used. This International Standard is not applicable to the design of clinical investigations.

Rubber condoms for clinical trials - Measurement of physical properties

BS EN ISO 4074:2002 天然乳胶阴茎套.要求和试验方法

NOTE—In addition to terms used in two of the three official ISO languages (English and French), this International Standard gives the equivalent terms in the German language; these are published under the responsibility of the member body for Germany (DIN). However only the terms given in the official languages can be considered as ISO terms.

Natural latex rubber condoms - Requirements and test methods

ISO 4074:2002 天然乳胶避孕套.要求和试验方法

This International Standard specifies the minimum requirements and the test methods to be used for condoms made from natural rubber latex which are supplied to consumers for contraceptive purposes and to assist in the prevention of sexually transmitted infections.

Natural latex rubber condoms - Requirements and test methods

ASTM D4570-02(2007) 橡胶加工用化学药品的试验方法:筛分法测定硫的粒度分布

This test method is used to evaluate sulfur for suitability as a rubber vulcanizing agent. Sulfur particles must be small enough to dissolve in rubber during cure to produce a uniform network of cross-links. This test method is used as a quality control method to ensure that large particles are not present (and to determine if the sulfur follows a typical pattern for size distribution).1.1 This test method covers the particle size measurement of the coarse fraction of ground sulfurs. It is limited to measurement of particles greater than 45 μm (No. 325 sieve). If the sulfur is very fine and the screens become plugged by the caking of the sulfur, it may be necessary to use a wet sieve procedure instead. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Rubber Chemicalsx2014;Determination of Particle Size of Sulfur by Sieving (Dry)

ASTM D120-02a(2006) 橡胶隔热手套的标准规范

1.1 This specification covers manufacturing and testing of rubber insulating gloves for protection of workers from electrical shock.1.2 Two types of gloves are provided and are designated as Type I, non-resistant to ozone, and Type II, resistant to ozone.1.3 Six classes of gloves, differing in electrical characteristics, are provided and are designated as Class 00, Class 0, Class 1, Class 2, Class 3, and Class 4.1.4 The values stated in SI units are to be regarded as the standard. See ASTM SI 10.The following safety hazards caveat pertains only to the test method portion, Sections 16, 17, 18, and 19, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.For specific precaution statements, see 18.2.

Standard Specification for Rubber Insulating Gloves

ASTM D4679-02 一般用途、家用或护肤用橡胶手套的标准规范

1.1 This specification covers requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported and unlined, intended for household, beautician use, or general use.1.2 This specification is intended to serve as a guide to permit obtaining gloves of consistent performance. The safe and proper use of gloves is excluded from the scope of this specification.1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Rubber General Purpose, Household or Beautician Gloves

ASTM D4679-02(2007) 一般用途、家用或护肤用橡胶手套的标准规范

1.1 This specification covers requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported with or without a flock lining, intended for household, beautician use, or general use.1.2 This specification is intended to serve as a guide to permit obtaining gloves of consistent performance. The safe and proper use of gloves is excluded from the scope of this specification.The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Rubber General Purpose, Household or Beautician Gloves

ARMY MIL-R-46082 B NOTICE 2-2001 厌氧型单成分固持胶

This notice should be filed in front of MIL-R-46082B, dated 10 June 1983.

RETAINING COMPOUNDS, SINGLE COMPONENT, ANAEROBIC

DIN EN 455-2:2001 一次性医用手套.第2部分:物理特性要求和检测(包括技术勘误1-1996)

This document specifies requirements and gives test methods for physical properties of single-use medical gloves (i.e. surgical gloves and examination/procedure gloves) in order to ensure that they provide and maintain in use an adequate level of protection from cross contamination for both patient and user.

Medical gloves for single use - Part 2: Requirements and testing for physical properties (including Technical Corrigendum 1:1996); German version EN 455-2:2000

DIN EN 455-1:2001 一次性医用手套.第1部分:密封性要求和检验

Medical gloves for single use - Part 1: Requirements and testing for freedom from holes; German version EN 455-1:2000

ASTM D4679-01 一般用途、家用或护肤用橡胶手套的标准规范

1.1 This specification covers requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported and unlined, intended for household, beautician use, or general use.1.2 This specification is intended to serve as a guide to permit obtaining gloves of consistent performance. The safe and proper use of gloves is excluded from the scope of this specification.1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Rubber General Purpose, Household or Beautician Gloves

ASTM D3772-01 橡胶指套标准规范

1.1 This specification covers the requirements for finger cots made from natural rubber latex. The purpose of this specification is to obtain consistent performance among products produced in various locations or at various times in the same location.1.2 This specification does not cover the safe and proper use of finger cots or products of special construction for special use.1.3 The values stated in SI units are to be regarded as the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Natural Rubber Finger Cots