H32 焦炭 标准查询与下载

ISO 687:2010 固体矿物燃料.焦炭.一般分析试样中水分的测定

This International Standard specifies a method for determining the moisture in the general analysis test sample of coke. It can be used for the determination of moisture in blast-furnace coke, foundry-coke and other high-temperature carbonization products.

Solid mineral fuels - Coke - Determination of moisture in the general analysis test sample

SANS 567:2007 焦炭．散密度小型容器测定方法

Specifies a method for the determination of the bulk density of coke in a cubical container of capacity 0.2 cubic metres. It is applicable to coke with a nominal top size not greater than 125mm.

Coke - Determination of bulk density in a small container

SANS 520:2007 焦炭（粒度大于20mm） 机械强度测定方法

A sample of coke greater than 20 mm in size and of known size distribution is subjected to mechanical stresses in a rotating drum. The degree of breakdown of the coke is evaluated by a process of sieving and size analysis after 100 drum revolutions (Micu

Coke (greater than 20 mm in size) - Determination of mechanical strength

BS ISO 18894:2006 焦炭.焦炭活性指数(CRI)和活化后焦炭浓度(CSR)的测定

ISO 18894:2006 specifies the equipment and techniques used for determining lump-coke (> 20 mm) reactivity in carbon dioxide gas at elevated temperatures and its strength after reaction in carbon dioxide gas by tumbling in a cylindrical chamber.

Coke - Determination of coke reactivity index (CRI) and coke strength after reaction (CSR)

ISO 18894:2006 焦炭.焦炭活性指数(CRI)和活化后焦炭浓度(CSR)的测定

This International Standard specifies the equipment and techniques used for determining lump-coke (> 20 mm) reactivity in carbon dioxide gas at elevated temperatures and its strength after reaction in carbon dioxide gas by tumbling in a cylindrical chamber.

Coke - Determination of coke reactivity index (CRI) and coke strength after reaction (CSR)

YB/T 4138-2005 焦粉和小颗粒焦炭

本标准规定了粒度小于10mm的焦粉和粒度10mm～25mm小颗粒焦炭的产品分类、技术要求、试验方法、检验规则、标志、包装、运输、贮存和一般要求。 本标准适用于高温干馏方法生产的焦炭。

Coke breeze and nut coke

SANS 579:2005 焦炭．总水分测定方法

Specifies a method for determining the total moisture of coke. It can be used for the determination of moisture of blast-furnace coke, foundry coke and other high-temperature carbonization products.

Coke - Determination of total moisture

ASTM D5061-05 显微测定冶金焦中结构组分的标准试验方法

1.1 This test method covers the equipment and procedures used for determining the types and amounts of coke carbon forms and associated recognizable coal- and process-derived textural components in metallurgical coke in terms of volume percent. This test method does not include coke structural components such as coke pores, coke wall dimensions, or other structural associations.1.2This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Microscopical Determination of the Textural Components of Metallurgical Coke

KS M ISO 12984:2004 铝生产用碳质材料.煅烧焦炭.粒度分布的测定

이 규격은 잔류 석유 코크스(delayed petroleum coke)를 하소시킴으로써

Carbonaceous materials used in the production of aluminium－Calcined coke－Determination of particle size distribution

KS M ISO 8723:2004 炼铝用碳素材料.煅烧焦炭.油含量的测定.溶剂萃取法

이 국제 표준은 알루미늄 생산에서, 하소 코크스 중의 유분 함량을 용매 추출법으로 측정

Carbonaceous materials for the production of aluminium－Calcined coke－Determination of oil content－Method by solvent extraction

KS M ISO 10237:2004 铝生产用碳质材料.煅烧焦炭.残余氢含量的测定

생 코크스는 알루미늄의 전기적 생산에 사용되는 산화 양극 제조에 사용되기 전에 하소(c

Carbonaceous materials for use in the production of aluminium-Calcined coke-Determination of residual-hydrogen content

KS M ISO 12981-1:2004 铝生产用碳质材料.煅烧焦炭.二氧化碳的活性测定.第1部分:质量损失法

이 규격은 알루미늄 제조용 산화 양극 제조에 사용되는 하소된 석유 코크스의 이산화탄소에

Carbonaceous materials used in the production of aluminium-Calcined coke-Determination of the reactivity to carbon dioxide-Part 1:Loss in mass method

KS M ISO 9406:2004 炼铝用的碳素材料.生焦炭.用重量分析法测定挥发物的含量

이 규격은 알루미늄 제조에 사용되는 생 코크스 중의 휘발분 함량을 중량법에 의해 측정하

Carbonaceous materials for the production of aluminium－Green coke－Determination of volatile matter content by gravimetric analysis

ISO 687:2004 固体矿物燃料.焦炭.一般分析试样中水分的测定

This International Standard specifies a method for determining the moisture in the general analysis test sample of coke. It can be used for the determination of moisture in blast-furnace coke, foundry-coke and other high-temperature carbo4ization products.

Solid mineral fuels - Coke - Determination of moisture in the general analysis test sample

NF M03-039*NF ISO 1014:2004 焦炭.相对真密度、相对表观密度和孔隙度测定

Coke - Determination of true relative density, apparent relative density and porosity.

JIS K 2151:2004 焦炭.试验方法

この規格は，石炭コークス類(以下，コークスという。)の粒度試験方法，かさ密度試験方法，密度・気孔率試験方法，落下強度試験方法，回転強度試験方法，反応性試験方法，及び灰の溶融性試験方法について規定する。

Coke -- Testing methods

ASTM D5142-04 使用仪器测量法进行煤和焦炭分析样品近似值分析的标准试验方法

Moisture, as determined by the instrumental test method, is used for calculating other analytical results to a moisture-free basis using procedures in Practice D 3180. Moisture percent determined by this test method may be used in conjunction with the air-dry moisture loss determined in Method D 2013 and Test Method D 3302 to determine total moisture in coal. Total moisture is used for calculating other analytical results to an as-received basis using Practice D 3180. Ash yield, as determined by this test method, is the residue remaining after burning the coal and coke samples. Volatile matter yield, when determined as herein described, may be used to (1) establish the rank of coals, (2) indicate coke yield on carbonization, (3) provide the basis for purchasing and selling, or (4) establish burning characteristics. Fixed carbon is a calculated value. It is the difference between 100 and the sum of the percent moisture, ash, and volatile matter. All percents shall be on the moisture reference base. Moisture, ash, volatile matter, and fixed carbon percents constitute the proximate analysis of coal and coke. Note 18212;The ash obtained differs in composition and amount from the mineral constituents present in the original coal. Incineration causes an expulsion of all water, the loss of carbon dioxide from carbonates, the conversion of iron pyrite into iron oxides and sulfur oxides, and other chemical reactions. Ash yield, as determined by this test method, can differ from the amount of ash produced in furnace operations or other combustion systems because incineration conditions influence the chemistry and amount of ash.1.1 These instrumental test methods cover the determination of moisture, volatile matter, and ash, and the calculation of fixed carbon in the analysis of coal and coke samples prepared in accordance with Method D 2013 and Practice D 346. Results obtained through the use of the instrumental tests have been shown to differ from those obtained with Test Methods D 3173, D 3174, and D 3175 on some coals and cokes. Where a relative bias between the instrumental methods and Test Methods D 3173, D 3174, and D 3175 for proximate analysis of coal and coke are shown to exist, the instrumental results shall be corrected or the instrument calibrated using samples of known proximate analysis. Test Methods D 3173, D 3174, and D 3175 shall be considered the referee test methods. The instrumental test methods are not applicable to thermogravimetric analyzers using microgram size samples.1.2 The moisture value determined is used for calculating other analytical results to a dry basis. When used in conjunction with the air dry loss moisture, as determined in accordance with Method D 2013, Test Method D 3302, or Practice D 346, the calculated total moisture can be used to convert dry basis analytical results to the as-received basis.1.3 The result of the ash determinations can be applied in the ultimate analysis, Practice D 3176.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods for Proximate Analysis of the Analysis Sample of Coal and Coke by Instrumental Procedures

ASTM D346-04(2010) 实验室分析用焦炭试样的收集和制备标准实施规程

This practice may be used to provide a representative sample of the coke from which it is collected. Because of the variability of coke and the wide variety of sampling equipment, caution must be exercised in all stages of sampling, from system specifications and equipment procurement to equipment acceptance testing and actually taking the final sample. This practice also provides an analysis sample of coke from the gross or divided sample. The analysis samples can be used to determine the value of the coke represented, its ability to meet specifications, as well as for other purposes.1.1 This practice covers procedures for the collection and reduction of samples of coke to be used for physical tests, chemical analyses, and the determination of total moisture. 1.2 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Collection and Preparation of Coke Samples for Laboratory Analysis

ASTM D3683-04 原子吸收法测定煤和焦炭灰分中痕量元素的标准试验方法

Many trace elements occur in coal, primarily as a part of the mineral matter but may also be associated with the organic matrix. Concern over release of certain trace elements to the environment as a result of coal utilization has made the determination of these elements an increasingly important aspect of coal analysis. When coal ash is prepared in accordance with this test method, the eight elements listed in 1.1 are quantitatively retained in the ash and are representative of concentrations in the coal. Concentrations of these and other elements in power plant ash, industrial process ash, fly ash, and so forth, may or may not be representative of total quantities in the coal.1.1 This test method describes a procedure for the determination of beryllium, chromium, copper, manganese, nickel, lead, vanadium, and zinc in coal ash or coke ash. Note 1Although not included, this test method can be applicable to the determination of other trace elements, for example, cadmium.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.2 The values stated in SI units (IEEE/ASTM SI 10) should be regarded as the standard.

Standard Test Method for Trace Elements in Coal and Coke Ash by Atomic Absorption

ASTM D346-04e1 实验室分析用焦炭试样的收集和制备标准实施规程

1.1 This practice covers procedures for the collection and reduction of samples of coke to be used for physical tests, chemical analyses, and the determination of total moisture. 1.2 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only.This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Collection and Preparation of Coke Samples for Laboratory Analysis