H32 焦炭 标准查询与下载

YB/T 035-1992 焦炭电阻率的测定方法

Determination method of electrical resistivity of coke

BS 1016 Sec.108.5:1992 煤和焦炭的分析与试验方法.第108部分:焦炭的试验.第5节:密度和疏松度的测定

Methods for analysis and testing of coal and coke. Tests special to coke. Determination of density and porosity

BS 1016 Sec.108.6:1992 煤和焦炭的分析与试验方法.第108部分:焦炭试验.第6节:临界鼓风值的测定

Methods for analysis and testing of coal and coke. Tests special to coke. Determination of critical air blast value

BS 1016 Sec.108.2:1992 煤和焦炭的分析与试验方法.第108部分:焦炭的专门试验.第2节:米库姆转鼓系数(Micum)和延性铁冶炼系数(Irsid)

Methods for analysis and testing of coal and coke. Tests special to coke. Determination of Micum and Irsid indices

BS 1016 Sec.108.1:1992 煤和焦炭的分析与试验方法.第108部分:焦炭的专门试验.第1节:震烈系数的测定

Methods for analysis and testing of coal and coke. Tests special to coke. Determination of shatter indices

ASTM D5061-92(1997) 在冶金焦中用显微术测定组织成分体积百分比的测试方法

1.1 This test method covers the equipment and procedures used for determining the types and amounts of coke carbon forms and associated recognizable coal- and process-derived textural components in metallurgical coke in terms of volume percent. This test method does not include coke structural components such as coke pores, coke wall dimensions or other structural associations. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Microscopical Determination of Volume Percent of Textural Components in Metallurgical Coke

BS 1016 Sec.108.3:1991 煤和焦炭的分析和试验方法.第108部分:焦炭的特殊试验.第3节:容积密度的测定(小容器)

Methods for analysis and testing of coal and coke. Tests special to coke. Determination of bulk density (small container)

ASTM A837-91(2001) 渗碳用合金钢锻件

1.1 This specification covers alloy steel forgings for carburizing applications. 1.2 Forgings are considered weldable under proper conditions. Welding technique is of fundamental importance and it is presupposed that welding procedure and inspection shall be in accordance with approved methods for the class of material used.

Standard Specification for Steel Forgings, Alloy, for Carburizing Applications

ISO 9406:1988 炼铝用碳素材料.生焦碳.用重量分析法测定挥发物的含量

Carbonaceous materials for the production of aluminium; green coke; determination of volatile matter content by gravimetric analysis

ISO 8723:1986 铝生产用碳素材料 煅烧焦 油含量的测定 溶剂萃取法

Calcined coke may be treated with different types of oil in order to limit the formation of a dust cloud during loading and transportation. The method specified in this International Standard permits the determination of the loss of mass in calcined coke after elimination of oil adhering to the particles, by extraction with dichloromethane (methylene chloride) in an extraction apparatus.

Carbonaceous materials for the production of aluminium; Calcined coke; Determination of oil content; Method by solvent extraction

ISO 2325:1986 焦炭 粒度分析(标称最大粒度小于或等于20mm)

Two methods of operation are described: where a restricted size analysis is required, using two sieves only; where a complete size analysis is required. A sample of coke is subjected to a prozess of size analysis by a specified procedure, and the results are expressed in terms of the cumulative percentage by mass of the coke remaining on sieves of different sized openings.

Coke; Size analysis (Nominal top size 20 mm or less)

ISO 1014:1985 焦炭 真相对密度、视相对密度和孔隙率的测定方法

For calculating the true relative density the mass of water displaced by a known masss of dry coke, ground to pass a sieve of nominal size of openings 212 um, is determined using a pyknometer. - The volume of a large amount of coke is determined by displacement in water; dividing the mass of the dried coke by the mass of an equal volume of water gives the apparent relative density. - The porosity is calculated from the true relative density and the apparent relative density of the coke.

Coke; Determination of true relative density, apparent relative density and porosity

ISO 8004:1985 铝生产用碳素材料 煅烧焦和煅烧碳产品 二甲苯密度的测定 比重瓶法

The density is meassured at 25 degrees centigrade by a pyknometric method after degassing under vacuum. Calcined coke may be treated with different types of oil in order to avoid the formation of dust during loading and transportation. The present method does not provide for this elemination of traces of oil which may be present in the sample.

Carbonaceous materials for the production of aluminium; Calcined coke and calcined carbon products; Determination of the density in xylene; Pyknometric method

ISO 6997:1985 铝生产用碳素材料 煅烧焦 表观油含量的测定 加热法

A test portion is heated in a non-oxidizing atmosphere at a fixed temperature and the loss of mass is determined. The apparent oil content is calculated in terms of loss of mass. To ensure a non-oxidizing atmosphere, some drops of toluene are added to the crucibles.

Carbonaceous materials for the production of aluminium; Calcined coke; Determination of apparent oil content ; Heating method

ISO 8005:1984 铝生产用碳素材料 生和煅烧焦 灰分含量的测定

Carbonaceous materials used in the production of aluminium; Green and calcined coke; Determination of ash content

BS 4262:1984 高炉用焦炭技术质量的规定方法

Lists the characteristics used to specify the technical quality of the coke, states the corresponding methods of tests and gives details of typical values. Appendices deal with guidance on selection of the cokes and details of an extended Micum test.

Method of specifying the technical quality of coke for use in blast furnaces

ISO/TR 7517:1983 焦炭 评定物理强度的不同试验的比较

Coke; Comparison of different tests used to assess the physical strength

BS 3407:1982 焦炭筛选设备的评定指南

Recommended procedures for obtaining and recording data for assessing the efficiency of new or altered coke screening plant and mobile plant.

Guide for assessing coke screening plant

ISO 579:1981 焦炭.全水分的测定

Coke; Determination of total moisture content

ISO 728:1981 焦炭(标称最大粒径大于20mm).粒度分析

Coke (nominal top size greater than 20 mm); Size analysis