K40 输变电设备综合 标准查询与下载

UL 916 BULLETINS-2003 能源管理设备

These requirements cover energy management equipment that controls electric loads to achieve some desired use of electrical power. This equipment typically involves the use of sensors or transducers that monitor power consumption, preprogrammed data logic circuits, external command signals (as from a utility company), or any combination of these.

Energy Management Equipment

KS C 9317-2002 除湿机

이 규격은 실내의 습도를 저하시키는 것을 목적으로 하며 압축식 냉동기, 송풍기 등을 하

Dehumidifiers

NF C10-120:2002 三相交流电系统内短路电流.第0部分:电流的计算

Short-circuit currents in three-phase a.c.systems - Part 0 : calculation of currents.

DIN EN 50065-7:2002 频率范围为3kHz-148.5kHz的低压电气设备的信号传输.第7部分:设备阻抗; 德文版本 EN 50065-7:2001

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 7: Equipment impedance; German version EN 50065-7:2001

DIN EN 50065-4-1:2002 频率范围为3KHz至148.5KHz的低压电气设备信号传输.第4-1部分:低压退耦过滤器.总规范

Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 4-1: Low voltage decoupling filters; Generic specification; German version EN 50065-4-1:2001

NF C64-010/A2:2002 高压开关设备和控制装置标准的通用规范

Common specifications for high-voltage switchgear and controlgear standards.

NF C64-111:2001 高压交流断路器的综合试验

Synthetic testing of high-voltage alternating current circuit-breakers.

BS EN 60270:2001 高压试验技术.部分放电测量

This International Standard is applicable to the measurement of partial discharges which occur in electrical apparatus, components or systems when tested with alternating voltages up to 400 Hz or with direct voltage. This standard - defines the terms used; - defines the quantities to be measured; - describes test and measuring circuits which may be used; - defines analogue and digital measuring methods required for common applications; - specifies methods for calibration and requirements of instruments used for calibration; - gives guidance on test procedures; - gives some assistance concerning the discrimination of partial discharges from external interference. The provisions of this standard should be used in the drafting of specifications relating to partial discharge measurements for specific power apparatus. It deals with electrical measurements of impulsive (short-duration) partial discharges, but reference is also made to non-electrical methods primarily used for partial discharge location (see annex F). Diagnosis of the behaviour of specific power apparatus can be aided by digital processing of partial discharge data (see annex E) and also by non-electrical methods that are primarily used for partial discharge location (see annex F). This standard is primarily concerned with electrical measurements of partial discharges made during tests with alternating voltage, but specific problems which arise when tests are made with direct voltage are considered in clause 11. The terminology, definitions, basic test circuits and procedures often also apply to tests with other frequencies, but special test procedures and measuring system characteristics, which are not considered in this standard, may be required. Annex A provides normative requirements for performance tests on calibrators.

High-voltage test techniques - Partial discharge measurements

KS C 5115-5101-2001 电子设备用固定电阻器.第5部分:空白详细规格.精密卷绕固定电阻器连接的稳定性评分0.1%.评定水平E

권장 실장 방법 이 저항기는 단자 포스트에 납땜하도록 설계되었다. 저항기 본체의 고온으로

Fixed resistors for use in electronic equipment-Part 5:Detail specification: Fixed precision wirewound resistors withsolderable axial wire leads-Stability class 0.1 %-Assessment level E

NF C13-100:2001 由HV公共配电系统供电的建筑物内部的用户热力站

Consumer substations installed inside a building and fed by HV Public distribution system (up to 33 kV).

NRS 051-1999 中压架空导线束系统用不绝缘中性线支撑导线用悬吊和拉紧装置

Covers the requirements for the manufacture, testing and supply of strain and suspension fittings for aerial bundled conductors for use at a.c. system voltages from 3,3 kV up to and including 33 kV.

Suspension and strain fittings for insulated neutral supporting conductors used in medium-voltage aerial bundled conductor systems

DIN VDE 0101:2000 电压1kV以上的电力装置

Power installations exceeding 1 kV; German version HD 637 S1:1999

KS C 6028-1999 小型控制用电磁继电器试验法

이 규격은 전자 기기 및 공업용 제어 회로의 주로 신호 전송에 사용하는 제어 소형 전자 릴

Test methods of low power electromagnetic relays for industrial control circuits

JB/T 9639-1999 封闭母线

　　本标准规定了封闭母线的品种、技术要求、结构、试验方法、产品的成套范围、包装、运输。 　　本标准适用于电压为35kV及以下、电流为35000A及以下的发电机、变电站及其它输配电回路上使用的封闭母线及其成套设备。 　　本标准不适用于使用在有严重腐蚀金属构件、绝缘性和有剧烈震动、摆动、冲击等场所的封闭母线。

Phase buses

IEC TR 60919-3:1999 高压直流系统的性能　第３部分：动态

GB/Z 20996的本部分提供了高压直流系统动态性能的综合导则。本部分中的动态性能是指其特 征频率或时间区域覆盖暂态条件到稳态条件之间范围的事件和现象。它涉及到的动态性能应属于在稳 态或暂态条件下，两端高压直流输电系统与相连的交流系统或其部件，如电厂、交流线路和母线、无功源 等之间的相互影响。两端高压直流输电系统采用由三相桥式接线(双路)组成的12脉动(波)换流器单 元构成，具有双向功率传输能力。换流器采用由无间隙金属氧化物避雷器进行绝缘配合的晶闸管阀作 为桥臂。本部分中未考虑二极管换流阀。对于多端高压直流输电系统虽未特别提及，但本部分中的许 多内容也适用于多端系统。 GB/Z 20996由三个部分组成。第1部分稳态，第2部分故障和操作，第3部分动态。在制定与编 写过程中，已经尽量避免了三部分内容重复。因此，当使用者准备编制两端高压直流系统规范时，应参 考三个部分的全部内容。 对系统中的各个部件，应注意系统性能规范与设备设计规范之间的差别。本部分没有规定设备技 术条件和试验要求，而是着重于那些影响系统性能的技术要求。本部分也没有包括详细的地震性能要 求。另外，不同的高压直流系统可能存在许多不同之处，本部分也没有对此详细讨论，因此，本部分不应 直接用作某个具体工程项目的技术规范。但是，可以以此为基础为具体的输电系统编制出满足实际系 统要求的技术规范。本部分涉及的内容没有区分用户和制造厂的责任。

Preformance of high-voltage direct current(HVDC)systems--Part3:Dynamic conditions

NAVY QPL-23155-21-1998 避难设备 有空气的

This list has been prepared for use by or for the Government in the acquisition of products covered by the subject Specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue f the applicable specification. T

ESCAPE APPLIANCE, HOODED, AIR INFLATABLE, WITH POUCH, SUBMARINE PERSONNEL

NAVY MIL-I-24490 B NOTICE 2-1998 MARK 5,MOD 2(15人)和MARK 6(25人)可充气的压缩空气膨胀系统设备

This notice should be pled in porn of MIL-SíD-1323-341 (NAVY) dated 13 ApM11989.

INFLATION SYSTEM EQUIPMENT, COMPRESSED AIR, FOR MARK 5, MOD 2 (15 PERSON) AND MARK 6 (25-PERSON) INFLATABLE LIFEBOATS

NAVY MIL-S-24186 B NOTICE 2-1998 HD-732/UD型空气中粒子采样器

MIL-S-24186B, dated 7 June 1991, is inactive for new design and is no longer used, except for replacement purposes.

SAMPLER, AIR PARTICLE, HD-732/UD

NAVY MIL-R-23074 C NOTICE 1-1998 橡胶-空气-铅型(铝回收率)橡胶砖

MIL-R-23074C, dated 22 May 1990, is inactive for new design and is no longer used, except for replacement purposes.

RUBBER TILE, RUBBER-AIR-LEAD-TYPE (RAL)

NAVY MIL-V-82466 NOTICE 1-1998 真空气态氮分配系统

MIL-V-82466, including Amendment 1, dated 24 November 1971, is inactive for new design and is no longer used, except for replacement purposes.

VACUUM-AIR-NITROGEN DISTRIBUTION SYSTEM