K84 蓄电能装置 标准查询与下载

HJ 2534-2013 环境标志产品技术要求 电池

本标准规定了电池环境标志产品的术语和定义、基本要求、技术内容和检验方法。 本标准适用于原电池和蓄电池。 2

Technical requirement for environmental labeling products Battery

NF C58-521*NF EN 60952-1:2014 航空器用电池. 第1部分: 通用试验要求和性能水平

La présente partie de la série CEI 60952 définit les méthodes d'essai pour l'évaluation, la comparaison et la qualification des batteries et établit les niveaux de performances et d'environnement minimaux pour la navigabilité. Lorsque les essais spécifiques sont définis sans exigence d'acceptation et de refus (pour établir la capacité de performance), les valeurs déclarées du fabricant, à partir des essais de qualification, seront utilisées pour établir des exigences minimales concernant le maintien de l'agrément pour cette conception de batterie.

Aircraft batteries - Part 1 : general test requirements and performance levels

BS EN 61427-1:2013 可再生能源存储用蓄电池和蓄电池组. 一般要求和试验方法. 光伏离网应用

Secondary cells and batteries for renewable energy storage. General requirements and methods of test. Photovoltaic off-grid application

JB/T 9478.2-2013 光电池测量方法 第2部分：伏安特性

IB/T9478 的本部分刑定了測黑光屯池伏安特性﹏遵守的基本方法q 本部分适用〕‥光屯池伏安牯性的測暈。

Photovoltaic cell measurement methods - Part 2: Volt-ampere characteristics

JB/T 9478.4-2013 光电池测量方法 第4部分：照度-电流特性

IB/T9478 的本部分刑定了測黑光屯池照度ˍ屯流特′性﹏遵′、〕=的基本方法q 本部分适用〕‥光屯池照度ˉ屯流牯性的測暈。

Photovoltaic Cell Measurement Methods Part 4: Illuminance-Current Characteristics

JB/T 9478.1-2013 光电池测量方法 第1部分：总则

Photovoltaic cell measurement methods - Part 1: General

JB/T 9478.3-2013 光电池测量方法 第3部分：光电转换效率

IB/T9478 的本部分规定了測黑光屯池光屯料換效率﹏遵守的基本万法。 本部分适用于光屯池光屯棘換效率的測暈』

Photovoltaic Cell Measurement Methods Part 3: Photoelectric Conversion Efficiency

KS C IEC 62133:2013 含碱性或其他非酸性电解液的蓄电池和蓄电池组.便携式密封蓄电池和蓄电池组的安全要求

이 표준은 비산성 및 알칼리 전해액을 포함하는 2차 전지, 즉 휴대형 밀폐 2차 단전지 및 이것으로조립된 휴대기기용 전지(단추형은 제외)의 안전성 및 오용 환경 시험법과 이에 따른 요구사항에 대하여 규정한다.

Secondary cells and batteries containing alkaline or other non-acid electrolytes-Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications

UL 2580-2013 电动车用电池

UL Standard for Safety Batteries for Use In Electric Vehicles (Second Edition; Reprint with revisions through and including June 17@ 2016)

SAE J2380-2013 电动车蓄电池的振动测试

This SAE Recommended Practice describes the vibration durability testing of a single battery (test unit) consisting of either an electric vehicle battery module or an electric vehicle battery pack. For statistical purposes, multiple samples would normally be subjected to such testing. Additionally, some test units may be subjected to life cycle testing (either after or during vibration testing) to determine the effects of vibration on battery life. Such life testing is not described in this procedure; SAE J2288 may be used for this purpose as applicable. Finally, impact testing, such as crash and pothole, is not included in this procedure.

Vibration Testing of Electric Vehicle Batteries

SAE AIR5561-2013 锂电池动力便携式电子设备

This SAE Aerospace Information Report (AIR) is intended to cover any type of portable electronic device, powered by a rechargeable lithium battery that has application in operating the aircraft. This includes devices such as laptop computers, electronic tablets, and electronic book-reading devices, used as Electronic Flight Bags (EFBs), and similar applications.

Lithium Battery Powered Portable Electronic Devices

UL 1989-2013 备用蓄电池

Standby batteries

IEC 61951-1:2013 含有碱性或其他非酸性电解质的蓄电池和蓄电池组. 便携式密封可充单体电池. 第1部分: 镉镍电池

This part of IEC 61951 specifies marking@ designation@ dimensions@ tests and requirements for portable sealed nickel-cadmium small prismatic@ cylindrical and button rechargeable single cells@ suitable for use in any orientation.

Secondary cells and batteries containing alkaline or other non-acid electrolytes - Portable sealed rechargeable single cells - Part 1: Nickel-cadmium

DIN EN 62133:2013 含碱性或其它非酸性电解液的蓄电池和蓄电池组.便携式密封蓄电池和蓄电池组的安全性要求(IEC 62133-2012).德文版本EN 62133-2013

Secondary cells and batteries containing alkaline or other non-acid electrolytes - Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications (IEC 62133:2012); German version EN 62133:2013

BS EN 62133:2013 含有碱性或其它非酸性电解液的蓄电池和蓄电池组. 便携式密封蓄电池和由它们组成的便携式电池组的安全要求

Secondary cells and batteries containing alkaline or other non-acid electrolytes. Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications

DB44/T 1202-2013 电动汽车用锂离子动力电池系统技术条件

本标准规定了电动汽车用锂离子动力电池系统的技术要求、试验方法、检验规则及标志、包装、运输和贮存要求。 本标准适用于为电动汽车（包括纯电动汽车、混合动力汽车等）提供驱动力的锂离子电池系统。 本标准不适用于由镍氢电池和铅酸电池等其他非锂离子电池组成的电池系统。

Technical specifications for lithium-ion power battery systems for electric vehicles

JIS C 8708 ERRATUM 1:2013 勘误表

ERRATUM

SAE J2984-2013 可回收的推荐性操作规程用交通运输电池系统识别

The chemistry identification system is intended to support the proper and efficient recycling of rechargeable battery systems used in transportation applications with a maximum voltage greater than 12V (including SLI batteries). Other battery systems such as non-rechargeable batteries, batteries contained in electronics, and telecom/utility batteries are not considered in the development of this specification. This does not preclude these systems from adapting the format proposed if they so choose.

Identification of Transportation Battery Systems for Recycling Recommended Practice

DIN IEC/TS 62607-4-1:2013 纳米加工.关键控制特性.第4-1部分:锂离子电池用阴极纳米材料.电化学特性,2-电极电池方法(IEC 113/144/CD-2012)

Nanomanufacturing - Key control characteristics - Part 4-1: Cathode nanomaterials for lithium ion batteries - Electrochemical characterisation, 2-electrode cell method (IEC 113/144/CD:2012)

IEC 62133:2012/COR1:2013 含有碱性或其它非酸性电解液的蓄电池和蓄电池组. 便携式密封蓄电池和由它们组成的便携式电池组的安全要求; 勘误表1

Secondary cells and batteries containing alkaline or other non-acid electrolytes - Safety requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications; Corrigendum 1