Q36 玻璃纤维 标准查询与下载

JC/T 589-2008 增强橡胶用玻璃纤维绳

本标准规定了增强橡胶用玻璃纤维绳（以下简称玻璃纤维绳）的术语和定义、产品代号、要求、试验方法、检验规则、包装、标志、运输和贮存等。 本标准适用以连续玻璃纤维纱经过化学处理、烘焙、加捻合股成缆而制成的玻璃纤维线绳。主要用作橡胶制品例如同步带、V带、轮胎等的增强材料。

Glass fibre reinforcing cord for rubber

GOST R 53237-2008 玻璃纤维.生产和使用过程中安全的一般要求

Fiber glass. General requirements for safety in the course of Production and Application

JC/T 573-2007 玻璃纤维缝纫线

本标准规定了玻璃纤维缝纫线（以下简称缝纫线）的分类与代号、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于由玻璃纤维原丝经退并、加捻并经浸涂处理而制成的光滑的合股纱线。主要用于缝制玻璃纤维过滤布、玻璃纤维毡和其它玻璃纤维制品。

Fiberglass sewing thread

SANS 1446:2007 玻璃纤维无捻纱

Covers the requirements for two types of rovings of E-type glass, of eight recommended nominal fibre diameters.

Glass rovings

KS L 2511-2007 袋式除尘器用玻璃织物

이 규격은 건식 여과 장치용 여과포로 사용되는 집진용 처리 유리 직물1)(이하 집진용 유리

Finished glass cloths for bag filter

KS L 2509-2007 玻璃纤维带

이 규격은 주로 전기 절연, 라이닝 및 플라스틱의 강화에 사용하는 무처리1)의 직조 유리

Textile glass tapes

JC/T 175-2007 玻璃纤维套管坯管

本标准规定了玻璃纤维套管坯管（以下简称套管）的术语和定义、分类和代号、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于以连续玻璃纤维纱编织而成的压扁宽度小于100mm的圆筒状制品，该制品经涂覆处理后可用作电气、电器和仪表等的绝缘。

Glass fiber greige braided tubular sleeving

AWWA C950-2007 玻璃纤维压力管

This standard describes the fabrication and the testing of nominal 1-in. through 156-in.(25-mm through 4,000-mm)fiberglass pipe and joining systems for use in both aboveground and belowground water systems. Service and distribution piping systems and transmission piping systems are included. Both glass-fiber-reinforced thermosetting-resin pipe(RTRP) and glass-fiber-reinforced polymer mortar pipe(RPMP) are fiberglass pipes. Epoxy-resin and polyester-resin systems are described, and commercial-grade E-type glass is specified as the glass-fiber reinforcement material in the pipe wall. Liner materials incorporated include thermosetting or thermoplastic resin, reinforced or unreinforced, with or without fillers. Pressure classes described are 50,100,150,200,250,300,350,400,and 450 psig (345,689,1,034,1,379,1,724,2,069,2,414,2,759, and 496 kPa). This standard may be used to the extent applicable for other diameters, pressure classes, and stiffness classes. For information on design, hydraulics, and installation, refer to AWWA Manual M45, Fiberglass Pipe Design.

Fiberglass Pressure Pipe

ASTM D581-07 机织玻璃纤维套管的标准规范

1.1 This specification covers the requirements for continuous glass filament greige braided tubular sleeving and is suitable for use as electrical insulation and for structural and mechanical applications.1.2 This specification is intended to assist ultimate users by designating the types of these products that are typical in the industry.1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Glass Fiber Greige Braided Tubular Sleeving

ASTM D4969-07 聚四氟乙烯(PTFE)涂覆玻璃织物的标准规范

1.1 This specification covers glass fabric impregnated, coated, and sintered on both sides with PTFE to a nominal thickness of 0.318 mm (0.015 in.) or less.1.2 The PTFE-coated glass fabric is for electrical, chemical, and mechanical uses.1.3 The PTFE-coated glass fabric of this specification does not pertain to structural fabric, single-sided PTFE coatings, or materials used for laminates.1.4 The values stated in SI units as detailed in IEEE/ASTM SI-10. Note 1 - There is no ISO standard that covers information included in this specification. The dielectric test is mentioned in ISO 12086-2 and ISO 13000-1 and 2.

Standard Specification for Polytetrafluoroethylene-(PTFE) Coated Glass Fabric

ASTM D3656-07 乙烯基涂覆玻璃丝编织的防昆虫(蚊帐)布和百页窗帘布用标准规范

1.1 This specification covers the requirements for vinyl-coated glass yarn insect screening and louver cloth. 1.2 This specification is intended to assist ultimate users by designating the sizes and types of these products that are generally available in the industry. 1.3 This specification shows the terminology and requirements for: 1.3.1 Commercial standard vinyl-coated glass yarn insect screening designed and woven primarily for installation in or on any dwelling, patio, screening enclosure, building, or structure for the purpose of keeping out flies, mosquitoes, and most insects. 1.3.2 Vinyl-coated glass yarn louver cloth used extensively in soffit and louver vents to keep out most large insects, birds, and airborne litter, while at the same time providing for adequate ventilation and air circulation. 1.4 This specification shows the values in both SI units and inch-pound units. “SI units” is the technically correct name for a system of metric units known as the International System of Units. “Inch-pound units” is the technically correct name for the customary units used in the United States. The values stated in inch-pound units are to be regarded as the standard. The value in SI units are provided for information only. 1.5 The following precautionary caveat pertains only to the test methods portions, Sections 8-19, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Specification for Insect Screening and Louver Cloth Woven from Vinyl-Coated Glass Yarns

WB/T 1036-2006 菱镁制品用玻璃纤维布

本标准规定了玻璃纤维布的产品分类、技术要求、试验方法、检验规则、包装、标志、运输和贮存。 本标准适用于玻璃纤维纱织造的网布。主要用作菱镁制品的增强材料。 菱镁制品不允许使用高碱玻璃纤维布作为增强材料。

Glass fiber nets used for magnesite products

KS L 2524-2006 玻璃纤维表面涂覆材料

이 규격은 주로 건축, 기계 설비 등에 사용되는 유리면 또는 암면으로 구성되는 보온재, 흡

Textile glass fabrics for surfacing

JIS R 3421:2006 集尘器用纺织玻璃纤维成品布

この規格は，JIS R 3414に規定するガラスクロス及びこれに準じるガラスクロスに，乾式ろ過集じん装置用ろ布として用いるのに適した処埋を施した集じん用処理ガラスクロス(以下，集じん用クロスという)について規定する。

Textile finished glass fabrics for bag filter

JIS R 3414:2006 纺织玻璃纤维织物

この規格は，JIS R 3413に規定するガラス糸及びこれを加工した糸を用いて織り上げた無処理のガラスクロスについて規定する。

Textile glass fabrics

JIS R 3411:2006 纺织玻璃短纤维闷光织物

この規格は，主としてプラスチックの強化に用いるガラスチョップドストランドマヅト(以下，チョップマットという。)についで規定する。

Textile glass chopped strand mats

JIS R 3412:2006 纺织玻璃纤维粗纱

この規格は，主としてプラスチックの強化に用いるガラスロービング(以下，ロービングという。)について規定する。

Textile glass roving

JIS R 3413:2006 纺织玻璃纤维纱

この規格は，ガラス糸について規定する。

Textile glass yarns

ANSI/ASTM D2310:2006 机制玻璃纤维(玻璃纤维增强热固树脂)管规范

This classification covers machine-made "fiberglass" (glass-fiber-reinforced thermosetting-resin) pressure pipe. Methods of classification, requirements, test methods and the method of marking are included. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes. Note 1For the purposes of this standard, polymer does not include natural polymers. This classification is based on the method of manufacture, the type of materials used in construction, and the test performance of the product type. It is not based on dimensions or raw material specifications. Two methods of classifying long-term strength are included: (1) based on cyclic loads for use in those liquid-handling applications where the effects of pumping by duplex or triplex pumps or other cyclic pressure loads dictate the performance requirements of the piping, and (2) based on the steady (static) loads such as would be required for gas service applications. The values stated in inch-pound units are to regarded as the standard. The values in parentheses are provided for information only. The following precautionary caveat pertains only to the test method portion, Section 7, of this classification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2There is no known ISO equivalent to this standard.

Classification for Machine-Made "Fiberglass" (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe

JIS R 3420:2006 纺织玻璃纤维制品的试验方法

この規格は，ガラス長織維及びガラス長繊維を用いたガラスクロス，ガラスマット(以下，それぞれクロス，マットという)などの製品の一般試験方法について規定する。

Testing methods for textile glass products