U40 船用主辅机综合 标准查询与下载
共找到 80 条与 船用主辅机综合 相关的标准，共 6 页
이 표준은 선박용 터빈, 디젤 기관 및 과급기에 사용하는 수평 원통형 윤활유 냉각기(이하
Ship’s lubricant oil cooler(Shell and tube type)
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2012-12-13
- 实施
- 2012-12-13
이 표준은 선박에 윤활유 이송 펌프를 탑재시 준수하여야 하는 일반 사항과 윤활유 이송 펌프
Lubricating oil pump for marine use
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
이 표준은 선박에 연료유 이송 펌프를 탑재시 준수하여야 하는 일반 사항과 연료유 이송 펌프
Fuel oil transfer pump for marine use
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
? ??? ??? ???, ?? ? ?? ??, ??? ? ??? ?? ?? ???? ??
Forged steel 40 K angle valves for marine use
- ICS
- 23.060.30
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
이 표준은 선박의 증기관 계통, 맑은 물 및 급수관 계통, 연료유 및 윤활유관 계통 등에
Marine bronze 5 K angle valves(union bonnet type)
- ICS
- 23.060.30
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
? ??? ??? ?? ?? ??? ??? ????.
Marine bronze hose valves
- ICS
- 23.060.30
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
? ??? ??? ??? ??? ????? ?? ?? ??? ??? ?? ??? ??? ?
Exhaust pipe for marine use
- ICS
- 47.02
- CCS
- U40
- 发布
- 2012-11-13
- 实施
- 2012-11-13
This document describes the application of the SAE J1939 recommended practices for compliance with on-board diagnostic malfunction detection system requirements for marine sterndrive and inboard spark ignition engines, as mandated by the California Air Resources Board (CARB). These Otto-cycle engines are not derived from automotive diesel-cycle engines. The purpose of this recommended practice is to provide a standard open interconnect architecture that allows a generic diagnostic tool to communicate with marine sterndrive and inboard spark ignition engine's on board diagnostic system. These on-board diagnostic malfunction detection system requirements are referred to as OBD-M in this document.
Marine Stern Drive and Inboard Spark-Ignition Engine On-Board Diagnostics Implementation Guide
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2012-04-16
- 实施
本标准规定了用于船舶动力设备、风机、空压机、仪器仪表及其他机械设备起隔振和降噪作用的橡胶剪切隔振器（简称隔振器）的分类、要求、试验方法、检验规则及标志、包装、运输和贮存。 本标准适用于隔振器的设计、生产与检验。
Rubber shear vibration isolators
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2011-06-15
- 实施
- 2011-10-01
Ships and marine technology - Maintenance and testing to reduce losses in critical systems for propulsion
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2010-08-01
- 实施
本标准规定了渔船布置图中主要的专用设备图形符号(以下简称图形符号)。 本标准适用于渔船布置图的设绘。
Graphical symbols of special equipments on the arrangement plants of fishing vessel
- ICS
- 47.020.01
- CCS
- U40
- 发布
- 2010-05-20
- 实施
- 2010-09-01
Surface ship mooring and sailing test procedures part 37: Diesel engine and gas turbine combined propulsion unit test
- ICS
- CCS
- U40
- 发布
- 2009-12-22
- 实施
- 2010-4-1
Mooring and sailing test procedures for surface ships Part 56: Diesel engine and gas turbine combined propulsion automatic control and monitoring system test
- ICS
- CCS
- U40
- 发布
- 2009-12-22
- 实施
- 2010-4-1
Surface ship mooring and sea test procedures part 159: Bilge water and ballast water system tests
- ICS
- CCS
- U40
- 发布
- 2009-12-22
- 实施
- 2010-4-1
This standard is a guide for the design, installation, and selection of materials for exhaust systems for marine engines.
Installation of Exhaust Systems for Propulsion and Auxiliary Engines
- ICS
- 13.040.40
- CCS
- U40
- 发布
- 2009
- 实施
This standard applies to devices that stop the propulsion engine under emergency conditions. It is not intended to be an instantaneous device that will offer immediate protection if the wearer falls into the path of the propulsion system/rudder.
Emergency Engine Cut-Off Devices
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2009
- 实施
This technical information report is a compilation of the key safety requirements of commonly used national and international standards related to voltages and the design, construction, and installation of electrical systems and components used in high voltage electric propulsion systems.
Electric Propulsion Systems
- ICS
- 47.020.20
- CCS
- U40
- 发布
- 2009
- 实施
The purpose of this SAE Recommended Practice is to provide guides toward standard conditions for operating marine engine throttles (gasoline or diesel) where push-pull cable control is applicable. For control cable information see SAE J917.
Marine Control Cable Connection Engine Throttle Lever
- ICS
- 47.020.20;47.020.70
- CCS
- U40
- 发布
- 2008-04-01
- 实施
The purpose of this SAE Recommended Practice is to provide guides toward standard conditions for operating marine hydraulic transmissions where push- pull cable control is applicable. For control cable information see SAE J917.
Marine Control Cable Connection Engine Clutch Lever
- ICS
- 47.020.20;47.020.70
- CCS
- U40
- 发布
- 2008-04-01
- 实施
本规范规定了按能容考核的舰船用钢丝绳隔振器（以下简称为隔振器）的要求、质量保证规定、交货准备等。 本规范适用于隔振器产品的设计、制造和验收。其他应用领域的钢丝绳隔振器的设计、制造和验收亦可参照使用。
Specification for wire-cable vibration isolator of ships
- ICS
- CCS
- U40
- 发布
- 2008-03-17
- 实施
- 2008-10-01
