共找到 122 条与 发动机零部件 相关的标准,共 9 页
MODULE ASSEMBLY, STORAGE, SHELF TYPE
MODULE ASSEMBLY, STORAGE, SHELF TYPE
MODULE ASSEMBLY, UNIVERSAL STORAGE
MODULE ASSEMBLY, UNIVERSAL STORAGE
MIL-M-29440, dated 20 January 1988, is inactive for new design and is no longer used, except for replacement purposes.
MODULE ASSEMBLY, WORKBENCH
SHELTER ASSEMBLY, RIGID, GENERAL PURPOSE
SHELTER ASSEMBLY, RIGID, GENERAL PURPOSE
MODULE ASSEMBLY, STORAGE, DUAL SHELF
MODULE ASSEMBLY, STORAGE, DUAL SHELF
MODULE ASSEMBLY, PERSONNEL STORAGE
MODULE ASSEMBLY, PERSONNEL STORAGE
MIL-S-29434,dated 20 January 1988, is inactive for new design and is no longer used, except for replacement purposes.
SHELTER ASSEMBLY, 10 FOOT RIGID, GENERAL PURPOSE
MODULE ASSEMBLY, DESK
MODULE ASSEMBLY, DESK
SHELTER ASSEMBLY, KNOCKDOWN
SHELTER ASSEMBLY, KNOCKDOWN
This specification covers the requirements for the manufacture and acceptance of the Detonating Cord Assemblies. Referred to in this document as DCA.
CORD, DETONATING ASSEMBLY
The intent of this SAE Aerospace Recommended Practice (ARP) is to define and recommend to the Aerospace Industry standardized test procedures for establishing fuel nozzle operating performance including types of tests, controlled and measured parameters, and test configurations.
GAS TURBINE ENGINE FUEL NOZZLE TEST PROCEDURES
This SAE Aerospace Standard (AS) provides material identification codes for aluminum alloys, copper alloys, carbon steels, alloy steels, titanium alloys, corrosion resistant materials, and heat resistant materials that are used to make AN, MS, and AS engine and propeller standard utility parts. This document also provides similar material codes for company parts (such as nuts, bolts, etc.) having design configuration similar to other company parts or the engine and propeller standard utility parts (AN, MS, and AS) that are not of the same material.
Identification of Material for AN, MS, and AS Engine and Propeller Standard Utility Parts and Also for Company Parts
This specification covers the requirements for two mes of detonating cord assemblies
DETONATING CORD ASSEMBLY (DCA)
この規格は,航空機エンジン始動用の空気源と機体との接続部の寸法を規定する。
Aircraft -- Connections for starting engines by air
Ring, Retaining - Internal, Spiral Wound Heavy and Medium Duty, UNS S66286 UNS S66286; FSC 5365
Ring, Retaining - Internal, Spiral Wound Heavy and Medium Duty, UNS S66286 UNS S66286; FSC 5365
This document standard specifies the dimmensions of connections for starting aircraft engines by air, which are necessary to ensure international interchangeability of connectors with adaptors. It also gives the minimum clearances required on the air-craft to provide adequate acess for the ground adaptor.#,,#
Aircraft - Connections for starting engines by air (ISO 2026:1974)
Find and report unapproved aerospace parts
This specification is approved for use by the United States Marine Corps, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense.
SHELTER ASSEMBLY, KNOCKDOWN
This specification establishes the requirements for an explosive designated as Composition CH-6.
COMPOSITION CH-6
Cover - Engine Accessory Drive, Round, 8.000 Bolt Circle, AMS 4490 FSC 2995
Cover - Engine Accessory Drive, Round, 8.000 Bolt Circle, AMS 4490 FSC 2995
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号