共找到 807 条与 自行车 相关的标准,共 54 页
Bicycle quick release front and rear axles
Bicycle internal transmission rear axle
1.1 These test methods and specifications cover the standard for front wheel retention systems for all bicycles equipped with manually operated retention systems such as a quick release. 1.2 This specification is only for bicycles equipped with manually operated retention systems, and does not apply to tool-operated wheel retention systems. 1.3 The intent of this specification is to define the performance of primary and secondary wheel retention systems, with the focus on preventing unintended wheel separation and prevention of unintended contact of the retention system with the disc brake rotor or wheel. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Methods and Specifications for Bicycle Manually Operated Front Wheel Retention Systems
Cycles - Luggage carriers for bicycles - Requirements and test methods (ISO 11243:2016); German version EN ISO 11243:2016
Cycles. Handlebar centre and stem dimensions
Cycles - Handlebar centre and stem dimensions
Cycles. Luggage carriers for bicycles. Requirements and test methods
Cycles - Stem wedge angle (ISO 8562:1990)
Cycles - External dimensions of spoke nipples (ISO 6701:1991)
Cycles - Splined hub and sprocket - Mating dimensions (ISO 10230:1990)
Cycles - Screw threads used in bottom bracket assemblies (ISO 6696:1989)
Cycles - Screw threads used to assemble head fittings on bicycle forks (ISO 8488:1986)
This International Standard specifies safety and performance requirements for the design and testing of luggage carriers intended for mounting (with or without tool) above and adjacent to the wheels of cycles and lays down guide lines for instructions on the use and care of such luggage carriers. This International Standard does not apply to removable luggage (for example, handlebar bags or baskets that are not permanently attached). Toy carrier intended to be mounted on bicycles for young children in the scope of ISO 8098 are not covered by this International Standard.
Cycles - Luggage carriers for bicycles - Requirements and test methods
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号