气相 液相 离子色谱 气质 液质 SPE 红外 紫外 拉曼 近红外 ASS OES AFS ICP-MS 微波 电镜 天平 纯水设备 测序仪 移液工作站 COD 粒度仪
关注公众号

关注公众号

手机扫码查看

手机查看

喜欢作者

打赏方式

微信支付微信支付
支付宝支付支付宝支付
×
头像

分析测试百科网 > 行业资讯 > 技术原理

PCR产物纯化方法

2019.8.08
Purification of PCR Products in Preparation for Cloning

Joseph Sambrook
Peter Maccallum Cancer Institute and The University of Melbourne, Australia
David W. Russell
University of Texas Southwestern Medical Center, Dallas
Excerpted From Molecular Cloning: A Laboratory Manual Third Edition
ABSTRACT
The residual enzymatic activity of thermostable DNA polymerases that survive the rigors of PCR can compromise subsequent enzymatic reactions. This protocol describes how to use proteinase K to destroy thermostable enzymes and to purify amplified DNA in preparation for cloning.


MATERIALS
Reagents and Solutions

  • Ammonium acetate (10 M)

  • Amplified DNA from polymerase chain reactions

  • Chloroform

  • Ethanol

  • Phenol:chloroform (1:1, v/v)

  • TE (pH 8.0)


Enzymes and Buffers

  • Proteinase K (20 mg/ml)

  • Genomic grade proteinase K that has been shown to be free of DNase and RNase activity.


Gels

  • EthanolAgarose gel containing 0.5 µg/ml ethidium bromide




METHOD
 

  1. Pool up to eight PCRs (400 µl) containing 1 µg of the desired amplification product. (See Troubleshooting.)
     
    If mineral oil was used to prevent evaporation during PCR, centrifuge the pooled samples briefly and transfer the lower (aqueous) phase to a fresh microcentrifuge tube. 
     

  2. Add 0.2 volume of 5x proteinase K buffer and proteinase K to a final concentration of 50 µg/ml. Incubate the mixture for 60 minutes at 37°C.
     

  3. Inactivate the proteinase K by heating to 75°C for 20 minutes.
     

  4. Extract the reaction mixture once with phenol:chloroform and once with chloroform.
     

  5. Add 0.2 volume of 10 M ammonium acetate and 2.5 volumes of ethanol. Mix the solution well and store it for 30 minutes at 4°C.
     

  6. Recover the DNA by centrifugation at maximum speed for 5 minutes at 4°C in a microcentrifuge. Discard the supernatant and then wash the pellet with 70% ethanol. Centrifuge again, remove the supernatant, and then allow the DNA to dry.
     
    The DNA may be further purified by chromatography or by gel electrophoresis. This step is recommended when primers have been used to add restriction sites to the ends of the amplified DNA. Unused primers and primer-dimers should be removed before digesting the DNA with the appropriate restriction enzymes (please see Removal of Oligonucleotides and Excess dNTPs from Amplified DNA by Ultrafiltration). 
     

  7. Dissolve the pellet in TE (pH 8.0). Assume that the recovery of amplified DNA is 50-80% and dissolve the DNA in TE (pH 8.0) at an estimated concentration of 25 µg/ml (25 ng/µl).
     

  8. Analyze approx. 25 ng of the purified DNA by agarose-ethidium bromide gel electrophoresis, using markers of an appropriate size. Check that the amplified band fluoresces with the intensity expected of approx. 25 ng of DNA.
     


TROUBLESHOOTING
 

Nonspecific amplification products are present at significant levels (e.g., are detectable by gel electrophoresis). 
 
Step 1 
 
Purify the desired product by electrophoresis through low-melting-temperature agarose before proceeding (please see Recovery of DNA from Low-melting-temperature Agarose Gels: Organic Extraction).


REFERENCES
 

Crowe J.S., Cooper H.J., Smith M.A., Sims M.J., Parker D., Gewert D. 1991. Improved cloning efficiency of polymerase chain reaction (PCR) products after proteinase K digestion. Nucleic Acids Res. 19: 184-184.[Free Full Text]
 
Wybranietz W.A. and Lauer U. 1998. Distinct combination of purification methods dramatically improves cohesive-end subcloning of PCR products. BioTechniques 24: 578-580.[Medline]


Anyone using the procedures in this protocol does so at their own risk. Cold Spring Harbor Laboratory makes no representations or warranties with respect to the material set forth in this protocol and has no liability in connection with the use of these materials. Materials used in this protocol may be considered hazardous and should be used with caution. For a full listing of cautions regarding these material, please consult:
Molecular Cloning: A Laboratory Manual Third Edition, by Joseph Sambrook and David W. Russell, © 2001 by Cold Spring Harbor Laboratory Press, Cold Spring Harbor, New York, p. . 8.25-8.26.

Copyright © 2006 by Cold Spring Harbor Laboratory Press. All rights reserved. No part of these pages, either text or image may be used for any purpose other than personal use. Therefore, reproduction modification, storage in a retrieval system or retransmission, in any form or by any means, electronic, mechanical, or otherwise, for reasons other than personal use, is strictly prohibited without prior written permission



生物在线
推荐
推荐作者
热点排行
一周推荐
关闭

Copyright ©2007-2021 ANTPEDIA, All Rights Reserved

京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证：京ICP证110310号