This standard specifies harmonic limits@ their methods of measurement@ and power factor (PF) for lighting equipment. This standard covers all types of lighting equipment that is used for general illumination (typically found in residential@ commercial@ and industrial applications) and which is connected to any of the following commonly distributed 60 Hz alternating current (AC) power line systems: 120 V@ Single Phase 220/230 V@ Single Phase 208/240 V@ Single Phase 277V@ 347 V@ Single Phase 480 V Single Phase 480V/347 V@ 3 Phase Note: These line voltages are nominal and include commonly encountered nameplate variations of the above. As an example@ products rated at either 117@ 120@ or 125 Volts AC would be covered as being inclusive of nominal 120 V systems. Harmonic emission limits@ where they are defined by this standard@ shall include both harmonic and interharmonic emissions over the low frequency range 0 ?C 9 kHz. At this time@ limits for interharmonics are not specified. This standard covers lighting equipment regardless of wattage (operating input power level) or operating input current. However@ emission limits will only be specified over a range of power or current deemed to be warranted at this time. This standard supersedes the requirements for power factor (PF) and total harmonic distortion (THD) of ANSI C82.11 and ANSI C82.14. Depending upon the specific product@ harmonic limits in this standard may be expressed in terms of THD rather than individual limits for specific harmonics or interharmonics. Since there is a technical relationship between harmonic content@ THD@ and power factor@ some products will include PF requirements where the addition of these criteria is helpful in setting a baseline for power quality impact of lighting equipment. Emphasis has been on establishing limits that are simple to assess and that are in keeping with the practices of this industry. Lighting equipment covered under the scope of this standard which contains only passive electrical components or passive ballast circuitry is exempt from limits and need not be measured or tested@ i.e. core and coil ballasts. Note: As an example@ an electronic starter (which contains an electronic component) is sometimes used in conjunction with passive ballast circuitry. The overall device or equipment would still be classified as a passive ballast circuit.