This standard applies to pin and sleeve type plugs@ receptacles@ power inlets@ and connectors@ rated up to 800 amperes and up to 600 volts ac or dc@ and which may include up to eight pilot contacts. These devices are intended to provide power from branch circuits@ or are for direct connection to the branch circuit in accordance with the Canadian Electrical Code Part I@ the National Electrical Code (NEC)@ ANSI/NFPA 70@ and the Mexican Electrical Code@ NOM 001 SEDE@ using copper conductors@ for use in either indoor or outdoor nonhazardous locations. In Canada@ the terminals of a device intended to accommodate aluminum conductors also comply with CSA C22.2 No. 65. This standard does not apply to single conductor pin and sleeve devices. Single pole locking-type separable connectors are covered by CSA C22.2 No. 1691/UL 1691. This standard does not apply to: a) Devices molded integrally with flexible cord or cable that are covered by UL 817@ CSA C22.2 No. 21@ and NMX-J-195-ANCE; b) General and special use devices@ such as attachment plugs@ receptacles@ cord connectors@ inlets@ current taps@ flatiron and appliance plugs@ that are covered by UL 498@ CSA C22.2 No. 42@ CSA C22.2 No. 57@ CSA C22.2 No. 182.2@ NMX-J-412-ANCE@ NMX-J-412/2-1-ANCE@ NMXJ- 412/2-2-ANCE@ NMX-J-412/2-3-ANCE@ NMX-J-412/2-4-ANCE@ NMX-J-412/2-5-ANCE@ and NMX-J-412/2-6-ANCE; c) Single and multi-pole connectors intended for connection to copper conductors@ for use in data@ signal@ control and power applications within and between electrical equipment@ where exposed@ that are covered by UL 1977 and CSA C22.2 No. 182.3; d) Devices intended for use in hazardous (Classified) locations that are covered by UL 1203 and CSA C22.2 No. 159; and e) Products such as switched interlocks that are covered by UL 508 and CSA C22.2 No. 14.