MPMS 10.8-2005

Manual of Petroleum Measurement Standards Chapter 10-Sediment and Water Section 8-Standard Test Method for Sediment in Crude Oil by Membrane Filtration (Second Edition)

MPMS 10.8-2005 发布历史

This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to approximately 0.15 mass %. The accepted unit of measure for this test method is mass %@ but an equation to convert to volume % is provided (see Note 6). The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns@ if any@ associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements@ see 6.1 and Annex A1. *A Summary of Changes section appears at the end of this standard.

MPMS 10.8-2005由API - American Petroleum Institute 发布于 2005-11-01，并于 2017-01-16 实施。

MPMS 10.8-2005的历代版本如下：

• 1991年02月01日 MPMS 10.8-1991
• 2005年11月01日 MPMS 10.8-2005

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 MPMS 10.8-2005 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

MPMS 10.8-2005

发布日期

2005年11月01日

实施日期

2017年01月16日

废止日期

无

中国标准分类号

/

国际标准分类号

/

发布单位

API - American Petroleum Institute

引用标准

18

适用范围

This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to approximately 0.15 mass %. The accepted unit of measure for this test method is mass %@ but an equation to convert to volume % is provided (see Note 6). The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns@ if any@ associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements@ see 6.1 and Annex A1. *A Summary of Changes section appears at the end of this standard.