J551-4-2006
已作废

Test Limits and Methods of Measurement of Radio Disturbance Characteristics of Vehicles and Devices@ Broadband and Narrowband@ 150 kHz to 1000 MHz

标准号

J551-4-2006

发布日期

2006年09月01日

实施日期

2012年06月28日

废止日期

2006-09-27

中国标准分类号

/

国际标准分类号

/

发布单位

SAE - SAE International

引用标准

12

适用范围

This SAE Standard contains test limit1 and procedures for the measurement of radio disturbances in the frequency range of 150 kHz to 1000 MHz. The document applies to any electronic/electrical component intended for use in vehicles. Refer to International Telecommunications Union (ITU) Publications for details of frequency allocations. The test limits are intended to provide protection for receivers installed in a vehicle from disturbances produced by components/modules in the same vehicle.2The receiver types to be protected are: broadcast radio and TV3@ land-mobile radio@ radio telephone@ amateur and citizensapos; radio. The limits in this document are recommended and subject to modification as agreed between the vehicle manufacturer and the component supplier. This document shall also be applied by manufacturers and suppliers of components and equipment which are to be added and connected to the vehicle harness or to an on-board power connector after delivery of the vehicle.This document does not include protection of electronic control systems from RF emissions@ or from transient or pulse type voltage fluctuations. These subjects are covered in other sections of SAE J551 and in SAE J1113.The World Administrative Radiocommunications Conference (WARC) lower frequency limit in region 1 was reduced to 148.5 kHz in 1979. For vehicular purposes@ tests at 150 kHz are considered adequate. For the purpose of this document@ test frequency ranges have been generalized to cover radio services in various parts of the world. Protection of radio reception at adjacent frequencies can be expected in most cases.RationaleThis document is being cancelled in favor of using the technically identical intrnational standards CISPR 12 and CISPR 25. The linkage to these documents is included in the revised SAE J551-1 and SAE J1113-1.1. Only a vehicle test can be used to determine the component compatibility to a vehicle limit.2. Adjacent vehicles can be expected to be protected in most situations.3. Adequate TV protection will result from compliance with the levels at the mobile service frequencies.