This test method covers determination of the length changes that are produced by causes other than externally applied forces and temperature changes in hardened hydraulic-cement mortar and concrete specimens made in the laboratory and exposed to controlled conditions of temperature and moisture. The values stated in either inch-pound or SI units are to be regarded separately as standard. An exception is with regard to sieve sizes and nominal size of aggregate@ in which the SI values are the standard@ as stated in specification ASTM E 11. Within the text@ the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore@ each system must be used independently of the other@ without combining values in any way. This standard does not purport to address all of the safety concerns@ if any@ associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.