J1113-3-2010
Conducted Immunity@ 250 kHz to 400 MHz@ Direct Injection of Radio Frequency (RF) Power
说明：
- 此图仅显示与当前标准最近的5级引用；
- 鼠标放置在图上可以看到标题编号；
- 此图可以通过鼠标滚轮放大或者缩小；
- 表示标准的节点，可以拖动；
- 绿色表示标准：J1113-3-2010 ， 绿色、红色表示本平台存在此标准，您可以下载或者购买，灰色表示平台不存在此标准；
- 箭头终点方向的标准引用了起点方向的标准。
- 标准号
- J1113-3-2010
- 发布日期
- 2010年08月01日
- 实施日期
- 2010年08月06日
- 废止日期
- 2010-08-01
- 中国标准分类号
- /
- 国际标准分类号
- /
- 发布单位
- SAE - SAE International
- 引用标准
- 10
- 适用范围
- This part of SAE J1113 specifies the direct RF power injection test method and procedure for testing electromagnetic immunity of electronic components for passenger cars and commercial vehicles. The electromagnetic disturbances considered in this part of SAE J1113 are limited to continuous@ narrowband conducted RF energy. This test method is applicable to all DUT leads except the RF reference ground. The test provides differential mode excitation to the DUT. Immunity measurements of complete vehicles are generally only possible by the vehicle manufacturer. The reasons@ for example@ are high costs of a large absorber-lined chamber@ preserving the secrecy of prototypes or the large number of different vehicle models. Therefore@ for research@ development@ and quality control@ a laboratory measuring method for components shall be applied by the manufacturer. This method is suitable over the frequency range of 250 kHz to 400 MHz. This direct RF power injection test is particularly effective when used as part of the engineering development of the electronic component (at the prototype PCB level) where the line by line diagnostic capabilities of this test facilitate costeffective circuit board level improvements in the RF immunity performance of the module or component.